Answered: What is the value of the force (F) in…

What is the value of the force (F) in the unit of N required to balance the system in the figure? M=6 kg and F makes an angle (0 =37°) below horizontal. g = 10m/s2.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 62A

See similar textbooks

Related questions

Q: What is the value of the force F (N) required to balance the system in the figure? M=5 kg and F…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 77.0 kg. The pivot under the…

A: Given:- mass of beam = 77 Kg mass of women = 57 Kg L =6m l = 4 m

Q: 5. The fgure shows a uniform, horizontal beam (length = 10 m, mass = 25 kg) that is pivoted at the…

A: Fundamentals By convention let's take the torque directed into the screen as negative and out from…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

Q: At he center of the rope, a 7.9-kg ball is hung as shown. What is the tension in the rope if the…

Q: In the figure below, if my 3m2. What is the ratio x2/ xt which keeps the system in equilibrium? m, X…

A: Relation between the masses :m1 = 3m2

Q: What is the value of the force F (N) required to balance the system in the figure? M-2 kg and F…

A: M = 2 kg θ = 37og = 10 ms2

Q: A uniform plank of length 2.00m and mass 30.0kg is supported by three ropes, as indicated by the…

A: Length of plank, L=2.0 mmass of plank, m =30.0 kgweight of person, w=700Ndistance from left end,…

Q: 9. The system shown in the following figure is in static equilibrium and the angle 0 = 25.0°. Given…

A: The expression for the minimum mass at equilibrium is,

Q: 4. A 500 N diver stands at the end of a 4.0 m diving board. The diving board is attached by two…

A: Given W1 =150N W2 = 500N L=4.0m X = 1.5m We have to find the force in each of the two support.

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

Q: A uniform beam of length L = 7.75 m and weight 3.75 x 102 N is carried by two workers, Sam and Joe,…

A: The free body diagram is shown below: At equilibrium, the net force acting along the vertical…

Q: 18. o The wheels, axle, and handles of a wheelbarrow weigh 60.0 N. The load chamber and its contents…

A: For the figure on left-hand side,

Q: A uniform beam of length L = 7.25 m and weight 4.65 x 102 N is carried by two workers, Sam and Joe,…

A: The uniform length of the beam, The weight of the beam,

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 94.0 kg. The pivot under the…

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: Mass of object = 9 kg Theta = 37 degree Value of g = 10m/s2

Q: What is the value of the force (F) in the unit of N required to balance the system in the figure?…

A: C. 375

Q: Determine the additional mass required for stable equilibrium. Meter stick: Xcm = 50.0 cm, m = 150.0…

Q: A 10.0-kg monkey climbs a uniform ladder with weight w = 1.09 ✕ 102 N and length L = 3.40 m as…

A: T = 80 N Weight of the monkey = Mg = 10 × 9.8 => W = 98 N Weight of ladder w = mg = 1.09 × 10²…

Q: A strut is attached to the wall with a pin that allows free rotation about point O in the x-y plane,…

A: Given:- We have given a figure as shown below and the force on the rod as F→1= 350 lb and angle…

Q: 18) 0.3 m 0.7 m M Figure A2 If the mass of the plank is 8.8 kg what mass (M) is needed to balance…

A: Mass of the plank is given as, m1 = 8.8 kg Distance between the fulcrum and the plank is given as,…

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 92.0 kg. The pivot under the…

Q: What is the value of the force F (N) required to balance the system in the figure? M-2 kg and F…

A: Given, M=2 kg The angle of force=37 degree we have to find force F

Q: Where is the woman when the normal force n1 is the greatest? X=0 c. (c) What is n1 when the beam…

Q: E10. A weight of 8.0 N is located 12.0cm from the fulcrum on the beam of a simple balance. What…

A: Torque = F×r

Q: A carpenter's square has the shape of an L as shown in the figure below. Locate its center of…

Q: What is the value of the force F (N) required balance the system in the figure? M=13 kg and F makes…

Q: For the student shown, approximately how far from her feet is her center of gravity?A. 0.6 m…

Q: wheels, axle, and handles of a wheelbarrow weigh 60.0 N. The load chamber and its contents weigh 525…

