Answered: Calculate the reserve capacity at 80°F…

Calculate the reserve capacity at 80°F of an automobile battery that was discharged at 87°F for 102 min.? A. 94.62 min B. 94.86 min C. 95.40 min D. 95.15 min

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 51P

See similar textbooks

Related questions

Q: A voltaic cell is constructed with two Zn2+-Zn electrodes, where the half-reaction is Zn2+ 2e−→ Zn…

A: Voltaic cell always gets utilized as "electrical power" which mainly generates "direct current".…

Q: Determine the molar mass (amu) of Metal (M) if it took 2.21 minutes for a current of 1.24 A to plate…

Q: Batteries are charged and discharged due to the concentration of the solutions inside. Calculate the…

Q: Determine the molar mass (amu) of Metal (M) if it took 2.91 minutes for a current of 1.2 A to plate…

Q: nter electrons as e-. A voltaic cell is constructed in which the anode is a Sn|Sn2+ half cell and…

A: The electrode which has less negative reduction potential will act as a cathode and will undergo…

Q: The redox reaction below has a AG value of 219. kJ. Determine the standard cell potential (Eᵒcell)…

Q: A corrosion cell consists of copper(Cu) with an sheet area of 250cm2 and the density of the current…

A: Given: Surface area of Cu = 250 cm2 Surface area of Fe = 25 cm2 And current density passing = 0.5…

Q: Q1/ Fill the blank with the suitable words (a 1- A system contains s single – component with one…

A: 1) 2) LIQUIDUS ;c phase diagram 3) OXIDATION 4) DIFFUSION and TEMPERATURE The rate of corrosion of…

Q: A thin circular-disk earring 4.00 cm in diameter is platedwith a coating of gold 0.25 mm thick from…

A: GIVEN: Diameter of earring =4.00cm Thickness of coating=0.25 mm Current(I) = 0.013 A d of gold =19.3…

Q: Consider the voltaic cell illustrated in Figure , which isbased on the cell reactionZn(s) +…

Q: Which expression(s) are incorrectly defined? I- Ohmic potential is the voltage that overcomes its…

A: According to the given question, here we have to identify the incorrectly defined statements.

Q: Use the standard half-cell potentials listed in the table to calculate the standard cell potential…

Q: Rank the following metals in order from least reducing power to most reducing power, and explain…

Q: Question is attached

A: The electrode which has less negative reduction potential will act as a cathode and will undergo…

Q: Q1 (a) Read the following sentences carefully and briefly justify the answer: (i) Combustion of…

A: (i) Benzene when heated in the presence of oxygen (air) generates carbon dioxide and water. Benzene…

Q: Initial mass of copper electrode (g) 1.201g Final mass of copper electrode (g) 1.163g Initial…

A: Initial mass of copper electrode (g) 1.201g Final mass of copper electrode (g) 1.163g Initial mass…

Q: Phosphate buffered saline (PBS) is routinely used in the lab to wash cells that are being grown in…

A: We need to calculate the Nernst Potential for Na+ and K+ of cells being washed by PBS.

Q: a. Write the balanced net-ionic equation for the spontaneous reaction that occurs as the cell…

A: a) balanced equation for spontaneous reaction is given below Cd(s)+2Ag+(aq)------>…

Q: 5.Calculate ΔG° for the following balanced redox reaction. Pb2+(aq) + Cu(s) → Pb(s) +…

A: The Gibbs free energy (or Gibbs energy) is a thermodynamic potential that can be used to calculate…

Q: Electrolytic Reduction of Cu2+ to Cu on the Surface of a Coin initial mass of coin: 5.6917 g…

A: Given: The initial mass of coin=5.6917 g The final mass of coin=5.7553 g Coulombs…

Q: An antique automobile bumper is to be chrome plated. The bumper, which is dipped into an acidic…

Q: In an investigation, you construct a galvanic cell and compare your observations with standard cell…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Bb Chapter 1– PRPE-2165- X CHEM 1225 sec 001 ad x A ALEKS - Avery McCrear X b Answered: A galvanic…

A: Given:

Q: Q1 (a) Read the following sentences carefully and briefly justify the answer: (i) At STP 22.4 liter…

A: Hi, since you have posted multiple subparts questions, we will answer the first three subparts for…

Q: ezto.mneduca .com/ext/map/index.html?_con=conočexternaI_browser=UQlaunchuri=nttps7o25 7252Fewconn…

A: We will calculate standard reduction potential

Q: Initial mass of copper electrode (g) 1.201g Final mass of copper electrode (g) 1.163g Initial…

Q: Given: Fe2+ + 2e- --> Fe Eº = -0.44V Fe3+ + 3e- --> Fe…

A: Fe + Cl2 ==> Fe2+ + 2 Cl-

Q: 1. Imagine that you and a friend went to sea for catching fish by boat. However, in the middle of…

A: a) As we are in middle of seawater, we could make battery out of seawater. Seawater is good…

Q: Initial mass of copper electrode (g) 1.201g Final mass of copper electrode (g) 1.163g Initial…

A: We first need to calculate the theoretical mass of copper that should have been deposited, using…

Q: A current of 2.10 A is passed through a solution containing Cu2+(aq) for 35.0 minutes with copper…

