Code in Java using Do-while Loop   Write a program that accepts an integer input. If the integer is positive, print the values from the positive integer down to zero. Otherwise, if it is negative, print the values from the negative integer up to zero. Separate each number with a space. Input 1. One line containing an integer Output Enter a number: 5 5 4 3 2 1 0

السبت ۲ أكتوبر المحاولة رقم 1 :2 HW • Write a program that computes the average of 5 students grades which are entered by the user. Write a program that converts pounds into kilograms. The program prompts the user to enter a number in pounds, converts it to kilograms, and displays the result. One pound is 0.454 kilograms. محتوى إضافي؟ يمكنك إضافة نص وملفات تدعم إجاباتك. إضافة محتوی إرسال الحفظ لوقت لاحق

MUST BE IN PYTHON PROGRAMMING CODE!!!!! NO C++ or Java!! Directions: Design a program with a loop that lets the user enter a series of names (in no particular order). After the final person’s name has been entered, the program should display the name that is first alphabetically and the name that is last alphabetically. For example, if the user enters the names Kristin, Joel, Adam, Beth, Zeb, and Chris, the program would display Adam and Zeb. Additional requirements: Note that the possible set of input values can include negative, 0, or positive values, but not the sentinel value of -99. DESIGN HINT: • When determining the largest (or smallest) value in a set of numbers, remember to use variables to keep track of the current largest (or smallest) number found thus far. These variables can then be used as a comparison to each subsequent input number to see if the new number is larger (or smaller) than the current largest (or smallest) number and updated appropriately. At the end of all…

PrimeAA.java Write a program that will tell a user if their number is prime or not. Your code will need to run in a loop (possibly many loops) so that the user can continue to check numbers. A prime is a number that is only divisible by itself and the number 1. This means your code should loop through each value between 1 and the number entered to see if it’s a divisor. If you only check for a small handful of numbers (such as 2, 3, and 5), you will lose most of the credit for this project. Include a try/catch to catch input mismatches and include a custom exception to catch negative values. If the user enters 0, the program should end. Not only will you tell the user if their number is prime or not, you must also print the divisors to the screen (if they exist) on the same line as shown below AND give a count of how many divisors there are. See examples below. Your program should run the test case exactly as it appears below, and should work on any other case in general. Output…