1. List the concentrations of the stock.[Acetone]0.6M[lodine]00025M[HC1]2. From the computer plot of the data for each trial (absorbance vs. time in seconds), deteminethe slope of the best straight line; use the following data table to summarize your results:Table 1.Trial #Acetone, mLlodine, mLHCI, mLAAbs/At ( slope of line)H20, mLA1.01.01.02.0-0.0010258xto:34978.t0.0016339x+0.4435770,00g0217x 0.891120. 0013205xto,2352712.01.01.01.01.02.01.01.0D1.01.02.01.03. Convert stock concentrations to initial concentrations and fill in Table 2:Table 2.Trial #Disappearance Rate of l2 (M/s)-A[L/At (= -slope/730)[Acetone][lodine][HCIJ0.120.00050.120.240.1210.120. coe 50.120.0010.12D0.00050.24

Absorbance of a solution is proportional directly to the concentration of absorbing species provided…

Answered: 3. Convert stock concentrations to…

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.28QAP

See similar textbooks

Similar questions

functional grp analysis compound: myristic acidpls complete the table Test Reagent Observation Inference NaHCO3 Effervescence Br2 in water, dark Yellow solution 2,4-DNPH Orange solution KMnO4 Purple solution
A newly synthesized drug was found to have a carboxyl group, an imide and a sulfonamide group. The first type of method to consider in this drug molecule’s quantitatve analysis is: a. Non-aqueous Alkalimetryb. Non-aqueous Acidimetryc. Aqueous Alklaimetryd. Aqueous Acidimetry
This is a ATR spectrum. In which caffeine/PVA films were measured. Line a) correspond to a pure pva film and the other lines are films at increasing caffeine concentration. Notice that the OH band at around 3200cm-1 decreases at higher caffeine concentrations. However at a certain concentration (line d) such band starts to increase back to the initial intensity. What does that mean? Waht is the chemical meaning for that behavior?
Calculate the concentration of a solution of peptide AWSME, in mM if the absorbance at 280 nm for the solution is 0.6 absorbance units, and a 0.2-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1. Round your answer to two decimals.
a) How does mass spectrometry identify organic compounds? b) Describe the use and function of Quadrupole Analyzers ? c) One of the ionization sources for atomic mass spectrometry (MS) is Inductively Coupled Plasma (ICP). Explain the need for an interface in the ICPMS instrument and how can it be achieved.
Would your absorbance value be too high or too low if the level of indicator were above the mark on the pipet when delivered to the flask? Explain your answer.
with a theoretical yield of 80% compute for the percent error of the following data Vial weight= 18.3501 vial + fluorescein weight=18.442 resorcinol = 0.1502g Phthalic anhydride= 0.1022g
Xanthurenic acid stock solution Absorbance 25 0.052 50 0.128 75 0.202 100 0.310 150 0.448 200 0.621 Plot a graph, from graph, y=mx (force the trend line to pass through origin since the blank with no xanthurenic acid was set to be zero absorbance) in which, y: Absorbance, x concentration
Spectroscopy and a Calibration Curve Prepare a series of standard solutions of the colored compound with known concentrations by diluting the stock solution with distilled water. Use volumetric flasks to ensure accurate dilutions. Let's assume we have a stock solution of potassium permanganate (KMnO4) with a concentration of 0.100 M (molar). We will prepare five standard solutions with the following concentrations by diluting the stock solution with distilled water: 0.020 M 0.040 M 0.060 M 0.080 M 0.100 M Measure the absorbance of each standard solution at the wavelength of maximum absorbance (λmax) using the UV-Vis spectrophotometer. Record the absorbance values. For 0.020 M: Absorbance = 0.150 For 0.040 M: Absorbance = 0.290 For 0.060 M: Absorbance = 0.440 For 0.080 M: Absorbance = 0.580 For 0.100 M: Absorbance = 0.730 Plot a calibration curve by graphing the absorbance values (y-axis) against the corresponding concentrations (x-axis) of the standard solutions. Use a linear…
What are the advantages of using the KBr in IR spectroscopic sample preparation? Please shortly answer at your own words. Answer should be to the point (specific 4-5 lines).
A phenol standard with a concentration of 4.00 ppm has an absorbance of 0.424 at a wavelength of 460 nm using a 1.00-cm cell. A water sample is steam-distilled, and a 50.00-mL aliquot of the distillate is placed in a 100-mL volumetric flask and diluted to volume with distilled water. The absorbance of this solution is found to be 0.394. What is the concentration of phenol (in parts per million) in the water sample?
The answer with a BCA table for both parts would be great, thank in advance for the help. btw, this is a pre test that isn’t graded

SEE MORE QUESTIONS

Recommended textbooks for you

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Organic Chemistry: A Guided Inquiry

Chemistry

ISBN:

9780618974122

Author:

Andrei Straumanis

Publisher:

Cengage Learning

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Organic Chemistry: A Guided Inquiry

Chemistry

ISBN:

9780618974122

Author:

Andrei Straumanis

Publisher:

Cengage Learning

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

3. Convert stock concentrations to initial concentrations and fill in Table 2: Table 2. Trial # [Acetone] Disappearance Rate of Iz (M/s) -A[1:/At (= -slope/730) [lodine] [HCI] 0.12 A d.0005 0.12 L024 0.12 10.12 O. coe 5 0.12 0.001 0.12 o.c0050.24 D.