Answered: DC motor in parallel (250V -25KW)…

DC motor in parallel (250V -25KW) Product coil resistance (Ra=0.06) Ohm Parallel coil resistance (Rf=100) Ohm Calculate the product capacity?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter9: Components For Electric Motors

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Related questions

Q: In the circuit shown, If you know that the current I = 6mA and Rt = 12 kilo ohms, find the value of…

Q: You have been asked to design a cheap fan to fit in a refrigerator. Which motor would you select…

A: It is an Ac electric motor that is designed in such a way that it can operate on a single-phase…

Q: 011(s); 012(s); Chapter 5 G₁(s) G7(s) Reduction of Multiple Subsystems G₂(s) G4(S) FIGURE P5.8 G3(s)…

Q: True or False 1. The AC system adopted for secondary distribution is 3 phase 3 wire. 2. The…

A: We need to tell about whether the given statement are true or false .

Q: 4. a) A sensor produces a baseband measurement signal m(t) that has a B=5 kHz bandwidth. This signal…

Q: 2. The initial current through the inductor at t = 0 in the circuit shown in following Figure is 2…

A: The initial current through the inductor,The circuit diagram,

Q: How & Find the transfer function, Center frequency, and bandwidth in figure. what type of filter?,…

A: For the given circuit the transfer function, centre frequency, bandwidth, type of filter and the…

Q: 2. An inductor with inductance L-0.12 H carries a linearly-changing current of I(t)=5(1-2), A. What…

A: Inductance L = 0.12 H.Current

Q: Iin (w) jw L mor Tout (w) R₁ R₂ 1 jwC Solve for the frequency response H(w) of the circuit

Q: Given a 50MVA, 3.3kV generator has a synchronous impedance of 10%. Find the per unit impedance on a…

A: A generator has,Synchronous impedance, .So .

Q: In a workshop, there is a three-phase asynchronous motor with a power of 6 HP, an efficiency of 85%,…

A: Given dataOutput power, Efficiency, Initial power factor, Final power factor, To find outWe have to…

Q: Draw CMOS NOR with three input?

Q: A rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene…

Q: What is the rms voltage output value of the ac component in a half-wave rectifier when the peak…

A: Peak voltage of the wave, Vp= 1200Volts

Q: 2- Consider the sampled data system shown below. The steady state error for unit ramp input is (b)…

Q: 3- A state variable formulation of a system is given by the equations 0 3x]+[u, x₁(0)=0, x₂ (0) = 0…

Q: Example 3 An NMOS transistor with k',-0.4mA/V², (W/L)=10 and Vth=0.5V is operated with VGS=1V. a)…

A: Generally NMOS transistor consists of 3 terminals namely1. gate indicated with G 2. drain indicated…

Q: For the circuit below, a. Apply Laplace and find i(t), t>0. b. Determine the initial (t=0+) and…

Q: A sequential circuit has one primary input m, and one primary output n. It has two D flip-flops with…

A: Flipflop equation and the output equations of the circuit are given ,we have to fill the state table…

Q: 20 V 270 ΚΩ IBQ VB 470 92 Ico + VCEQ 2.2 ΚΩ o Vc B=125 LOVE FIG. 4.122 Problems 8, 9, 12, 14, 66,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 1 L = h,…

A: The value of the inductor, The resistor, The cpacitor,The voltage, The initial

Q: What is the total size of memory of 7 RAM memory chips where each one has a size of 64K X 8?

A: One RAM memory chip has a size of 64K×8 bits memory.Like this we have 7 RAM memory chips.Find total…

Q: 1- ..the value of path loss that one expects to be exceeded by the actual path loss 50%. 2- Radar…

A: “Since you have posted multiple questions, we will provide the solution only to the first five…

Q: Calculate the drain current if IDSS = 10 mA, pinch-off voltage of -4V and gate to source voltage is…

A: We need to find out drain current for JFET .

Q: For the lossless TL shown in below with length 1, let Zg - 620, ZR = (open circuit load) and the…

A: We have given the parameters (open circuit load)Hence Now Reflection coefficient at receiving end…

Q: Vas For the two stage amplifier circuit, find the total gain. Use K'n=0.05mA/V² and (W/L)=4, Vth=1V,…

Q: Calculate the ripple voltage of a full-wave rectifier with a 150 µF filter capacitor connected to a…

Q: 4. a) An RTD (Resistance Temperature Detector) sensor forms one arm of a Wheatstone bridge circuit…

A: The circuit diagram is shown below,

Q: Question 1: R1 = 2 and R2 = 4. Calculate the output Voltage Vo for the circuit in the figure. +10 V…

Q: 24V 3 Ω www 1=0)) 4Ω 4Η mo 8 Ω

A: Given circuit diagram is,

Q: A sequential circuit has one primary input m, and one primary output n. It has two D flip-flops with…

Q: A compensated repulsion motor is used to drive a conveyor belt in a factory. The motor is rated for…

Q: 3. A transmission a) Z₁ = 3Zo line is matched when: b) Z₁ = Zo c) Z₁ = 1/3Z,

A: Condition when a Transmission Line is matched.

Q: A circuit consisting of three resistances 12 ohms, 18 ohms and 36 ohms, respectively. The whole…

A: Three resistances are given Supply voltage V = 60 V.Power dissipated in resistance is

Q: ww m R R ww R, ww R

Q: Α) 2: Tel Rab 8 Ω Ο 18 Ω ²³-are 2012 www www 9Ω. ΣΩ www 20 Ω HE 20TH CLICHT 22 ΑΛΜ wwwww 12 AST

A: We need to find out equivalent resistance between a and b for given circuit.

