could you DRAW A SIMPLE CIRCUIT DIAGRAM of a functional 5461as 8-segment display (arduino kit) with a 74HC595 shift register WITHOUT RESISTORS on a breadboard please (can use tinkerCAD)

Build the bistable 555 circuit on TinkerCAD, where the output is an LED.

4. Assume you have an edge-triggered register with four bits. Fill out the output waveform data based on clk and input data (D). CIk D 1001 0010 1000 0101 ; 1111 0001 0111 Q

Apply 5B: Use a 7-Segment Decoder to Drive a 7-Segment Display 1. Draw the wiring diagram of the 74LS47 device driving the common-anode 7-segment display through 3300 resistors in series, one per segment. 2. Build the circuit based on the wiring diagram. Tie off any control inputs of the 74LS47 device to enable it as a 7-segment decoder. Test all the segments of the display by temporarily connecting LT (pin 3 of 74LS47) to GND. Then connect D, C, B, and A of the 74LS47 device to power or ground rail and cycle through the 16 combinations to verify that the display shows the characters according to the truth table of the 74LS47 device. 3. Now interface the circuit in Apply 5A.4 with the circuit in Apply 5A.2 such that the display only shows the numbers controlled by N3N₂N₁No that are prime. When the numbers are non-prime, the display should be blank. Hint: use a single device with basic gates.