Answered: Ex : What is the value of the force (F)…

Ex : What is the value of the force (F) required to balance the system in the figure? M = 5 kg and F makes and angle (O =37°") below 3 m 2 m OM Answer: ET about center = 0 ITMl + |T = 0 %3D

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 77AP: The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of...

See similar textbooks

Related questions

Q: A1 450-kg automobile has a wheel base (the distance between the axles) of 2.80 m. The automobile's…

Q: What is the value of the force F (N) required to balance the system in the figure? M=5 kg and F…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

Q: Which of the following is always true of a lever system in equilibrium? A The force of gravity on…

A: In a lever system , with respect to the fulcrum the fulcrum the total torque about any point is…

Q: The arm in Figure P8.17 weighs 41.5 N. The force of gravity acting on the arm acts through point A.…

A: Draw the free body diagram of the arm and show the components of the forces Ft and Fs as well.

Q: In an isometric exercise a person places a hand on a scale and pushes vertically downward, keeping…

Q: When tightening a bolt, you push perpendicularly on a wrench with a force of 156 N at a distance of…

A: Given, F = 156 N d = 0.12 m Torque = F*d*sin A Since the force is applied perpendicular to the…

Q: In the figure below, if my 3m2. What is the ratio x2/ xt which keeps the system in equilibrium? m, X…

A: Relation between the masses :m1 = 3m2

Q: > Bing Inbox (19) - mwboutin@gma x Uh-oh! There's a problem wit × A steel wheel is mounted on OSu…

A: a) The expression for the mass of the disk is, The expression for the moment of inertia is,

Q: What is the value of the force F (N) required to balance the system in the figure? M=12 kg and F…

Q: Q1. A 750-pound boat sits on a ramp inclined at 60 degree, what force is required to keep the boat…

Q: The mass center Gof the 1200-kg rear-engine car is located as shown in the figure. Determine the…

Q: 1) To loosen a pipe fitting, a plumber slips a piece of scrap pipe (a “cheater") over his wrench…

Q: A 20.0-m-long uniform beam weighing 880 N rests on walls A and B, as shown in the figure (Figure 1).…

A: a) Consider that point B is in the midway of the beam. Apply the equilibrium condition of the moment…

Q: A device for exercising the upper leg muscle is shown in Figure shown, together with a schematic…

A: Here according to the first condition of equilibrium, the net force on system is zero and according…

Q: 3. Auniform beam of length L and mass Mhas its lower end pivoted at P on the floor, making an angle…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: Mass of object = 9 kg Theta = 37 degree Value of g = 10m/s2

Q: ACTIVITY 2B: Three Torques (Make sure to indicate the direction of all forces in the diagram.) Fen…

Q: A pencil rests against a corner, as shown below. The sharpened end of the pencil touches a smooth…

A: Given Data: The coefficient of static friction is, µs=0.80 The center of mass of the pencil is…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: C. 375

Q: 8. Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1…

Q: What is the value of the force F (N) required to balance the system in the figure? M-2 kg and F…

A: Given, M=2 kg The angle of force=37 degree we have to find force F

Q: Time lef What is the value of the force (F) in the unit of N required to balance the system in the…

A: The force in the unit of N required to balance the system. given,

Q: f the net

Q: E10. A weight of 8.0 N is located 12.0cm from the fulcrum on the beam of a simple balance. What…

A: Torque = F×r

Q: Given: The four forces and F = 200 N geometry shown. 6 m F2 = 600 N Find: The force F5 required to…

A: Given are the magnitudes of the following forces : F1= 300 N ; F2= 600 N ; F3 = 900 N ; F4 =…

Q: What is the value of the force F (N) required balance the system in the figure? M=13 kg and F makes…

Q: 4. Determine the product of inertia of the area shown with respect to the x and y aXEs. (Ans. Pxy =…

Q: I have three forces acting on some arbitrary object as given in the table below: F Fy Force 1 10 [N]…

A: Given Force Fx Fy F1 10 15 F2 -5…

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

A: Option B is the right answer 450 N force required to balance the system

Q: A 3.0-m-long rigid beam with a mass of 100 kg is supported at each end, as shown. An 80 kg student…

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

Q: Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1 and…

A: For the balance of the given system we must have i)Total force on the system along the horizontal…

Q: using this tool from…

A: The masses to be balanced net torque about any point in the space must be zero. Write the formula…

Q: A1 530-kg automobile has a wheel base (the distance between the axles) of 2.70 m. The automobile's…

Q: E 30 cm - 40 cm 30 cm - 3) In the figure shown, M2 has a mass of 2 kg, M3 has a mass of 8 kg.…

Q: 5. A gymnast rises onto her toes, as shown in the picture on the right. The floor pushes up on the…

A: Analyze the free body diagram. Consider the clockwise direction to be positive and the…

