For a polluted soil by crude oil. best method to wash it is by using a. EDTA O b. NAOH O c. Surfactant O d. HCI CLEAR MY CHOICE

Q: The approximate normality for a NaOH solution that Micah prepared is 0.1N. After standardization…

A: In a wine laboratory, analyzing wine for TA, VA and S02 involves the use of a sodium hydroxide…

Q: Phenol (analytical standard) is available as 5000. mg/mL solution in methanol. What aliquot (in μL)…

A: In the given question we have to calculate the volume of aliquot in microlitre (μL). Given data:…

Q: 85.A solution of known concentration used to standardize another solution is: 1. Primary standard…

A: A standard solution is a a solution of accurately known concentration prepared from a primary…

Q: 20 ml of 0.1 M sodium hydroxide is required ---- ml of 0.1M sulphuric acid at end point A- 10 B- 40…

A: Given: Molarity of sulfuric acid is 0.1 M. Molarity of NaOH is 0.1 M. Volume of NaOH is 20 mL.…

Q: What volume of 0.20 M H2SO4 can be prepared bydiluting 125 mL of 6.0 M H2SO4?

A: In chemistry laboratories, acids and bases are frequently used in reactions, But we know that some…

Q: Q1\ Answer with (True ) or (False) of the following : -innoring utical 6- Burettes, pipettes item…

A: 6. False..Burettes used in chemical analysis and pipettes used in manual method.  7 True 8.False.…

Q: A vinegar sample of 19 mL was diluted with distilled water to a 250-mL volume. 25 mL portion of this…

A: Acid-base titration: Titration is a method to determine the concentration of unknown acid by using…

Q: Based on the table below, calculate F-factor and X in the water sample. (Berdasarkan jadual di…

A:

Q: A 6.00-mL portion of an 8.00 M stock solution is to bediluted to 0.400 M. What will be the final…

A: Given: Molarity of stock solution M1= 8.00M Volume of stock solution V1= 6.00mL Molarity of dilute…

Q: A sample is analyzed for Pb. Is the ppm in a dry sample greater than,

A:

Q: How many mL of 0.10 M H2SO4 can be made from 50.0 mL of 0.25 M H2SO4?

A: M1 V1=M2 V2Here M1=0.10 M        V1=?       V2=50.0 ml      M2=0.25 M

Q: If you have an empty burette in a burette clamp, in what order do you do these steps to fill the…

A: To fill an empty burette,we have to close the stopcock of burette. Then we should remove the burette…

Q: mL of water sample requires 2.95 mL of 0.0112 M Na25

A: According to the question, we need to calculate the oxygen concentration if the titration of 33.0 mL…

Q: 27. How many milliliters of 8.00 M sodium hydroxide solution should be used to prepare 2.00 L of…

A: Number of moles of solute present in 1 liter of solution is known as molarity of the solution.

Q: A solution contains a mixture of Na;CO3 and NaOH. Using phenolphthalein indicator 25 mL of mixture…

A: Let x and y are the Meq ( Milliequivalent per litre) of sodium carbonate and sodium hydroxide…

Q: 10.00 mL of 1.10 M  HCl  diluted to 0.450 L

A:

Q: 07/03 mi of a specific scution of concertation M02 was added to it an amount of water whore volume…

A:

Q: IA student mixed 10.0 ml of 0.02 M H2SO3, 90.0 mh distilled water, aud 10.0 mL of 0.025 M Kl03. What…

A: Given that : Molarity of H2SO3 = 0.02 M Volume of H2SO3 = 10 mL Molarity of KIO3 = 0.025 M Volume of…

Q: 2Ag NO3 (a9)H CaÇha f19) How mamy h of a ó al HM Cad2. with. o.286L of a o+288M AgalOs Salution.…

A:

Q: What should you do with the 5 mL portions of NaOH used to clean the buret? Discard into designed…

A: To clean the buret , 5 ml portion of NaOH is added . Then that NaOH solution is contaminated with…

Q: how you plan to make 50mL of approximately 0.10M sodium acetate

A:

Q: -us solutions of 150.0 mL 0.30 M BaCl2 and 15 -answer.

A:

Q: A 12.7g sample of vinegar is titrated.  It requires 19.75 mL of 0.205 M NaOH to neutralize the…

A:

Q: A water contains 180 mg/l Ca, 75 mg/l Mg, 160 mg/l HCO3', and 150 mg/l CO2, all expressed as CaCO3.…

A: Total hardness TH = Ca in mg/L ×Eq. of CaCO3Eq. of Ca+  Mg in mg/L ×Eq. of CaCO3Eq. of Mg…

Q: 2- A solution 101

A: Concentration of solution in grams/litre is 350g/litre.

