Explain the effect of donor concentration (doping level) and temperature on electron mobility in n-type Si in connection with the electron scattering mechanism Please answer the qusetion easy to read

Q: what is the LFSE for [Co(bipy)3]^2+? splitting parameter is 11300cm-1 pairing energy is 22500cm-1

A:

Q: edral site). Determine by how much the diameter of the C atom in y-Fe is overs ct to the gap of the…

A: An interstitial  atom  is one which occupies  a site in crystal  structure  and normally not…

Q: If you plot the absorbance measurements of solutions vs. their concentrations, what is the slope…

A: Molar Absoptivity Problem A= ECL Slope = EL  Step-2 Has Picture that has proper explanation with…

Q: Calculate the lowest energy Δo for a solution

A: Orgel diagram is only applicable for weak field ligands and it shows the relative energies of…

Q: Discuss detail account on fol soft ionization techniques? a. Matrix Assisted Laser Desorption…

A: a. Matrix Assisted Laser Desorption Ionization (MALDI) Used mainly for large biomolecules (Peptides…

Q: In phase coupling increases the intensity. O True O False

A: In the phase we got the maximum envelop of first oscillation that is high frequency burst

Q: what the energy of neutron is suitable for crystal diffraction [the atomic spacing between two…

A: Given  The atomic spacing between two bonded atoms is generally around

Q: Question 29 Which of the following is not a step in Atomic Absorption Spectroscopy (AAS)? O A. Atoms…

A:

Q: Figure caption: EDS spectrum for a typical metal-rich spherule, K and L lines for noted elements are…

A: From EDS we can get the idea about the element present and it's amount . From here we can calculate…

Q: The absorbance of a solution of a weak acid was measured in the same condoitions under a series of…

A: According to the Henderson-Hasselbach equation log [conjugate base]/[acid] = pH-pka So according to…

Q: - most s

A: Dear student this question is related to organic chemistry.

Q: Statement of Purpose: Briefly include a statement of purpose for this experiment, relevant…

A: In a chemical reaction that is reversible in nature, the reaction takes place in both the…

Q: tohr Method is not good for determination of l- and SCN- due to O scattering of light O…

A: Mohr method is not good for determination of I- and SCN- because

Q: 1.0어 stoichiometric mixture- 0.8- 0.6- 0.4- metal in excess 0.2- 0.0- 0.0 0.2 0.4 0.6 0.8 1.0 XL…

A:

Q: 1. Using one set of data from Table 1 above, calculate the molar absorptivity of the Cr3+ solution…

A: Answer: According to Beer-Lambert law relation between absorbance and molar absorptivity will be:…

Q: what is the LFSE for [Fe(CN)6]4-? splitting parameter is  32800cm-1 pairing energy is 17600 cm-1

A:

Q: 3) Figure below shows an x-ray diffraction pattem for single crystal scandium nitride (ScN), having…

A:

Q: New Tab Metallic tantal C Metallic Tants C The Subitance C The Subitanci C The Subitarice C Wich Of…

A: In chemical kinetics, the rate of the reaction (the speed at which it occurs) is determined by the…

Q: is most often used to fabricate photodiodes. a. Silicon O b. Aluminim Oc. Carbon O d. Germanium Next…

A: Germanium is most often used to fabricate photodiodes.

Q: ata Sheet: Investigation of Nickel and Copper Coordination Complexes art B: The Coordination Number…

A: Given:

Q: as we increase the wavenumber, the penetration A. increases B. does not affect gher the reflective…

A:

Q: Does copper (II) acetate have a d-d or CT intensity?

A: Copper (II) acetate have CT intensity.

Q: KUESTION: 1 Silicon at T=300K contains a acceptor impurity concentration at Na=1016 cm-3. Determine…

A: Given:-          Let the donor concentration = ND cm-3               Acceptor concentration  NA =…

Q: What is the Molar Absorption Coefficient for Fe(SCN)2+ (M/cm) if the path length of vial is 2.24cm…

A: In the given question we have to calculate the molar absorption coefficient of Fe(SCN)2+ by the…

Q: EDTA and Mg

A: EDTA is chemical that binds certain metal ions, such as calcium, magnesium, lead, and iron. The…

Q: Proide corect prodsct noreacticn. Ho

A: Aqueous KOH upon heating react with a alkyl halide to give an alkene which is possibly a more…

Q: 3. (a) Draw the variation of signal strength with applied voltage for a-particles and explain. (b)…

A: This Question is based upon Nuclear Chemistry.

Q: Ionic interaction can be a mechanism of separation in SEC O HILIC NPLC O IEX

A:

Q: Condisering the following schematic representation, def,ne the mechanism involved in Cu-Ni diffusion…

A: The schematic representation on left shows Cu-Ni diffusion couple prior to heat treatment at high…

Q: Determine the diffraction angle of a polycrystalline material alpha-Fe BCC at (211) plane with…

A:

Q: If the dielectric constant of Si is 11.7, and binding energy of Sb donor is 0.039 eV and that of As…

A: Given : the formula of binding energy

Q: Trace the productiom of radionuclides in a cyclotron

A:

Q: Why is it necessary to buffer the solution with sodium acetate in the spectrophotometic…

A: To explain the reason of buffering the solution with sodium acetate in the spectrophotometric…

Q: Points to discuss: • Discuss the relationship between the concentration of the standard solution and…

A: Points to discuss: • Discuss the relationship between the concentration of the standard solution and…

Q: Q2/ Calculate the activation energy in( ev /atom) for vacancies formatiom of ( Al ) has ( 7.57 x 10)…

A:

Q: Calculate the (Ex/GS) atomic ratio for 3s---3p (oppose) in Mg* at 3000k?

A: Given that   For Mg+  Temperature = 3000K  Orbital --- 3s - 3p

Q: To establish a standard curve for a Big standard curve using Biuret, the spectrophotometer…

A: Given To establish a standard curve for a BSA standard curve using Bradford, Value to set the…

Q: Which of the following statements are true? Check all that apply. In fluorescence, AS # 0. The rate…

A: The first two options are correct. In fluorescence, ∆S is not equal to zero as in fluorescence, the…

Q: Explain how product ion scan can overcome some of the limitations of a) electrospray, and b)…

A: Product ion scan

Q: What is the strength of bisulphate anion/radical. Is it strong or weak? Explain.

A: Given anion,   Bisulphate anion/radical.

Q: Which of the following would result to an increase in the absorbance reading of the unknown…

A:

Q: There is a substance in a solution (8 g/liter). The length of cuvette is 2 cm and the extinction…

A: Given data contains, Concentration of solution is 8g/liter. Length of cuvette is 2cm. Extinction…

Q: ed in a variable pathlength cell. The absorbance of the reference and the sa cm. What is the…

A:

Q: ect the true statement(S) of the re s more sensitive than a UV detec does not respond to many…

A: The Refractive Index Detector in HPLC does not respond to many solutes. It only detects those with…

Q: Generally high temperature is favourable for chemisorption.’ Why?

A: Given: Generally high temperature is favourable for chemisorption.

Q: 5. Polarographic cells used for measuring the partial pressure of oxygen are temperature sensitive.

A: A polarographic cell is an electrochemical cell used to determine the concentration of analyte based…