Q: Quèstion 1 In the figure below, which of the following equations is correct according to the first…

Q: 6. A yoyo is dropped as shown in the figure below. Neglect air friction. The mass of the yoyo is…

Q: The weights W1 and W2 in the figure are in rotational equilibrium. Which of the following statements…

A: The two given weights are w1 and w2The distance of w1 from the pivot point = L1The distance of w2…

Q: 2. Use the equilibrium conditions to find the weights w1, w2, and w3 required to balance the mobile.…

A: different weights are hung on the arrangement as shown . To find : the values for w1 , w2, w3

Q: if the weight of the meter stick is 10 N, what must be the weight W₂ approximately? If W₂ is placed…

A: Given Data:- Weight of the meter stick is Ws=10 N is placed at d1=15 cm of the stick. The system is…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: Mass= 6 Kg

Q: A father lifts his child as shown in Figure shown. What force should the upper leg muscle exert to…

A: Suppose the father lifts the child and according to the figure we have certain values as written…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Fg 120000 N
FA+FB 165000
%3D
FA+120000= 165000
FA=45000 N
Ex : What is the value of the force (F) required to balance the system in
the figure? M = 5 kg and F makes and angle (0 =37°) below
3 m
2 m
OM
Answer:
ET about center 0
ITMl+ITpl 0
%3D
71Page

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

To get up on the roof, a person (mass 70.0 kg) places 6.00-m aluminum ladder (mass 10.0 kg) against the house on a concrete pad with the base of ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to frictionless. The center of ladder is 2.00 m from the bottom. The person is standing 3.00 m from the bottom. Find the normal reaction and friction forces on the ladder at its base.
The leg and cast in Figure P4.40 weigh 220 N (w1). Determine the weight w2 and the angle needed so that no force is exerted on the hip joint by the leg plus the cast. Figure P4.40
The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
Scientists have studied how snakes grip and climb ropes. In one study, they found that an important characteristic of a rope is its “compliance”— that is, how easily the rope, while under tension, can be flexed. As shown how scientists measured a rope’s compliance by attaching it to two strings, each supporting an identical mass m. The strings contort the rope so that its middle section lies at angle θ. For θ = 30° and m = 100 g, what are the tensions T1 and T2 in the upper and middle parts of the rope?
The drawing below shows a person whose weight is W = 603 N doing push-ups. Assume L1 = 0.880 m and L2 = 0.435 m. Calculate the normal force exerted by the floor on each hand, assuming that the person holds this position.
Children playing pirates have suspended a uniform wooden plank with mass M = 13.4 kg, length ℓ = 2.40 m, and angle θ = 35.0°, as shown in the figure. Sophia, with a mass of m = 21.6 kg, is made to "walk the plank" and is d = 1.5 m from reaching the end of the plank. What is the tension acting on the rope at the end (i.e value of F3)?
An athlete holds a 7.5-kg shot put in his hand with his lower arm horizontal, as shown in thefigure. His lower arm has a mass of 2.8 kg and its center of gravity (or center of mass) is 12 cmfrom the elbow-joint pivot. How much force must the extensor muscle (which is FM in thefigure) in the upper arm exert on the lower arm? Choices: 500 N 2000 N 1500 N 2500 N 1000 N Show complete solution and free body diagram
A 30.630.6 kg mass (?m) is suspended by the cable assembly as shown in the figure. The cables have no mass of their own. The cable to the left (?1T1) of the mass makes an angle of 0.00∘0.00∘ with the horizontal, and the cable to the right (?2T2)makes an angle (?2θ2) of 40.6∘40.6∘. If the mass is at rest, what is the tension in each of the cables, ?1T1 and ?2T2? The acceleration due to gravity is ?=9.81 m/s2g=9.81 m/s2.
A tightrope walker is walking between two buildings holding a pole with length ?=18.0 m,L=18.0 m, and mass ??=17.0 kg.mp=17.0 kg. The daredevil grips the pole with each hand a distance ?=0.560 md=0.560 m from the center of the pole. A bird of mass ??=515 gmb=515 g lands on the very end of the left‑hand side of the pole. Assuming the daredevil applies upward forces with the left and right hands in a direction perpendicular to the pole, what magnitude of force ?leftFleft and ?rightFright must the left and right hand exert to counteract the torque of the bird?
3. Soon-Yi is building a mobile to hang over her baby’s crib. She hangs a 0.020 kg toysailboat 0.010 m from the left end and a 0.015 kg toy truck 0.20 m from the right end of abar 0.50 long. If the lever arm has negligible mass, where must the support string beplaced so that the arm balances?
Two masses are hanging from the ends of a 1 m bar. Where is the balance point of the system? m1 is 1 kg, m2 is 3 kg. Ignore the mass of the bar between the two masses.
The board sandwiched between two other boards in Figure P4.77 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping?