Answered: For which of the following load Oman…

Engineering

Electrical Engineering

For which of the following load Oman Electrical standard 36 is applicable. O 250KVA O 450KVA O 100KVA O 350KVA

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.44P

See similar textbooks

Related questions

Q: A 440 V, 60 Hz generator, supplies two parallel- connected loads A and B. Load A draws an apparent…

A: First of all we need to calculate the real and reactive power consume by each load. Then we need to…

Q: A step down chopper has input dc voltage of 220 V and R = 10 Ω in series with L = 65 mH. If the load…

A: Given a step-down chopper has, Input DC voltage, Vs=220 V Resistor, R = 10 Ω in series with inductor…

Q: A 3-phase alternator has a rating of 5000kVA at 13200V. Calculate the full-load line current.

A: The term "alternator" comes from the term "alternating current" (AC). Alternators generate AC power…

Q: The two-wattmeter method is used to measure the power consumed by a delta connected load. Each…

Q: Exercise 1B Consider the 30 Hz based circuit in figure below: (a) Calculate total complex power.…

A: First we will calculate impedance seen by source than current using ohms law finally complex power…

Q: A three-phase supply is generated, when the three coils are placed in 120 degree apart. Select one:…

A: Three phase supply is produced when three coils are positioned at 120 degree apart in a piulsating…

Q: 72. In 132 kV system, the phase to ground capacitance is 0.01 µF and inductance is 6H. The voltage…

Q: Problem 1 – The 4.16kV distribution station capacitor bank below consists of 3 ungrounded double-wye…

A: a) 110% of rated rms voltage b) 120% of rated peak voltage. a) Kilo over - 135% b) RMS voltage -…

Q: e interconnected system allows to reduce reserve power capacity and increase the efficien lect one:…

A: In interconnected system, many generating units are connected together.

Q: A star connected 3 phase, 12 MVA, 11 kV alternator has a phase reactance of 10 %. It is protected by…

Q: DC SOURCES IN SERIES NUMBER 3 9 V HANOSREE 24 V DAANGNG COMPUTA SA DTAL MTMETER OFF 1.5 V +…

A: SERIES CIRCUIT: A simple series circuit is defined as “a circuit with components arranged in a…

Q: In a cold storage, cosφ = 0.9 for 8 various motors, the total power of the motors is 48kW, the…

A: Active power (P) =Vicosϕ For motors: kVA Sm of each motor=Pmcosϕm Sm=490.9 Sm=53.33kVA

Q: In substations, the buses are made of a. ACSR b. aluminium O c. PVC O d. Iron

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: q1)Please need correct answer fast

Q: The primary distribution voltage in Oman is а. 220 KV b. 415 V с. 11 KV d. 33 KV

A: The primary distribution voltage is kept below 1 kV .

Q: QUESTION 3 A 450nF capacitor, a 820 ohm resistor, and a function generator are all connected in…

A: The solution is given below

Q: A 20 KVA single phase transformer has a voltage of 13.67 on the primary and 240V on the secondary…

A: In this question, We need to determine the primary side current if Primary side voltage Vp= 13.67V…

Q: A three phase motor 380 v 60HZ run with rated current 25 A at power factor of 0.5 the total power…

Q: 1. 220V ( 2.5k ohms

A: To find 1. Instantaneous current(I) 2. Maximum current(Imax) 3. Phasor diagram

Q: Q.8: 3-0, 3-wire A-connected, 250V line voltage system connected to three equal impedances each…

Q: 2. Determine the total resistance using delta to wye transformation. 20n

Q: 2. Determine if the interconnection in the following circuit is valid or not and explain why. If…

Q: If a summing point is placed before a take off point, they will be represented ___ a. one branch…

Q: 16. Three phase, 50 Hz, 30 MVA, 20 kV, delta connected alternator. Neglecting saturation, The…

A: Given, Three phase, 50 Hz, 30 MVA, 20 kV, delta connected alternator. Required excitation current,…

Q: The two-wattmeter method is used to measure the power consumed by a delta connected load. Each…

A: In this question we need to find a total power and the reading on the individual wattmeters

Q: 5. A three phase load of operates at 0.707 pf lagging. A synchronous condenser having a pf of…

Q: Modern high-speed circuit breakers have tripping times between three and eight minutes. Select one:…

A: False Modern high-speed circuit breakers have tripping times between 3 to 8 Cycle of this signal Not…

Q: Loads connected in the Electrical Power System are always classified according to Resistive,…

A: In electrical power system which generally divide the load in three types Three basic types of…

Q: In a 66 KV system the phase is ground capacitance is 0.05 µF and inductance is 2H. The voltage (kV)…

A: Given a 66 kV system with, Capacitance, C=0.05 μF Inductance,k L=2 H Current that be interrupted,…

Q: Q22)ii) In Al-Ahmadi distribution station, a voltmeter of range (0-300V) and ammeter of range…

Q: 5. The two-wattmeter method is used to measure the power consumed by a delta connected load. Each…

Q: In 3-phase power measurement, wattmeter is used to measure power. O apparent O Active O complex…

A: given three phase power measurement

Q: Question No.33 In a single connected to infinite bus bar system, alternator voltage is 1.5 pu and…

A: Given, Alternator or generated voltage, Eg=1.5 pu Terminal voltage, Vt=1 pu (as reference)…

Q: KVAR rating of any electrical equipment is equal to times of Tanø, where Ø is phase angle.

