For the CO2 impact experiment station: 1) Obtain two plastic cups, red cabbage indicator, a straw, and plastic wrap. 2) Fill each cup approximately one-quarter to one-third full of tap water and add ~10 mL of the red cabbage indicator. 3) Place the two cups side by side on a sheet of white paper. 4) Place the straw into one of the beakers and cover that beaker with the plastic wrap. 5) Carefully blow bubbles into the test cup for 3 min. and observe both cups. 6) Compare the color to the control cup and record any differences. This the Question: Did the beaker with the solution into which CO2 was bubbled change pH/color? By how much? Is this what, you would predict, based on your knowledge of the chemistry of CO2?

For the CO2 impact experiment station: 1) Obtain two plastic cups, red cabbage indicator, a straw, and plastic wrap. 2) Fill each cup approximately one-quarter to one-third full of tap water and add ~10 mL of the red cabbage indicator. 3) Place the two cups side by side on a sheet of white paper. 4) Place the straw into one of the beakers and cover that beaker with the plastic wrap. 5) Carefully blow bubbles into the test cup for 3 min. and observe both cups. 6) Compare the color to the control cup and record any differences. This the Question: Did the beaker with the solution into which CO2 was bubbled change pH/color? By how much? Is this what, you would predict, based on your knowledge of the chemistry of CO2?

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter1: Solubility

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

Table 1: Temp vs. solubility data of ammonium chloride. Test tube g NH4Cl/10 mL H2O Crystallization temp. (ºC) 1 1.0 g/10 mL H2O 10 oC 2 1.8 g/10 mL H2O 20 oC 3 2.9 g/10 mL H2O 40 oC 4 3.8 g/10 mL H2O 65 oC 5 4.4 g/10 mL H2O 95 oC Use the table to plot a solubility curve for ammonium chloride on the graph provided below. For the best fit line, use a smooth curve. "Mass of Solute per 100 mL of H2O," should be written on the y-axis (use increments of 2g for every box). "Temperature (°C)" should be written on the x-axis (use increments of 10 °C for every 2 boxes).
Tc-99m sulfur colloid is to be reconstituted with 75 mCi Tc-99m pertechnetate, to be drawn from an eluate with activity concentration of 325 mCi/mL. You will add constituents totaling 2.5 mL to the kit. What volume of eluate and of normal saline should be added to reach 5 mL final volume?
If 500mL of 0.10M Ca2+ is mixed with 500mL of 0.10M SO42-, what mass of calcium sulfate will precipitate? Ksp for CaSO4 is 2.40 • 10-5. express answer to 3 significant figures. And include units.
suppose your absent minded lab partner grabbed medium porosity filter paper instead of the fine porosity paper and you noticed cloudiness in your filtrate. will the reported concentration of limiting reactant solution be greater than, less than, or equal to the true concentration of limiting reactant solution? Na3PO4 and BaCl2 are the solutions used
Complete the following: 1. Random error, also called _________arises from the effects of uncontrolled variables in the measurement. 2. The ____________,measures how closely the data are clustered about mean. 3. The chemical equilibrium in which all the reactants and products are in the same phase are called____________. 4. Reaction that go to completion and never proceed in the reverse direction are said to be_____________ 5. The equation for buffer is the__________equation. 6. A ___________solution is one that resists changes in pH when small quantities of an acid or an alkali added to it. 7. __________is the pH of the pure, neutral and polyprotic
Can you please please please not reject this question. I really need to know this. AND THIS IS NOT A GRADED QUESTION. So can someone please answer this without rejecting this everytime. I really need to learn how to do the calculations for this becuse I have my exam within 2 weeks. So please someone and this is not a graded question. Okay this time I have included all the information. Molarity is included. An experiment was conducted by following the procedure below. Prepare a 50-mL burette for titration. Rinse the clean burette and tip with two 5-mL portions of standardized 0.005 M HCl solution and discard. Fill the burette with standardized HCl, remove the air bubbles in the tip, and record the initial volume (± 0.01mL). Record the molarity of the HCl solution, which is 0.005M Cover the flask with parafilm to avoid contact with carbondioxide from air. Rinse a 25 mL pipet with 1 or 2 mL of the saturated Ca(OH)2 solution and discard. Pipet 25 mL of the filtrate into a clean…
Tom, an analytical chemist, bought a bag of decaffeinated coffee from a grocery store. However,Tom suspected that he might have received regular coffee and therefore decided to analyze hiscoffee for caffeine. In the lab, he took 0.5 mL of the brewed coffee and diluted it in water tomake a 100.0 mL solution. He performed four analyses and found the concentrations to be 4.69,3.99, 4.12, and 4.50 mg/L, respectively. (Assume the density of all solutions is 1.000 g/mL,1oz= 28.35 mL).(a) Report the concentration (in mg/L) of caffeine in the brewed coffee using the format asaverage ± standard deviation. (Note this is not the concentration in the diluted solution.)(b) Look up the caffeine content of regular vs. decaffeinated coffee. Do you think that Tom wasgiven the wrong type of coffee?(c) Caffeine intake of 300 mg per day reportedly has no adverse effects in the vast majority ofthe adult population. If Tom drinks 3 cups (8 oz/cup) of this coffee daily, is his intake withinthis known safe…
The total cation content of natural water is often determined by exchanging the cations for hydrogen ions on a strong acid ion-exchange resin. A 25.00 mL sample of a natural water was diluted to 100.00 ML with distilled water, and 2.06 g of a cation - exchange resin was added. After stirring, the mixture was filtered and the solid remaining on the filter paper was washed with three 15.00 mL portions of water. The filtrate and washings required 16.30 mL of 0.0282 M NaOH to give a bromocresol green end point. a) Calculate the number of millimoles of cation present in exactly 1.00 L of sample. b ) Report the results in terms of milligrams of CaCO3 per liter. Only typed solution.
Pre Lab Questions: (Each answer is to be written as a complete sentence) What is the reason for washing the precipitate with water in Step 9? Define precipitate. Define filtrate. In Step 2, what is the purpose for rinsing the stirring rod? read the Procedure to answer the questions Using a balance, mass between 1.50 – 2.00 grams of sodium carbonate in a pre-massed 150mL beaker. Add 20 mL of distilled water and stir thoroughly to make sure all the crystals are dissolved. Rinse the stirring rod with a little distilled water after stirring. Using a balance, mass between 1.50 – 2.00 grams of calcium chloride dihydrate in a pre-massed 50 mL beaker. Repeat Step 2 for the solution in the 50 mL beaker. Pour the calcium chloride solution into the 150mL beaker containing the sodium carbonate solution and stir. Mass a piece of filter paper. Fold the filter paper and place it into the funnel. Wet it with a little distilled water to ensure that it is stuck to the sides of the funnel. Slowly…
Consider Table 1, which lists the volumes of the Fe3+ and SCN- solutions used for the continuous variation method. Note that each of the stock solutions is 0.002 M before mixing. What are the initial concentrations of Fe3+ and SCN- for solution 4, where the volumes are both 5 mL? [Initial meaning after they are mixed, but before]they reach equilibrium)
Write measurement of Carbon dioxide evolution during respiration of germinating seeds by the Titration method
It is known that acid content has a major effect on theflavor of vinegars, but most cheaper vinegars are diluted similarly to 5% acidity Wt./vol. % is equivalent to gsolute per 100mL solution (so 5% is equivalent to 5 g acid/100 mL solution). a.) First, calculate the approximate molar concentration of acetic acid in the 5% wt./vol vinegar. b.) Next, calculate the expected molarity of acetic acid in the solution upon dilution by a factor of 5. Thank you!