Based on the six given solvents, which of the following answers lists ALL of the solvents that ARE suitable for liquid-liquid extraction of an aqueous layer? 1. Acetonitrile 2. Dichloromethane 3. Methanol 4. Hexanes 5. Methyl tert-Butyl Ether 6. Isopropanol

Q: Decide how the compounds below will partition during liquid-liquid extraction of water with an…

A: Polar compounds soluble in polar solvents( H2O) Non polar compounds soluble in non polar solvents

Q: Explain the stages of the formation of crude oil and gas in a flow chart.

A: The stages of the formation of crude oil and gas

Q: All of these should be considered in choosing solvent for extraction except should be sparingly…

A: The selection of solvent of choice is an important step in extraction. It mostly depends on the…

Q: Reading for the unknown solution: Trial 1: 7.3 Trial 2: 6.8 Trial 3: 7.3  Reading for the…

A: Normality of AgNO3 (N1) =  0.02  Volume of water sample (V2) = 20 mL   It is desired to calculate…

Q: A mixture containing ethanol (bp: 78 °C), acetone (bp: 56 °C), and ether (bp: 36 °C) undergoes…

A: To find: The true statement from the below a. Acetone is more volatile than ethanol but less…

Q: How would you characterize a solution made of hexane (C₂H₁) and octane (C₂H₂ )? 8: A) relatively…

A: Raoult’s law: It is stated as the partial vapour pressure of a solvent in a  solution is equal to…

Q: Organic and aqueous phases are separated from each other during extraction based on: Select one: O…

A: The organic and aqueous phases are separated by the extraction method.

Q: In which option is the order showing whether the questions given below are true or false? () If the…

A: The statement first is incorrect because complete purification through distillation is not possible…

Q: Match the steps given below for caffeine isolation. A. The mixture is filtered using a Big Buncher…

A: A question based on matching the steps, which is to be accomplished.

Q: The density of methylene chloride is 1.33 g/mL. A mixture of an organic acid, an organic base and a…

A: Given is, Density of methylene chloride is 1.33 g/mL.

Q: A glass plummet weighs 15 grams in air. When immersed in water, it weighs 8.5 g. When immersed in…

A: Given the mass of plummet in air, mair = 15 g  Mass of plummet in water, mwater = 8.5 g  Mass of…

Q: 4. Explain why aspirin is more soluble in ethanol than in water. For either of these solvents…

A: The basic rule of solubility is like dissolves like i.e., polar solvent will dissolve polar solute…

Q: Based on the six given solvents, which of the following answers lists ALL of the solvents that ARE…

A: Mixture is a type of matter which is composed of two or more substances. These are called as…

Q: What does the process of recrystallization accomplish? 1) Place toxic chemicals into pure materials…

A: Recrystallization is the process of purification of organic compounds. Hence, the process of…

Q: Which of these is NOT a criteria for selecting a good solvent for recrystallization? (A) Solvent…

A: Recrystallization is a process to purify compounds. It is based on the solubility. The principle is…

Q: Compute the amount of reagents which will be used for the preparation of the following reagents and…

A: a) calculations x% of any reagent means 'x' gram of solute in 100 mL of solvent So 5% NH4)2C2O4…

Q: Table 1. Miscibility of Coconut Oil and Solubility of Cholesterol Solvents Coconut Oil…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1. An organic student did an experiment extracting benzoic acid from a mixture of other organic…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Whichof the following would not be a good solvent to use to extract a sample from water?   hexane…

A:

Q: Anhydrous acetonitrile contains less than 0.001 wt% water. Express the water impurity in ppm.

A: Given  Water impurity in acetonitrile = 0.001 % wt  Water impurity in acetonitrile in ppm = To be…

Q: 7. The lower surface area provides a better surface contact with the solvent, facilitating faster…

A: The dissolution is defined as a process in which solute's molecules dissolved in the solvent. The…

Q: Which of the following solvents is the best to use for recrystallization of Solute A? Hexane…

A: The recrystallization technique is generally used to purify of any compound in a proper solvent. The…

Q: How does the data display that water is a good solvent for recrystallization of benzoic acid?…

A: Temperature (C).    Solubility(g benzoic acid/L water) 0                                     1.7 25…

Q: What are emulsions? Name an emulsion in which water is a dispersed phase.

A:

Q: Write the formula for a micelle of a NiS sol obtained in the reaction NiCl2 + H2S →… if the…

A: Introduction: A micelle is the colloidal suspension form by the aggregation of surfactant molecules…

Q: 19. A liquefied mixture of n-butane, n-pentane, and n-hexane has the following composition: n-C,H10…

A:

Q: The position of the phases in the separatory funnel (whether the top or bottom phase) is dependent…

A: “Since there are multiple sub-parts in this question and it is not mentioned that which one has to…

Q: 12. In IR analysis, solid samples are prepared in KBr pallet O O Thin film O Nujol Mull Organic…

A:

Q: Determine the percentage of aspirin (acetylsalicylic acid) recovered from your commercial aspirin…

A: Determine the percentage of aspirin ( acetylsalicylic acid)recovered from your commercial aspirin…

Q: TRUE OR FALSE, if false then give the correct word to make the statement true then explain 1.…

A: The sublimation of a solid occurs when, The solid has high vapor pressure The phase transition…

Q: How much of the suspending agent is needed to prepare a 60-mL preparation of Aluminum hydroxide gel…

A:

Q: 1. Calculate the concentration (mol/L or M) of calcium ions in each water sample using the molar…

A: The balanced chemical equation for the reaction between Ca2+ and EDTA is shown below: Ca2+ +…

Q: Add an excess of methanol to 8.0g of benzoic acid followed by a few drops of concentrated sulfuric…

A: Benzoic acid on reaction with methanol forms methyl benzoate. First it's extracted in cyclohexane.…

Q: Using recrystallization techniques, a student attempts to purify 0.50 g of compound H. Based on the…

A: Given : Mass of sample = 0.50 g Mass of purified crystals obtained = 0.396 g And maximum percent…

Q: Cite one factor that affects percent yield during recrystalization.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In a test tube, dissolve 10 drops of methanol in 3 ml. of water. Oxidize a copper wire spiral by…

A:

Q: Which of the following best describes a deep euctectic solvent? It is a solvent with various mixture…

A: A question based on solution that is to be accomplished.

Q: When performing arecrystallization, slocent with a boiling point less must be use than the melting…

A:

Q: Describe the characteristics that a crystal obtained through recrystallization must have, the final…

A: Recrystallization is basically a purification technique. Recrystallization is a process in which the…

Q: The amount of ethylene resulting from the thermal solution of butane is twice the amount resulting…

A: Two questions based on general chemistry that are to be accomplished.

Q: 8. Ethanol is miscible with water. (After all, alcoholic beverages don t separate into an “alcohol‟…

A: The question asks whether ethanol can be used as the extraction solvent or not for the purpose of…

Q: Based on the data below, which explanation BEST explains what state of matter the compound being…

A: In cases of gases solubility of gases in liquid increases with increase in pressure while solubility…

Q: 5. The mineral analysis below was reported for a water sample. Calcium 90 Chloride 120 Magnesium 30…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Based on the melting point of your impure solid, you look at the given samples and believe you have…

A: Recrystallization is used to purify compound. It is based on the fact that the solubility of a…

Q: Determine the mole fraction of p-dichlorobenzene dissolved in 1.00L of cyclohexane that shifts the…

A: Here, we have to determine mole fraction and mass of p-dichlorobenzene (solute) dissolved in 1.00L…

Q: In Step 8 (see below, as well as in the presentation), three different slimes were prepared by…

A:

Q: 10 mL of a liquid composed only of carbon and hydrogen is added to a separatory funnel containing…

A: Compound has only carbon and hydrogen.

Q: A. Organic Derivatives of Water A.1 Solubility in water Sample Observation Explanation Not clear…

A: According to Q&A guidelines of Bartleby, we are supposed to answer only one question out of…

Q: Prepare a Temperature vs Time cooling curve for each of the two trials involving the lauric…

A: Given data for trial 1:

Micelles and Biological Membrane

Micelles are the type of lipid molecules that organize themselves in spherical shape in aqueous solutions. The production of the micelle is a reply to the amphipathic behavior of fatty acids. It means that they consist of both hydrophobic regions and hydrophilic regions. In micelles, polar head groups (hydrophilic groups) produce an outer layer associated with water whereas nonpolar tails (hydrophobic groups) are organized in the interior.