A: Reactive power rating of equipement =(KVA)sin(pi)

Q: 1-phase electrical load absorbs only 100 W. The load characteristic (type) is

A: As we know that there are three types of load, Inductive load Capacitive load Resistive load All…

Q: A 150-kVA load has a power factor of 0.75 lagging. What is the kVA rating of connected capacitors to…

Q: Two 240V fluorescent lighting units are arranged to minimize the stroboscopic effect. The active and…

A: Given Two 240 v fluorescent lighting units Unit-1The active current component of unit-1 isI1a=0.6…

Q: 5.6 Two types of connections of Wattmeter pressure coil are shown in the figures. 20 A 10 k2 20 A 10…

A: we need to determine value RC.

Q: Q9. To represent the balanced single phase power systems, the systems should be connected in Why…

A: We have to find to represent the balance single phase power system the system should be connected in…

Q: For the circuit of Figure 1 calculate the complex impedance.

Q: The rated single phase supply in Oman is Select one: O 230 V, 60 Hz O 440 V, 60 Hz O 440 V, 50 Hz O…

A: Single phase supply is generally used in household networks. It has one Line wire and one ground…

Q: -1:-Choose the right answer: 1. In a three-phase star-connected alternator, a field current of 40 A…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: 4 Determine the wattmeter reading for Figure 17–54. W 40 Q 120 V 60 N © Cengage Learning 2013

Q: 78A O 1182/8.1A

A: Solve the problem

Q: Determine the total power information for a three parallel connected loads:

Q: Determine the KVAR rating of the capacitor connected in each phase. Also comment on the type of…

A: KVAR taken by condenser bank= P×[tanφ1-tanφ2]whereP= Active power φ1 = Old power factor angleφ2 =…

Q: 1. A 100 MVA, 20 kV alternator has X 1 = X 2 = 0.20 pu and X 0 = 0.05 pu. The neutral of the…

A: To restrict the fault current, reactors can be put anywhere in the distribution circuit. Because…

Q: • T or F, modify the wrong part if False, please underline twice your answer if True or False.…

A: False Above is a false statement When two alternators connected in parallel If the KVA ratings…

Question

For which of the following load Oman
Electrical standard 36 is applicable.
O 250KVA
O 450KVA
O 100KVA
O 350KVA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
Figure 2.26 shows three loads connected in parallel across a 1000-V(RMS),60Hz single-phase source. Load 1: Inductive load, 125kVA,0.28PF lagging. Load 2: Capacitive load, 10kW,40kvar. Load 3: Resistive load, 15kW. (a) Determine the total kW, kvar, kva, and supply power factor. (b) In order to improve the power factor to 0.8 lagging. a capacitor of negligible resistance is connected in parallel with the above loads. Find the kvar rating of that capacitor and the capacitance in F. Comment on the magnitude of the supply current after adding the capacitor.
Three Impedances each of (10 – j16)Ω are connected in mesh across a three-phase 415V ac supply. Determine the phase current, line current, active power and reactive power drawn from supply.
An impedance (6 + j8) Ω is connected across 220 V, 60-Hz mains in parallel with another circuit having an impedance of (8 – j6) Ω. Calculate: (a) the admittance of the combined circuit in polar form (b) total current taken from the mains.
SUPERNODAL ANALYSIS FIND( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
Q27/ (b) Three Impedances each of (10 – j18)Ω are connected in mesh across a three-phase 425V ac supply. Determine the phase current, line current, active power and reactive power drawn from supply
Circuit Impedance Z = (ohms) Phase Angle = arc cos R/Z = Calculated Is = (A) Calculate Ic = (A) Calculate Ir= (A) Calculate Il= (A)
A single phase inductive load takes 50 kVA at 0.60 power factor lagging. Solve for the kVAR of a capacitor required to improve the power factor to 0.81.
Compute the angle of the voltage in units of degrees (enter value only, not units) for a componet with phasor current and impedance specified below - I=2A<0º Z=1Ohm<45º
Transient stability of the power system can be improved by using.O Parallel LinesSingle LinesO Single Bundled LinesO Alloy conductors
Two motors are connected to a three-phase network. Motor M1 takes 22 kW and has a power factor of 0.9 and motor M2 of 11 kW with a power factor of 0.81. a) resulting active effect b) resulting reactive effect c) resulting apparent effect d) resulting effect factor
a-Calculate and draw the load current for the first two-period interval b-Calculate and draw the voltage across the load inductance