diameter tank at atmospheric pressure contains two inlets and one outlet port. The first inlet port has a flow diameter of 3.0in. and the flow diameter of the second inlet port is 2.0in. Water enters the first inlet port at 5 ft/s. Water enters the second inlet port at 8 ft/s. Water leaves the tank at a rate of 2 lb/s. Find the rate of change of

Q: A centrifugal air compressor handles 200 cfm from 12 psia to 90 psia. The initial specific volume is…

A: a. Flow energy:

Q: A turbine develops 144 HP running at 100 rpm under a head of 7.7 meters. After resolving the turbine…

A: Given data Power Developed = 144 HP  Speed = 100 rpm Head = 7.7 m

Q: A turbine is rated 620 hp when the flow of water through it is 22 ft3/s. Assuming an efficiency of…

A:

Q: of water 75 mm diameter and having a velocity of 15 m/s strikes a series of flat plates normally. If…

A: Given:d=75 mmV=15 m/su=10 m/s

Q: In the system, 900 L/min of oil is pumped with (s=0.92), from an underground storage tank to the…

A: Given: The flow rate of the oil, Q = 900 L/min The specific gravity of the oil, SG = 0.92 The loss…

Q: A positive displacement pump has a capacity of 8 cm3 per revolution and runs at 1000 rpm. Its…

A: Given: N - 1000 rpm v - 8 cm3/rev nv - 0.89  K - 2.4 x 104 bar p - 1 bar/s V - 500 L To find :…

Q: horizontal pipe flowing full at the outlet. The resulting jet strikes the ground surface at a…

A:

Q: Consider a duct systems where air flows through two 8 in. by 10 in. ducts that merge into an 18 in.…

A:

Q: Two pumps having the same specifications and power are connected in series to deliver a flow rate of…

A: Given data: h = 39+80 = 119 m hL = 39+7 = 46 m

Q: 4.4 A tank containing water is placed on a trolley, which is attached to the wall by a cable, as…

A:

Q: A pump takes water at 60°F from a large reservoir and delivers it to the bottom of an open elevated…

A:

Q: Water at 60°F is pumped from a reservoir to the top of a mountain through a 6-in. Schedule 120 pipe…

A:

Q: Water is fed to an inward flow reaction turbine, running at 180 rpm with a velocity of flow of 3…

A:

Q: /A Pelton wheel has a tangential velocity of buckets of 15 meters/sec. the water is being supplied…

A: calculated the power produced by the wheel in watts.

Q: A pump has a total (manometric) head of 12.1 m. The radial velocity through the pump is constant at…

A:

Q: The diameter of the pipe at the larger end is 0.50 cm and at the smaller end is 0.20 cm, the larger…

A: Larger end: D1= 0.50 cmZ1= 7 mV1= 1.2 m/sP1= 5200 kN/m2 Smaller end: D2= 0.20 cmZ2= 3 m   To find:…

Q: A centrifugal pump delivers water at a rate of 0.03 m^ 3 / s to a height of 18 meters through a pipe…

A: The input power of a centrifugal pump is converted into the kinetic energy of the fluid being…

Q: A centrifugal pump discharging 900 gpm and operates at 1800 rpm against a head of 120 feæet has a…

A:

Q: Water flows through a 75 mm diameter pipe at a velocity of 3 m/s. Find the mass flow rate in kg/s

A:

Q: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a head of…

A:

Q: Q.21 Water is being pumped at a rate of 0.5 ft/sec from a storage tank to a certain exit point of…

A: For solution refer below images.

Q: A pump takes water at 60 F from a large reservoir and delivers it to the bottom of an open elevated…

A:

Q: PROBLEM: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a…

A: given data;velocity coefficient (Cv)=0.98jet diameter(d)=15cmhead(H)=270mnozzle angle(α)=150wheel…

Q: A pipe has an initial radius of r1, which then changes to a radius of r2. The velocity of the water…

A:

Q: PROBLEM: A nozzle having a velocity coefficient of 0.98 discharges a jet 15 cm in diameter under a…

A: As per rule solved first four parts only

Q: 24 m3/s of water flowing through the fixed vanes of a turbine, has a tangential velocity component…

A:

Q: A pump takes water at 60°F from a large reservoir and delivers it to the bottom of an open elevated…

A:

Q: The velocity of water and pressure at the suction side of a pump is 4m/s and 90kPa respectively. If…

A:

Q: A 12-in diameter pump rotating at 600 rpm develops a head of 500 ft. Determine the peripheral…

A:

Q: 4. A pipe has an initial radius of 30cm, which then changes to a radius of 10cm. The velocity of the…

A: Please refer to the detailed solution given below, Answers - (a) Pressure difference P1 - P2 =…

Q: QUESTION 7 A pump discharges water at 4 m³/s through a pipe. If the pressure difference between the…

A:

Q: A pelton wheel is supplied with water under a head of 100 m at the rate 1000 litres/s. The bucket…

A:

Q: 3. If a pump discharges 75 GPM of water whose specific weight is 61.5 lb/ft^3 (g=31.95 fps^2), find…

A: Given data,  Q= 75 GPM (gal/min)  Specific weight Y= 61.5 lb/ft3 , g= 31.96 ft/s2

Q: H.W: The inlet diameter of the centrifugal pump, shown in figure below, is 28 in. and the outlet…

A: Given:d=28 inQ=9200 lb/sρ=49 lb/ft3

Q: A fire starts in an apartment building in downtown Boston. When the firefighters arrive, they…

A: As per the question, the water is coming out of the hydrant at a certain velocity. When that is…

Q: A 2-in water jet with a velocity of 130 fps strikes a single vane moving in the same direction of…

A: Given: Jet diameter, d = 2 in = 2in1 ft12 in = 16ft Jet Velocity, V=130 fps Vane velocity, u=50 fps…

Q: Water flows in a pipe that has a 4ft diameter and the following hypothetical velocity distribution.…

A: Given     Diameter, d = 4 ft Velocity, Vmax = 15ft/s                Vmin = 12ft/s Therefore,…

Q: A fluid moves in a steady flow manner between two sections in a flow line. At Section 1:A 1 =10 ft 2…

A:

Q: Water is flowing in a pipe with varying cross-sectional area, and at points the water completely…

A:

Q: The figure shows a pump that draws 840 L/min of crude oil (s= 0.85) in an underground storage drum…

A:

Q: 5. Elevation = 100 ft Di = 1 ft (1) e, = 1000 ft %3D D2 = 1 ft lz = 500 ft B Elevation = %3D 20 ft…

A:

Q: A fan with 24-in-diameter blades moves 2000 cfm (cubic feet per minute) of air at 70°F at sea level.…

A: Write the expression of the area of the fan blade. Write the expression of the flow rate of air.

Q: A turbine is discharging 10 m°/s under a head of 22 m at 200 rpm. The efficiency is 90%. Determine…

A:

Q: A hydroelectric power plant takes in 30 m³/s of water through its turbine and discharges it to the…

A: In the given case let us neglect the viscous work and heat transfer and take section 1 into…

Q: A pump takes water at 60°F from a large reservoir and delivers it to the bottom of an open elevated…

A: