Enter your answer in the provided box. A buffer solution is prepared in such a way that the concentration of propanoic acid is 5.55 × 10¬1 M and the concentration of sodium propanoate is 5.90 × 10~2 M. If the buffer equilibrium is described by CH3COOH(aq) + H2O(1) =H3O*(aq) + C2HgCOO¯(aq) propanoic acid propanoate ion with K=1.34 x 105, calculate the pH of the solution. pH =

Enter your answer in the provided box. A buffer solution is prepared in such a way that the concentration of propanoic acid is 5.55 × 10¬1 M and the concentration of sodium propanoate is 5.90 × 10~2 M. If the buffer equilibrium is described by CH3COOH(aq) + H2O(1) =H3O*(aq) + C2HgCOO¯(aq) propanoic acid propanoate ion with K=1.34 x 105, calculate the pH of the solution. pH =

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter15: Equilibria Of Other Reaction Classes

Section: Chapter Questions

Problem 82E: The simplest amino acid is glycine, H2NCH2CO2H. The common feature of amino acids is that they...

See similar textbooks

Similar questions

Calculate the ph of a solution prepared by dissolving 1.00g of sodium acetate,CH^3COONa, in 50.0ml of 0.15 M acetate acid, CH^3COOH(aq)
The simplest amino acid is glycine, H2NCH2CO2H. The common feature of amino acids is that they contain the functional groups: an amine group, -NH2, and a carboxylic acid group, -CO2H. An amino acid can function as either an acid or a base. For glycine, the acid strength of the carboxyl group is about the same as that of acetic acid, CH3CO2H, and the base strength of the amino group is slightly greater than that of ammonia, NH3. a. Write the Lewis structures of the ions that form when glycine is dissolved in 1 M HCl and in 1 M KOH. b. Write the Lewis structure of glycine when this amino acid is dissolved in water. (Hint: Consider the relative base strengths of the -NH2 and -CO2- groups.)
A 0.025 M solution of an unknown organic acid has a pH of 3.23. 2.1 By means of a full calculation, determine the value of the ionisation constant of the conjugatebase of this acid..- You may use “HA” to denote the formula of the acid.- You may make certain assumptions to simplify your calculations2.2 A certain amount of the sodium salt of the conjugate base of the acid was added to the system.Will the pH of the resulting solution increase or decrease, compared to the original given value? Explain your answer in a short sentence or two.
The primary buffer in the blood is carbonate-bicarbonate buffer. If the pKa is 6.1 and the pH is set at 7.4, what is the ratio of the concentrations of carbonate to bicarbonate. Describe the buffering capacity of this buffer.
Calculate the pH, pOH, and fraction of solute protonated or deprotonated in the following aqueous solutions: (a) 0.150 M CH3CH(OH)COOH(aq) (lactic acid), (b) 2.4 x 10-4 M CH3CH(OH)COOH(aq), (c) 0.25 M C6H5SO3H(aq) (benzenesulfonic acid). The appropriate values for pKa or pKb are given inthe table.
Sodium acetate, NaCH3CO2, of mass 7.4 g is used to prepare 250 cm3 of aqueous solution. What is the pH of the solution?
Benzoic acid, C6H5COOH, dissociates in water as shown in the equation below. A 40.0 mL sample of an aqueous solution of benzoic acid with a concentration of 0.50 M is titrated using standardized 0.25 M NaOH. C6H5COOH(s) -> C6H5COO–(aq) + H+(aq) Ka = 6.46 x 10^-5 Calculate the pH of the solution after the following amounts of NaOH have been added… A. 0 mL B. 10 mL C. 85 mL
134 grams of potassium sorbate KCH3 (CH)4CO2 is fully dissolved in 100.00 mL of water, which is carefully transferred to a conical flask. Then 100.00 mL of 0.240 M HNO3 is added dropwise to this solution from a burette. Given: Ka (sorbic acid) = 1.7 × 1O^-5 Showing all your calculations and reasoning, determine the pH of the solution that results after the addition of all the acid mentioned above. Suppose that the titration continues. Determine the pH of the solution in the flask at theequivalence point
A buffer solution with a pH of 4,9, consists of 0,25 mol∙dm–3 acetic acid (HC2H3O2; Ka= 1,8 x 10–5) and 0,35 mol∙dm–3 potassium acetate (KC2H3O2). A small quantity (0,050 mol) of solid KOH is added to 1 dm3 of the buffer. This quantity is so small that it does not affect the volume of the buffer. Calculate the new pH of the buffer solution after the KOH has been added.
Sodium benzoate, NaC,H,COO, is used as preservatives in vinegar, soy sauce, etc. The pH of a 0.10 M aqueous solution of sodium benzoate is 8.60. What is the pk. of benzoic acid, CoH,COOH? A. 6.20 B.5.40 C.9.80 D.4.20
What are the pKa values and buffering capacity of these following buffer components? Ammonium/Ammonia buffer Lactic acid/Lactate buffer Phosphoric acid/hydrogen PO4 buffer Benzoic acid/Benzoate buffer
Sulphuric acid (H2SO4 ), used in the manufacture of fertilizers, undergo decomposition and the acid dissociation constants are given as: Ka1=1x 10^3 and Ka2=1.2 x 10^(-2) .The initial concentration of sulphuric acid is given as 0.040M.Write the dissociation reactions. Calculate the concentration of [HSO4^- ] and [SO4^(2-)]. Calculate the pH of the acid solution. Write a discussion on the behaviour of polyprotic acids. (50 -100 words) Given: Ion product constant for water, Kw=1 x 10 ^(-14)