Chemistry Two unknown compounds A and B with the chemical structures below are separated on a reversed-phase HPLC with a methanol-water gradient. Based on your understanding on chromatography, describe which compound is eluted first. Why are the compounds eluted in such order? (Word guide: 120 ± 10%) А. В. CH3 CH3 CH3 17 CH3 CH3

Chemistry Two unknown compounds A and B with the chemical structures below are separated on a reversed-phase HPLC with a methanol-water gradient. Based on your understanding on chromatography, describe which compound is eluted first. Why are the compounds eluted in such order? (Word guide: 120 ± 10%) А. В. CH3 CH3 CH3 17 CH3 CH3

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter33: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 33.2QAP

See similar textbooks

Similar questions

is hexane or 70:30 hexane: ethyl acetate a better eluent based on their TLC plates and rf value in column chromatography separation of ferrocene-acetylferrocene.
2 d) In a typical HPLC column, 150 atm of pressure is required to push the mobile phase through the column. Why is high pressure needed in HPLC? e) Why are HPLC particles porous?
In comparing direct headspace injections with SPMEheadspace injections, later eluting peaks (by GC) arelarger in SPME. Explain why.
Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many amphetamine‑type stimulants (ATS). Using a 0.25 mm thick silica gel stationary phase and a 98.5:1.5 methanol:concentrated ammonia mobile phase, a spot was observed to have traveled 3.52 cm when the solvent front traveled 8.81 cm. What is the retardation factor (?F)for the compound that composes this spot?
What is a guard column and why is it used in HPLC but not in GC systems?
1- What are the main two types of columns in the HPLC? 2-What are the most disadvantages of mass-spectrmeter as a detector for HPLC? 3-What Are The Commonly Used Carrier Gases In GC Analysis ? 4-Name four of the mechanisms of the separation in chromatography? 5-Which Is The Most Commonly Used Detector In High Performance Liquid Chromatography And Why?
Which statement is true? Statement 1: Since tiny amounts of material are exposed on an open surface, the use of TLC is limited to relatively nonvolatile substances.Statement 2: To determine the identity of a specific compound in a mixture, the TLC behavior of the test sample and that of authentic standard compounds are compared on the same plate.
Why are some of the detectors listed unsuitable for HPLC? Which of the GC detectors ) in the table below ) are suitable for HPLC?
Which of the following characteristics is/are the advantage(s) of HPLC over GC? I. Only small amount of sample is required I. Can accommodate nonvolatile samples Ill. Highly selective CHOICES: O l only O ll only O Ill only O ll and Ill only
Which of the following statements regarding size exclusion chromatography is false? Fully included compounds are the last to elute out. Only fully included compounds elute out at Vi. Nothing can elute out before Vo. Only fully excluded compounds elute out at Vo.
Why do the ‘% Area’ values on the HPLC not correspond directly to composition by mole?
27. What exactly is meant by reversed phase? In addition to finding what compound would elute first in a reverse phase HPLC Separation... Can you explain what would elute first for HPLC, GC, TLC, IEC, SEC (or gel filtration) and affinity chromatography?