Develop an algorithm in Arduino to repeatedly count the number of times a button has been pushed and released and show the count on the Arduino serial monitor. When the count reaches 13, turn on a LED and reset the count, to zero, on the next push and release of the button.

I wrote out this circuit but need help to implement it into the two 7 segment displays

A device is to be installed to control elevators in a building with several floors. The system will use the following logic/rules to move elevators between floors:● Each elevator has a set of m buttons, one for each floor. These illuminate when pressed and cause the elevator to visit the corresponding floor. The illumination is canceled when the elevator visits the corresponding floor. ● Each floor, except the first floor and top floor has two buttons, one to request an up-elevator and one to request a down-elevator. These buttons illuminate when pressed. The illumination is canceled when an elevator visits the floor and then moves in the desired direction.● When an elevator has no requests, it remains at its current floor with its doors closed. The basic course of Action for an elevator scenario is: 1. Passenger presses the floor button (that is the button on the wall). 2. Elevator system detects the floor button pressed. 3. Elevator moves to the floor. 4. Elevator doors open. 5.…