Consider the following compressor that receives air at a constant rate of three cubic feet per second.  Air exits the compressor at a pressure of 95 pounds per square inch and 425 °F.   Assume that there are no changes in potential or kinetic energy.  With the assumption that there are constant specific heats, what is the power, in hp, consumed by the compressor? Surrounding P1=14.5 psi and T1= 68 °F

Q: Q6: Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in…

A:

Q: Air at 40° C flow steadily through the pipe shown in If P1 = 40 kPa (gage), P2 = 10 kPa (gage), D =…

A: Write the given data:

Q: A tank with openings 1, 2, and 3 is moving to left at a speed of 25 km/h. Knowing that D1 = D2 = 20…

A: Consider the diagram shown below with the velocities of flow. The velocity of the tank is The…

Q: pls replyyy Air is flowing through a square conduit whose section changes from 100 mm (section 1) to…

A: Please refer to the detailed solution given below,   Answer - Density of air at section 2 is 0.834…

Q: Water with density Pwater = 1000 kg/m³ flows through a pipe, composed of two reduced in size…

A:

Q: The pressure in a section of a horizontal pipe of diameter d1 = 2.0 cm is p1 = 142 kPa. The water…

A:

Q: projectile-like object with maximum diameter of 20 cm is placed at the exit of a 25-cm-diameter…

A:

Q: The cart in the figure below is accelerated along a level track by a jet of water that strikes the…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A: Flux Flux is a term to describe passage through a surface. Electrical flux is how much electricity…

Q: Q1) Water flows through the sudden pipe expansion shown below at a flow rate of 3 m3/s. the small…

A: The Bernoulli's principle equation " It states that the speed of the moving fluid flow is increased…

Q: A fluid with density 1 kg/m' is moving through a pipe with same cross-sectional area at a velocity…

A: Given data as per question Density of fluid =1kg/m3 velocity at 1 = 1.2 m/s Velocity at point 2 =1.5…

Q: A very popular toy on the market several years ago was the water rocket. Water (at 10°C) was loaded…

A: Given Pressure inside the rocket , Pi = 100 KPa exit area is on tenth of the inside area .

Q: 5. A water pipe having a 2.5 cm inside diameter carries water into the basement of a house at a…

A: As per given question we  defind a)speed  b) water pressure at the second floor?

Q: Q2- Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as…

A:

Q: 3.65 Air at 120 kPa absolute and 30°C flows vertically upward in a pipe, as shown in Fig. P3.65. If…

A: Given Data The total height is: H=1.5 m The inlet pressure of the air is: P1=120 kPa The…

Q: Consider the following figure showing a jet of water supporting a weight of 100 N at a height of 5 m…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A:

Q: left ventricle into the aorta can be modeled as a reducing nozzle (Figur below). Model both the left…

A: Given data as per questionFor Left ventricle, Loaction 1d1=3.1 cm=0.031 mv1=120 cm/s=1.2 m/sP1=130…

Q: A tank is filled with water (at 60 °F) by a pipe (with a relative roughness of 0.04) according to…

A:

Q: 3. In the figure shown, oil with specific gravity of 0.80 flows down at the rate of 15 m³/s. The…

A:

Q: Water 3. V D/2 2- 1 What is the hydrostatic pressure (Pa) at point (2). Do not write the unit.…

A:

Q: Consider coolant in a circular pipe to be in laminar flow; the following formula gives…

A: Given data: V=V max*(1-((r/R)^2)) V max = 2 m/s R = Radius of Pipe = 0.05 m Fluid Density (uniform)…

Q: Water is flowing through a vertical pipe with its smaller end upwards with diameter =0.5m and…

A: Note: As per the policy, we can solve the first question from multiple questions. Please resubmit…

Q: Q3/B/ A non-Newtonian fluid that can be described by a power law model for which n is 0.2 and k is 5…

A: n = 0.2 k = 5 (kpa s)^n length = 10 m Diameter = 20 mm Answer : Radius of required pipe is 15 mm

Q: 6.82 Water flows at low speed through a circular tube with inside diameter of 2 in. A smoothly…

A:

Q: The pipe flow in the figure shown below is driven by pressurized air in the tank. What gage pressure…

A:

Q: A water pipe having a 2.29 cm inside diameter carries water into the basement of a house at a speed…

A:

Q: A 7 cm diameter jet having a velocity of 30 m/s strikes a flat plate which is inclined at 45 the…

A: We know that a 30 m/s jet collides with a flat plate that is inclined at 45o to the jet's axis. If…

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A:

Q: Oil of specific gravity 0.82 flows through an orifice at the vertical side of a closed cylindrical…

A: Given: The specific gravity of oil, SG = 0.82 The oil level inside the tank, H = 4 m The height of…

Q: Q3. A pump draws water through a 20-cm suction pipe and discharges it through a 10- cm pipe in which…

A:

Q: Q= 200 L/s Z2 =10m 71 =5m Datum

A: Given Data Q=200 l/s=0.2 m3/s Z1=5 m Z2=10 m V2=4 m/s

Q: VII. Suppose water is leaking from a tank through a circular hole of area An at it's bottom. When…

A:

Q: Water with density of 1000 kg/m^3 flows through a horizontal pipe (in the x-z plane) bend as shown.…

A: Given:

Q: Q.2A) A tall water tank discharges through a well-rounded orifice, as in Fig. below. If, at this…

A: To find : The value of depth h. Given : The diameter of orifice is d=4×10-2 m. The density of water…

Q: A 6.0 cm diameter horizontal pipe gradually narrows to 4.5 cm. When water flows through this pipe at…

A: we can solve this question by using :- 1)continuity equation  2) Bernoulli  equation

Q: 3 Flujo estacionario e isotermo P3.126

A:

Q: A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and…

A:

Q: Water at 20°C flows through a 9 cm diameter pipe which has a 180° vertical bend, as in Fig. The…

A:

Q: Air at 40° C flow steadily through the pipe shown in If P1 = 40 kPa (gage), P2 = 10 kPa (gage), D =…

A: Given Patm =100KPa P1g = 40KPa P2g = 10KPa P1a = Patm +P1g = 100+40 KPa P2a = Patm + P2g = 100+ 10 =…

Q: Consider water flowing through a converging channel as shown and discharging freely to the…

A: Given: D1=150 mmv1=1.2 m/sD2=75 mmp2=patm

Q: A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and…

A:

Q: V₁ X = 31 Figure Q3 The figure Q3 shows a 180° elbow. Oil enters this elbow at a speed of X m/s and…

A: Given:  entering speed of the oil: →V1=31 m/s Inlet area→A1=25 m2 Exit area→A2=10 m2 From the…

Q: For a horizontal pipe, Gauge A reads 120-kPa and Gauge B reads zero kPa. If the sections diameter as…

A: Given data: Gauge pressure at A PA=120 kpa Gauge Pressure at B PB=0 kpa Diameter at section 1…

Q: Water at 10°C flows through the system shown in the figure below at 0.34 m/s. Energy loss in the…

A:

Q: - Given: Water from a pressurized tank fows out and creates a vertical jet as shown. 2. Total head…

A: Datum is considered as the dotted line in the given Figure. Given, Air pressure inside the tank,…

Q: 7. In the figure shown, what is the minimum height (h) to Block which water must rise in the Orifice…

A:

Q: increase in flow energy of a 10 ft3 of fluid passing a boundary of a system is 80,000 ft-lb.…

A: Given:Q=10 ft3E=80,000 ft-lbPi=100 psi