Q: A vinegar sample of 28 mL was diluted with distilled water to a 250-mL volume. 25 mL portion of this…

A: Acid-base titration: Titration is a method to determine the concentration of unknown acid by using…

Q: If you. dilute alle.mb ufa3.5M solution. to make isthe molovity of the dilute. Seluticn? -0.. 2.66.9…

A: We have given that  Concentration of solution before dilution = M1 = 3.5 M  Volume of solution…

Q: . What made an ashless filter paper ashless? 2.What type of precipitate is BaSO4?

A: In a chemical reaction, when a insoluble solid substance is formed this process is called…

Q: what volume (ml) of 0.70m sodium hydroxide (naoh) is needed neutralize 270 ml of 0.40 sulfuric acid

A: The required reaction, M1V1=M2V2 where, M is the molarity and V is the volume.

Q: How many milliliters of 0.05 M solution (Ca (NO3) should be mixed with pure water to obtain 500 g of…

A:

Q: You have a selution.containing 135-29 of waiter. what volume of this solution, in mi, would to make…

A: Mass of KBr=135.2 g Molar mass of KBr=119 g/mol The volume of the solution=2.3 L Moles of…

Q: 4. All the CaSO4 present in 0.511g of an impure sample of plaster is converted to 0.821g BaSO4 What…

A: Given mass of impure CaSO4 = 0.511 g mass of BaSO4 = 0.821 g The impure CaSO4 is converted into…

Q: NH vesulting from wH- Cl needed to provent mgl oH)2 From precipitating in alite of a S olution…

A:

Q: A 0.8250 g of soda ash sample was dissolved in distilled H₂O and diluted to 250-mL using a…

A: According to the bartleby guidelines for the multipart questions, I can solve only first three. So…

Q: hi i'm doind a salting effect exercise for a laboratory requiremnent.   What happens if we mixed…

A: Ethanol is also known as acetic acid. Its formula is CH3COOH .

Q: A 0.20 g sample of primary standard Na2C204 (134 g/mol) needed 37.22 mL of of KMN04 solution to…

A:

Q: The 08malic presqune associated welh salution in ä dialysis bag is 10.8 atma 25°C. What…

A: Given: Osmotic pressure of glucose = 10.8 atm Osmotic pressure of NaCl = 3×10.8 atm Temperature =…

Q: Part a and b properly solution

A: The solubility product of salt is a constant at a given temperature irrespective of the source from…

Q: Huw of Cppec CD Sulfate pentehydate vere neled. vere needed many grams to malse I00 mL cf the O.4M…

A: Here, we have to find the mass of copper (II) sulfate pentahydrate that were required to prepare 100…

Q: A 0.57 gram sample aspirin (MM=180 g/mol) is crushed and dissolved in water. The sample is titrated…

A:

Q: The KI used in this lab has a concentration of 0.500M. In trials 1-4, 1.0 ml of this solution is…

A:

Q: 5. Percent NaCl in the saturated solution: Show the calculation, including units and sig figs:…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: mL of a bleach (NaOCl) sample is diluted to 500 mL. An excessive amount of KI is added to the 20 mL…

A: We add excess  potassium iodide to  hypochlorite sample. oxidation reduction reaction takes place…

Q: serum sample of 3mL is analyzed for nitrogen by modified Kjeldahl. The sample is digested,…

A:

Q: 2- 20 ml of 0.1 M sodium hydroxide is required ---- ml of 0.1M sulphuric acid at end point 40 10 O…

A: Moles of NaOH = 2 × moles of H2SO4  Moles = molarity × volume

Q: Which portion of the detergent will dissolve dirt, say grease (oil) for example? non-polar tail, A…

A: Synthetic detergents have all the properties of soaps but actually do not contain any soap so they…

Q: Attached problem

A: Recrystallization is defined as the process in which grains of a crystal structure come in a new…

Q: 4. About 10 mL of concentrated HCl was transferred to a 1-L bottle and diluted to with water. When…

A:

Micelles and Biological Membrane

Micelles are the type of lipid molecules that organize themselves in spherical shape in aqueous solutions. The production of the micelle is a reply to the amphipathic behavior of fatty acids. It means that they consist of both hydrophobic regions and hydrophilic regions. In micelles, polar head groups (hydrophilic groups) produce an outer layer associated with water whereas nonpolar tails (hydrophobic groups) are organized in the interior.