A: Given, Current (I) = 2.10 A Time (t) = 35.0 min = 35.0 × 60 s = 2100 s mass of Copper (Cu) deposited…

Q: In an investigation, you construct a galvanic cell and compare your observations with standard cell…

Q: Which expression(s) are incorrectly defined? I- Ohmic potential is the voltage that overcomes its…

A: (I) Ohmic potential is the voltage required to overcome the electrical resistance of the solution…

Q: Initial mass of copper electrode (g) 1.201g Final mass of copper electrode (g) 1.163g Initial…

A: Given information: Initial mass of copper electrode (g) = 1.201g Final mass of copper electrode (g)…

Q: When a lead acid car battery is recharged by the alternator, it acts essentially as an electrolytic…

A: Answer = 3.50 grams

Q: 18 « < 4 o Object Object AGNO3(aq) Zn(NO3)2(aq) Diagram 1 Diagram 2 Object Metal Used Amount of…

A: Explanation to the correct option is given below.

Q: A student uses a strip of metal in an electrolysis circuit in which the metal strip serves as the…

A: Given data,Current=1.13ATime=5min50sec1 min=60sec5 min=5×60=300sectime=350secMass of metal=0.109g

Q: A certain metal M forms a soluble sulfate salt M, SO,. Suppose the left half cell of a galvanic cell…

A: We have to tell which half cell is positive electrode and then we have to find the Ecell of given…

Q: Worksheet Question ID: W-5033 In an investigation, you construct a galvanic cell and compare your…

A: As per our guidelines we are supposed to answer only 3 sub-parts. Galvanic cell : Galvanic cells…

Q: Calculate the solubility product and the solubility of AgBr at 25oC on the basis of the following…

A: Solubility is a phenomenon where the solute get dissolved in a solvent to form a solution. The…

Q: A voltaic cell is constructed in which the anode is a Pb|Pb2+ half cell and the cathode is a I-|I2…

Q: 2NAC1O3 (aq) + 4HCI(aq)2CIO2(g) + 2NACI(aq) + Cl2 (g) + 2H2O(!) has been tested as a disinfectant…

Q: At 326 K, an equilibrium constant of Keq = 5.01 x 10’ is measured for the following balanced redox…

A: Given; The value of equilibrium constant, (Keq)=5.01*109 The temperature, (T)=326 K. The reduction…

Q: Which expression(s) are incorrectly defined? I- Ohmic potential is the voltage that overcomes its…

A: The concentration polarization effects are covered in the term itself.

Q: Calculate Ecell for the following concentration cell: Ag(s)׀Ag+(sat’d AgI)║Ag+(sat’d AgCl)׀Ag(s)

A: We can use nernst equation to solve this problem. The cell reaction is given as, Ag(s)׀Ag+(sat’d…

Q: Calculate Ecell for the redox reaction. (round to 2 decimal places) What is [Ni²+] when Ecell when…

Q: Do you have enough information to Yes calculate the cell voltage under standard conditions? No If…

A: Two given half-cell reactions are as follows: Zn2+aq+2e-→Zns E°=-0.763 V......(1)…

Q: Given that the Cathode Half reaction is 4H2O + 4e- →2H2 + 4OH- and the anode half reaction is O2 +…

A: A question based on chemical thermodynamics that is to be accomplished.

Q: Consider the voltaic cell: Zn(s) + Cd2+(aq) → Zn2*(aq) + Cd(s). (E°cell = 0.36V) operating at…

A: Given:

Question

100%

15. Calculate the reserve capacity at 80°F of an automobile battery that was discharged at 87°F for 102
min.?
A. 94.62 min
B. 94.86 min
C. 95.40 min
D. 95.15 min

Obs: I inform you that the answer to letter " C " is wrong, according to the test I did. I appreciate your help which of this question is the correct answer. thanks

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Definition & Formulas:

VIEW

Calculations:

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is the difference between and ? When is equal to zero? When is equal to zero? (Consider regular galvanic cells as well as concentration cells.)
Consider a cell reaction at 25°C where n=4 . Fill in the following table.
Consider a cell reaction at 25°C where n=2 . Fill in the following table.
What is the voltage of a concentration cell of Cl ions where the concentrations are 1.045 and 0.085 M? What the spontaneous reaction?
Use the following half-equations to write three spontaneous reactions. Justify your answers by calculating E° for the cells. 1. MnO4(aq)+8H+(aq)+5eMn2+(aq)+4H2OE=+1.512V 2. O2(g)+4H+(aq)+4e2H2OE=+1.229V 3. Co2+(aq)+2eCo(s)E=0.282V
The overall reaction in the lead storage battery is Pb(s)+PbO2(s)+2H+(aq)+2HSO4(aq)2PbSO4(s)+2H2O(l) Calculate at 25C for this battery when [H2SO4] = 4.5 M, that is, [H+] = [HSO4] = 4.5 M. At 25C, =2.04 V for the lead storage battery.
A magnesium bar with a mass of 6.0 kg is attached to a buried iron pipe to serve as a sacrificial anode. An average current of 0.020 A flows between the bar and the pipe. (a) What reaction takes place at the surface of the magnesium bar? (b) What reaction takes place at the surface of the iron pipe? (C) In which direction do electrons flow between the two surfaces? (d) How many years would it take for the entire magnesium bar to be consumed?