Concentration 6.5x10^-5 M Submit Answer Try Another Version 2 item attempts remaining Not Submitted

Q: Acetic acid percentages in five vinegar samples were 4.98, 4.86, 4.97, 4.99. 5.08, 5.11, 4.97, 5.32…

A: To determine if any value can be rejected, we need to use Q-test.

Q: Active Raw Actual Yield Formulation Dosage Form Packaging Ingredient Materials 2 kgs calcium 1.75kgs…

A: Calcium carbonate is an alkaline earth metal salt. It contains Ca2+ cation and CO32- anion. It…

Q: Calculate the number of millimoles of acetic acid in Trial #2? Round your final answer to 4…

A: In the given question, NaOH is titrated with acetic acid.

Q: Post-lab Question #1: Temperature is a measure of the average kinetic energy of the particles in an…

A: The kinetic energy of the gaseous particles is the function of the temperature.

Q: Answer if true or false , if false, put the correct answer 1. Good primary standard needs to have…

A: 1) A good primary standard following criteria: 1) it has a high level of purity and it has low…

Q: Br 3H 1H 6. 4 O ppm Answer Bank 1H 4H 2H 3H Incorrect

A:

Q: These are practice questions. Please help! Thanks.

A:

Q: A paraffin wax candle is 6.25 inches tall and 1.50 inches in diameter. How many mL of paraffin wax…

A:

Q: +Table 2. Iron ore and cerium solution data. Flask Flask Flask 1 3 Iron ore mass, g: 0.105…

A: Given: The concentration of standard Ce(SO4)2 solution is 0.0362 M. The mass of iron ore taken in…

Q: Concentration of H2SO4, mol/L 0.104 0.104 0.102 0.105 Average Concentration 0.104 mol/L Question…

A: Deviation is the difference between the mean value and the observed value. Deviation=x-xmean Average…

Q: INTRODUCTION LABORATORY SIMULATION 10 8.75 7.5 6.25 5 3.75 2.5 1.25 12 16 18 22 Volume of NaoH Added…

A: Pka can be calculated as

Q: Molarity: 0.148 M Na2S2O3 Data for Unknown Sample Trial 1 Trial 2 Mass of Sample 0.081       g…

A: Given, Molarity: 0.148 M Na2S2O3

Q: Sample Pretreatment on Calibration V Sample Problem: A water sample was tested for iron content, but…

A:

Q: Experimental data: [A] 0.015 [B] 0.015 Rate (M/min) 3.75 0.025 0.015 5.61 0.015 0.025 7.92

A:

Q: Concentration (mg/ml) Time (min) 8.5 0.5 6.8 1 5.4 1.5 4.0 2 3.2 2.5 2.5 3 What will be the slope of…

A: Concept used: Slope = (Y2 - Y1)/ (X2 - X1) y = mx + c

Q: What is the correct ratio of sample to KBr? O 1) 1:10 ratio O 2) 1:50 ratio 3) 1:2 ratin

A: Spectroscopy plays an important role in the analysis of chemical compounds. Infrared spectroscopy is…

Q: Exploring the propitiates of gases experiment. Please show calculations. Volume (mL) Pressure (atm)…

A:

Q: 2 CIO2 (aq) + 2 OH- (aq) CIO3- (aq) + CI02- (aq) + H2O (1) > Experiment Number [CIO2] (M) | [OH-]…

A: Rate of reaction represents the change of concentration of a reactant or a product with respect to…

Q: the %K in the original sample as received.

A: Given data: The mass of soil = 1 g. The percentage of water in the soil sample = 15.00%. The…

Q: Your NaOH concentration 0.10 Trial 1 Trial 2 Volume of Acid (in mL) 12 ml 14 ml Initial Buret…

A: Disclaimer : To find out the percentage error , actual concentration of the acid should be known.…

Q: Create a graph displaying the relationship between Concentration and Density for the sugar solution.…

A: The data of concentration v/s density given is,

Q: "Solution 1" is made from the addition of water to a portion of the 0.0500 M  Fe3+ " prototype"…

A: Given, Molarity of prototype solution = 0.05M Fe3+. Volume of prototype solution = 10.0mL. Volume of…

Q: QUESTION 4 When we use detector tube and the measured concentration is 500 ppm, what is the range of…

A: Since you asked multiple questions so as per Q&A guidelines of portal I solve first question…

Q: Part C Cal2 -Ca-: O:: Ca : 2+ O Ca Submit Previous Answers Request Answer

A: Lewis structure is the structure of the simplest presentation of all the valence shell electron.…

Q: Trituration is a process of reducing particle size which involves the addition of an appropriate…

A: There are various method of reducing the particle size such as grinding, mechanical mixing etc.