Q: In the figure below, which of the following is correct according to the first condition of…

A: When any particle is in equilibrium the net force on it is always zero. Therefore we can balance the…

Q: Consider a beam of length L with a fulcrum x meters from one end (see figure). There are objects…

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

A: Option B is the right answer 450 N force required to balance the system

Q: What is the value of the force F (N) required to balance the system in the figure? M=19 kg and F…

Q: A carpenter's square has the shape of an L as shown in the figure below. Locate its center of…

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 79.0 kg. The pivot under the…

A: Tipping Point: The tipping point is a position in which an object is placed such that, even a small…

Q: How do you do this? A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a…

Q: Ex : What is the value of the force (F) required to balance the system in the figure? M = 5 kg and F…

A: Introduction: A system will be said to be balanced when the net torque produced by the forces about…

Q: Quèstion 1 In the figure below, which of the following equations is correct according to the first…

Q: What is the torque when a perpendicular force of 200 N is applied to a lever arm of 1.2 m?…

Q: The cylinder and the block are connected by a horizontal cord. Determine the largest couple C (in…

Q: 1250 N 4. F = ? 250 N 250 N 250 N F = ? 1250 N 1750N 1050 N 2100 N

A: when body is at equilibrium then the net force acting on the body is id equal to zero i.e summation…

Q: if the weight of the meter stick is 10 N, what must be the weight W₂ approximately? If W₂ is placed…

A: Given Data:- Weight of the meter stick is Ws=10 N is placed at d1=15 cm of the stick. The system is…

Q: 30 40 0.3 L 20 0.7 L The beam in the figure as shown has negligible weight and the pulley is…

A: Let tension in string connected to beam end is T Now, by lemi's theorem at right ride figure…

Q: Ivana Alawi placed a 50.0 g mass at the 20 cm mark in meterstick as shown in the figure. what is the…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

100%

What is the value of the force (F) in the unit
of N required to balance the system in the
figure? M=6 kg and F makes an angle (0
=37°) below horizontal. g = 10m/s² .
3 m
2 m
F
А. 150
B. None
С. 75
D. 5. V6
E. 300

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

How do he do the v impact section part at the bottom? How did he get 9.25 m/s @21 ah
Suppose just two external forces act on a stationary, rigid object and the two forces are equal in magnitude and opposite in direction. Under what condition does the object start to rotate?
Under what conditions can a rotating body be in equilibrium? Give an example.
A 185 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension ?1, and the other rope pulls up and to the left ?2=42.5∘ above the horizontal with a tension ?2, as shown in the figure. Find the tensions ?1 and ?2.
A 1350N window washers platform, 3.5 m long is suspended by two vertical wires at its ends. A 600N person is standing 2.0m form the right end. What are the tensions on both sides in two wires?
A double-decker London bus (Figure 1) might be in danger of rolling over in a highway accident, but at the low speeds of its urban environment, it's plenty stable. The track width is 2.05 m. With no passengers, the height of the center of gravity is 1.45 m, rising to 1.73 m when the bus is loaded to capacity. What is the critical angle for the unloaded bus? What is the critical angle for the loaded bus?
2. A boy weighting 600 N sits 2.5 m from the center of the see-saw. If his friend weighs 750 N, how far from the center should his friend sit so that the see-saw balances?
A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire that is attached to the wall, making a 35° angle with the post. If the post is 13kg what is the tension in the wire?
Pulling the string on a bow back with a force of 24.0 lb , an archer prepares to shoot an arrow. If the archer pulls in the center of the string, and the angle between the two halves is 126 ∘ , what is the tension in the string?
A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
To get up on the roof, a person (mass 70.0 kg) places 6.00-m aluminum ladder (mass 10.0 kg) against the house on a concrete pad with the base of ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to frictionless. The center of ladder is 2.00 m from the bottom. The person is standing 3.00 m from the bottom. Find the normal reaction and friction forces on the ladder at its base.
1. A museum of modern art is displaying an irregular 426-N sculpture by hanging it from two thin vertical wires, A and B, that are 1.25 m apart. The center of gravity of this piece of art is 48.0 cm from its extremeright tip. Find the tension in each wire. Give also the FBD. Show your complete solution.