Calculate the rate constant ( use 3 sig. figs and units) for the ozone decomposition reaction from the slope of the straight line in fig.1 100.090.080.070.060.050.040.030.020.00[%][%][03] initialConcentration inMicromoles / LiterTOKIE01000. 2000.3000. 4000. 5000.6000. 7000.Time in secondsFigure 1. Data describing the decomposition of ozone. Note that the curved line refers to the left scale, andthe straight line refers to the right scale.Table 1. Data on Ozone Decomposition (half-life time = 1270 s)Time (s)0100.900.1000.6900.7000.THAILUOR GESMO3 concentration (x 10-6 M) 89.6384.8754.8451.922.071.96In([0₂]/[03]0)0.00-0.0546-0.4914-0.5460-3.767-3.822LETAS JE SAD IN ASET BAZEITTEJ0.00-0.40-0.80-1.20-1.60-2.00 Ln-2.40-2.80-3.20-3.60-4.00-4.40A MISAAS124/ASH 20. Calculate the rate constant (use sig. figs. and units) for the ozone decomposition reaction from theslope of the straight line in fig. 1.

The rate of reaction is the speed at which the reaction proceeds. It can be quoted as the rate of…

Answered: Calculate the rate constant ( use 3…

Calculate the rate constant ( use 3 sig. figs and units) for the ozone decomposition reaction from the slope of the straight line in fig.1

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter5: Gases

Section: Chapter Questions

Problem 129E

See similar textbooks

Similar questions

As weather balloons rise from the earths surface, the pressure of the atmosphere becomes less, tending to cause the volume of the balloons to expand. However, the temperatura is much lower in the upper atmosphere than at sea level. Would this temperatura effect tend to make such a balloon expand or contract? Weather balloons do, in fact, expand as they rise. What does this tell you?
The highest building in Montreal is the ‘1 square building’, with a height of 203m.The atmospheric pressure in the streets of Montreal is P1 = 9.9 x 104Pa.Suppose air density is constant : ρair= 1,2 kg/m3 and g = 9.8 m/s2. Suppose the rooftop temperature to be T = 298K, and the air composition is 100%N2 molecules. The collision cross-section of N2 molecules is 0.43 nm2.*f. Find the collision frequency. Is it in the order of magnitude that you wereexpecting?
Calculate the collision frequency for (a) a molecule in a sample of oxygen at 1.00 atm pressure and 25°C, and (b) a molecule of hydrogen in a region of interstellar space where the number density is 1.0 × 1010 molecules per cubic meter and the temperature is 30 K. Take the diameter of O2 to be 2.92 × 10-10 m and that of H2 to be 2.34 × 10-10 m.
Chemeatry of Air Pollution. im confused with this assigment can i have some help please thanks
Find the collision density (number of collisions / sec / m3) of NO with O3 at 300 K if the concentration at 1 atm total pressure are each 0.2 ppm (0.2 mg/L) and if the molecular diameters are 300 and 375 pm, respectively. The universal gas constant is given as 0.082 L atm K-1 mol-1. (Hint: For 1 ppm at 1 atm total pressure, the partial pressure is 1 x 10-6 atm)
sodium azide (Na3N) decomposes on heating to form sodium and nitrogen gas. 2Na3N--> 6Na+N2 1.35g of sodium nitride were heated. a) calculate the mass of sodium formed on complete decomposition of the sodium nitride. give your answer to 3 significant figures.(AO2) b)calculate the volume of nitrogen gas (in cm^3)produced on complete decomposition of 1.35g of sodium nitride at 320K and 110kpa. the gas constant R= 8.31JK^-1 mol^-1. give your answer to 3 significant figures. (AO2)
1. A student following the procedure described in this module collected the following data: mass Mg, g 0.0243 initial syringe volume, mL 1.0 final syringe volume, mL 26.5 barometric pressure, torr 754 temperature, K 298 Determination#1 The value of the gas law constant (R) is 0.0822 L.atm/mol.K Determination #2 he volume of hydrogen gas produced by the reaction of 0.243 g of magnesium metal and collected at 750 torr and 298 K = 248 mL The results of this experiment are greatly affected by the care with which each of the steps is completed (a) Describe the error that would occur if the magnesium were to slide into the HCl in the test tub before the system is sealed off (b) What would be the effect on the results of a rise in the room temperature from 22.0 celcius, when determination #1 was done, to 25.3 celcius, when determination #2 was made? (c) Why must the surface coating of MgO be removed prior to determining the mass of magnesium used in the experiment? (d) What would be the…
In an experiment, sulfuric acid reacted with different volumes of sodium thiosulfate in water. A yellow precipitate was formed during the reaction. A cross drawn at the base of each flask became gradually invisible due the formation of this yellow precipitate. The time taken for the cross to become invisible was recorded. A partial record of the experiment is shown. Experimental Record Flask Volume ofH2SO4 Volume ofSodium Thiosulfate Volume ofWater Time 1 5 mL 50 mL 0 mL 19 seconds 2 5 mL 40 mL 10 mL 3 5 mL 30 mL 20 mL 4 5 mL 20 mL 30 mL Based on your knowledge of factors that affect the rates of chemical reactions, predict the trend in the last column of the experimental record. Use complete sentences to explain the trend you predicted. You do not have to determine exact values for time; just describe the trend you would expect (increase or decrease) and why it occurs.
The aerosols caused a 0.590.6 °C drop in surface temperature in thenorthern hemisphere. What is the mechanism by which this occurs?
A reaction at 20.0°C evolves 685.mmol of boron trifluoride gas. Calculate the volume of boron trifluoride gas that is collected. You can assume the pressure in the room is exactly 1atm. Be sure your answer has the correct number of significant digits.
Argon diffuses at a rate of 1.45 meters in 8.65 minutes. How long will it take helium to diffuse 5.86 meters under the same conditions? (I should see the calculation of rates first.)
answer 13,19,25 (IDK WHAT TO DO) PLS HELP SO THAT I CAN GET A GRASP A group of students enrolled in a Physical Chemistry Laboratory class performed an experiment on the THE STUDY OF AN ADSORPTION ISOTHERM: ACETIC ACID SOLUTIONS ON ACTIVATEDCARBON. The data gathered by the group are documented in the tables below. Solve for the unknown data.