Q: 3 V 6 uF HIH 8V in 5 ohm 5 ohm 3 ohm Calculate the current passing through each resistor when the…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Q1) Find a) Z b) I c) VR d) VL e) Draw phaser diagram 110 60

A: For the given RL circuit the value of total impedance, total current, voltage across the resistor,…

Q: The current in the 50 mag inductor in the circuit attached is known to be 100mA for t0 is given by…

Q: A parallel plate capacitor with a surface area of 1 cm² is found to store 1x 10¹4 electrons when the…

A: In parallel plate capacitor,Surface area, .Number of electrons, .Electric field, .

Q: X CLK FFO DQ Q FF1 DQ

Q: A 40 KW, 220V compound DC generator (as shown in the figure), has the given parameters: Rse = 0.03…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: In the circuit shown, constructed using 2k resistors and silicon diodes (VD=0.6V), find the current…

Q: Q2) The single-line diagram of a three-phase power system is shown in the figure below. The inductor…

A: Solution:Given data:Synchronous generators3 rating = 1000 KVA , 750 kVA , 500 kVA and give…

Q: Question 9: a- Use Thevenin's theorem to find the voltage and power through R₂ in the following…

A: Given data, , , To find outWe have to determine the voltage and power through , and the maximum…

Q: The figure below shows a series of JK flip flops which are triggered by the rising edge of the clock…

Q: Task 5 Evaluate using analytical techniques how the stability of a dynamic PID control system is…

A: We need to discuss the techniques how the stability of a dynamic PID control system is maintained.

Q: Let x[n] be an absolutely summable signal with rational z-transform H(z). If H(z) is known to have a…

Q: 5. The transmission line of Problem 4 above is energized with 765 kV at the sending end when the…

A: Solution:Given Data:sending end voltage =765 KVReviving end voltage=735 KVLoad Resistance=264.5 ohm…

Q: Find the relationship of Vo and Vin Vin 2ksz M 1 кл Vo

A: Given circuit diagram is,

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

I need an answer quickly please and Solve the question step by step please Help ?

DC motor in parallel
(250V -25KW) Product coil
resistance (Ra=0.06) Ohm
Parallel coil resistance
(Rf=100) Ohm Calculate the
product capacity?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Solution

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 500V, 60Hz, single phase synchronous motor develops 20hpand is operating at a pf of 0.8 lagging. Effective resistance ofarmature is I ohm. Iron an friction losses amount to 500W.Determine power drawn by the motor from the source.
Solve the following problems. Use four decimal places for accuracy 2. A three phase, three wire, 5HP, 75% power factor, 50Hz, induction motor has a rated phase voltage of 127.02V with 88% efficiency. Determine the admittance in millisiemens of this motor if the connected capacitor pf is raised to 95%
A series motor has an armature resistance of 0.2Ω and a series field resistance of 0.3Ω. It is connected to a 240V supply and at a particular load runs at 24rev/s when drawing 15A from the supply. Calculate the speed of the motor when the load is changed such that the current is increased to 30A. ANSWER:_______________rev/sec
Induction motor, 4-pole, 37.3kW 50Hz has windage and friction losses of 3320W. The stator losses and rotor losses are equal. If the motor is delivering full load power output at a speed of 1440rpm. Find Mechanical power developed
The rotor of a 3-phase, 60 Hz, 4-pole induction motor takes 118 kW at 3Hz. The motor has stator copped loss of 2.95 kW, a mechanical loss of 2kW and a stator core loss of 1.7 kW. Solve for the motor efficiency
A 200 W, 230 V, 50 Hz, 4 pole capacitor start motor has the following winding constants with the full-load efficiency of 64%,Main winding: R=4.5 Ω; XL=3.7 Ω. Starting winding: R=9.5 Ω; XL=3.5 Ω. Find the value of starting capacitance that will result in the maximum starting torque.
A series motor has an armature resistance of 0.2 ohms and a series field resistance of 0.3 ohms. It is connected to a 240V supply at a particular load runs at 24 rev/s when drawing a 15A from the supply. Calculate the speed of the motor when the load is changed such that the current is increased to 30A. Answer is in rev/sec.
A 240 V ,6.28KW, star connected Induction motor with speed of 100 rps.Calculate the shaft torque a.100 N-m b.10 N-m c.0.1 N-m d.1 N-m
A stepper motor has a step angle of 1.8º and is driven at 4000 pps. Determine (a) resolution (b) motor speed (c) number of pulses required to rotate the shaft through 75.6º.
The rotor of a 3-phase, 60-Hz, 4-pole induction motor tales 120 kW at 3 Hz. The motor has a stator copper loss of 3 kW, a mechanical loss of 2 kW and a core loss of 1.7 kW. Solve the efficiency.
A 440V compound motor has an armature resistance of 0.8Ω and field resistance of 200Ω. Determine the generated voltage when giving an output of 7Hp at 85% efficiency.
A three-phase, star-connected, 7460 kW, 6000V, 50 Hz synchronous motor has a power factor of 0.8, while its efficiency is 92% when feeding a load upstream. This motor has an armature resistance of 0.5 Ω and a synchronous reactance of 4.2 Ω. The stator windings are connected to an infinitely powerful network. A mechanical load equal to 75% of the rated load is connected to the shaft of the motor. According to this; a)Enter the amplitude value of the current passing through the phase windings of the motor. b) Calculate the pole wheel voltage induced in the motor c) Calculate the load angle. ç) Enter the value of the internal phase angle.