Compile the PLC program Compile the PLC program using Ladder logic on Codesys or Logix Pro for the Traffic light change over as described in the Problem statement. Capture the Screenshots of the Ladder logic program as well the run sequences of the program and list it below with the explanation of the actions in line with the requirements for the Traffic light problem statement

Write a Ladder Logic PLC program for each of the following scenarios.  Label all contacts and coils in the PLC program. Scenario 1 Turn on a light when either one of two switches (I1, I2) is toggled on (construct an OR Gate).  Turn on a second light when both switches (Same inputs I1, I2) are toggled on (construct an AND Gate).  Turn on a third light when both switches (Same inputs I1, I2) are toggled off (construct a NOR Gate).  Turn on a fourth light when either switch (Same inputs I1, I2) is toggled off (construct a NAND Gate).  Print a copy of the program showing the construction of the four gate configurations.  Also, submit a truth table for the four input configurations.    Then modify your program so, only one light turns on at a time as you toggle the four truth table states. Scenario 2 Construct a seal-in circuit using a stop-and-start pushbutton and an internal coil to seal in.  Turn on a light for 10 seconds when the start button is pushed then turn it off automatically or…

2- Draw the PLC ladder logic for each of the following: D. BI DEC

Draw a PLC ladder logic program that will control a motor in two different directions