Q: 2. Use the trendline equation from the calibration plot (that you wrote down in Table 2) to…

A: Solution: In colorimetry experiment we plot absorbance vs Concentration. we get a straight which…

Q: Table 5: Data for Trial 3 Water displaced in mL 2 mL Time (seconds) 53 4 mL 100 6 mL 139 8 mL 178 10…

A: The order of the reaction is the sum of the exponents of the concentration terms in the…

Q: Peak area proportional to mass or concentration of the individual components of the sample injected.…

A:

Q: 101 Chem101 O 8 https://app.101edu.co Question 4 of 9 A 2.00 L graduated cylinder contains 1.40 L of…

A: Density of solution can be defined as mass of solution per unit volume of that solution. Litre and…

Q: Question is attached

A: Molarity is defined as the moles of solute present per liter of the solution. It is expressed in…

Q: Use the reaction below and the table of data to answer Questions 1-5. 2 NO (g) + Br2 (8) 2 NOBr (g)…

A:

Q: Subtract. Write your answer in simplest form. Explanation Check 1/2 2/7

A:

Q: TRial 1 Trial 2 Trial 3   0.1 N HCl 0.1 N NaOH 0.1 N HCl 0.1 N NaOH 0.1 N HCl 0.1 N NaOH…

A: Given that, the tritation of 0.1 N of HCl by 0.1 N of NaOH. The data table is shown below   Trial…

Q: LIMIT TEST (IMPURITIES - BIOLOGICAL) Instructions: Note the color change of each of the samples by…

A: A question based on general chemistry that is to be accomplished.

Q: Calculate the volume of a 0.01 M potassium permanganate (KMnO4) solution that you need to prepare 25…

A:

Q: 15. answer question in pic pls

A:

Q: 3. Convert stock concentrations to initial concentrations and fill in Table 2: Table 2. Trial #…

A: Absorbance of a solution is proportional directly to the concentration of absorbing species provided…

Q: Which one hardness type that remain .after boiling process Temporary hardness. Permanent hardness.

A: There are two types of water hardness; Temporary hardness  Permanent hardness

Q: Hazard prevention techniques/tools before the chemical accident, types of PPE equipment's and any…

A: Hazard prevention techniques are very much essential while performing chemical experiments. Personal…

Q: experiment A pair of 100 mL samples of water are taken from a well bored into a large underground…

A:

Q: The following volumes of 0.000300 M SCN are diluted to 15.00 mL. Determine the concentration of SCN…

A: Given that, the following volume of 0.000300 M SCN- is diluted to 15.0 mL. We have to calculate the…

Q: Part B. Standardization of Sodium hydroxide solution Balanced chemical equation: Trial 1 Trial 2…

A: Mass of Oxalic Acid  0.1314 g   Initial burette reading  0.40 mL   Final burette reading…

Q: Procedure it attached below, but question is in the screenshot.   Part A: Solution Preparation Work…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Trial 3: Final buret reading (mL) Buret reading 36 37 38 39

A: what is the reading of this buret?

Q: Trial final burette reading (mL) initial burette reading (mL) volume of NaOH(aq) added (mL) colour…

A:

Q: pletion Status: product? OCH3 Na Octy work up Submit to save and submit. Click Save All Answers to…

A: Answer: option 2 is correct answer. This in interamolecular aldol reaction in which base remove the…

Q: qualitative and quantitative analysis?

A: Ans. Sodium chloride can be analysed by various analysis techniques:  Flame photometry is an atomic…

Q: alculate the concentration in ppm of Cd in a 2.00 mL sample which has been shown to contain 16.4 μg…

A: Solution stoichiometry involves the calculation of the concentration of solutions in the given…

Q: There are 12 eggs in a dozen. If a farmer's chickens produce an average of 284 dozen eggs in a…

A: