Environmental Engineering, environmental chemistry question: Suppose the gas above the soda in a bottle of soft drink is pure CO2 at a pressure of 2 atm. Calculate [CO2] at 25o C Calculate the pH of the soft drink at 25o C. Start with the following chemical reaction and realize the solution will be somewhat acidic: CO2 + H2O <<<>>> H+ + HCO3-

Environmental Engineering, environmental chemistry question: Suppose the gas above the soda in a bottle of soft drink is pure CO2 at a pressure of 2 atm. Calculate [CO2] at 25o C Calculate the pH of the soft drink at 25o C. Start with the following chemical reaction and realize the solution will be somewhat acidic: CO2 + H2O <<<>>> H+ + HCO3-

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter1: Energy Basics

Section: Chapter Questions

Problem 16P

See similar textbooks

Similar questions

The concentration of chlorine in a water tower tank was 2 mg/L when the tower was taken out of service. If the chlorine decays by first-order kinetics with a rate constant of 1.0 1/d, what is the chlorine concentration when the tank is put back in service 8 hours later? What mass of chlorine in kg must be added to the tank to raise the chlorine level back to 2 mg/L. (Assume completely-mixed tank).
For a solution with a pH equal to 9.5, express the concentrations of H+ and OH- in units of meq/L and mg/L as CaCO3.
Chloroform, CHCl3 a volatile liquid, was once used as an anesthetic but has been replaced by safer compounds. Chloroform boils at 61.7°C and has a heat of vaporization of 31.4 kJ/mol. What is its vapor pressure at 37.2°C?
What is the solubility of ethane (in units of grams per liter) in water at 25 °C, when the C2H6 gas over the solution has a partial pressure of 356 mm Hg? kH for C2H6 at 25 °C is 1.94×10-3 mol/L·atm.
An industry is planning to use a 250 m3 bioreactor to treat 400 m3/day of wastewater containing 80 mg/L of benzene (CsHe). Benzene is expected to degrade by microbial action in a completely-mixed reactor (CSTR) with a first-order degradation rate coefficient of 5.0/ day a. Write a balanced reaction for the complete oxidation of benzene to carbon dioxide and water. b. Draw a diagram and write a mass balance equation for benzene in the tank reactor. c. Assuming steady-state conditions, determine the concentration of benzene in the outflow d Determine the mass of benzene that comes into the reactor each day, the mass of benzene that goes out of the reactor each day, and the mass of benzene that is degraded each day. e. Calculate the percent removal. If air is com bubbled oxygen transfer efficiency is equal to 15%. posed of 21 percent oxygen, estimate the volume of air that would have to be through the reactor each day. Assume the air temperature is 25°C and that the Ans: c) 19.4 mg/L d)…
Determine the theoretical oxygen demands for the following chemicals and show the balanced stoichiometric equations with your work: a) 150 mg/L ethanol, b) 0.5 mg/L pentachlorophenol (chloride will end up being OCl- when oxidized), and c) 100 mg/L isopropanol
You are treating 10 million gallons per day (MGD) of water with alum at a dosage of 50.0 mg/L. Alum is available as a hydrated salt Al2(SO4)3.16H2O. Determine:(a) The monthly alum dosage required in metric tons/month (1 metric ton = 1000 kg)(b) If you assume that each equivalent of alum added to the water consumes 1 equivalent of alkalinity, determine the alkalinity consumed by alum addition in milliequivalents/L (meq/L)(c) Given that the raw water contained 30 mg/L as CaCO3 of alkalinity, is the alkalinity sufficient? What would happen if the alkalinity is inadequate?
In wastewater treatment plants, ammonium ion is removed from the water by raising the pH to form ammonia in an air stripping process described on p 65, in the textbook. This is the equilibrium reaction that describes the process of ammonium conversion to ammonia: NH4+ ⇄ NH3,aq + H+ Ammonia in the water then readily converts to ammonia gas, a) Plot a graph showing the concentration of ammonium ion as a function of pH. Use an Excel spreadsheet.b) If the wastewater pH is raised to 10, what fraction of ammonium ion did not react to form ammonia?
Use the psychrometric chart for the following questions unless asked to “calculate”, in which case you must use the appropriate calculations. 1. Calculate the enthalpy (H in kJ/kg) of an air/water vapour mixture which is at 25oC and 0% rh (i.e. dry air). 2. Check your result from question 1 with the psychrometric chart. Are they the same? 3. Now calculate the new enthalpy of the same air/water vapour mixture after raising the rh to 50% (still at 25oC). 4. Check your result again with the psychrometric chart. Are they the same? 5. How much water vapour had to be added to it to raise the rh to 50%? 6. Without changing the enthalpy (i.e. an adiabatic process), how much more water vapour could the air/water vapour mixture from question 4 hold before becoming saturated? 7. What is the new temperature of the air/water vapour mixture of question 5 at saturation? (See over for #8) Timusk 2007 8. Calculate the January ventilation cost for a typical leaky old Toronto house measuring 5m wide x…
Determine the concentration of hydrogen ion and the hydroxide ion (in mg/L) of a solution that has a pH of 9.1
Water with a dissolved oxygen (DO) concentration of 0.94 mg/L enters a well-mixed tankat a rate of 1500 L/min. The tank volume is 280 m3. In the tank, bacteria consume the oxygen for metabolism proportionally to the amount of oxygen present (if they use it at a rate r = k1 · DO, where k1 = 0.0021 min−1). Oxygen is dissolving into the water at a rate proportional to the degree of undersaturation (i.e., at a rate given by r = k2(DOsat − DO), where k2 = 0.0021 min−1 and DOsat = 8.5 mg/L. What is the steady-state concentration ofDO? Answer in units of mg/L.
What would be the pH if 10-2 moles of hydrofluoric acid (HF) were added to 1 L pure water? The pKa of HF is 3.2.