frictionless A 166.4 cm 166.4 cm pulley h e frictionless pulley 118 kN 27 kN

Q: A 50 kN weight is supported by a cable and a pulley attached at frame BAC. Find forces AB and AC.…

A: Given data  Weight (W)=50kN

Q: 750 N is Fig. 1 shows a simple six bar linkage held in static equilibrium while a force P applied.…

A: Kinetic energy of system (T)T=m1x˙22+m2(x˙+Lθ)˙22+I2θ˙2where I=m2L2

Q: CDEFGH is plate with a circular hole in it and has a unit weight p (N/m²). It is attached on DE beam…

A: Given: The weight of plate, ρ = 400 N/m^2 The coefficient of friction between crate and surface, µ1…

Q: 1. Please find the support reactions at A and 5 kN 20 kN В. 30° 1m 1m 1m

A:

Q: The forklift weighs 3500 lb and carries an 800-lb shipping container. There are two front wheels and…

A:

Q: 1. Figure Q1 shows an illustration of a bell crank mechanism that is in a state of static…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 3/2 A carpenter carries a 12-lb 2-in. by 4-in. board as shown. What downward force does he feel on…

A:

Q: A pulley-and-cable assembly supports block W and requires a downward force at P for equilibrium.…

A:

Q: Problem 1: The surface of the inclined plane is smooth (no friction). The inclination is 0, with…

A: Consider the free body diagram as shown below for the box. From the force equilibrium along the…

Q: Situation 2: Find the minimum force P required to just pull out box B. Also, find the tension of the…

A:

Q: The pulley system below is in static equilibrium, where load W3 is 730 N, angle a = 500 and angle 0…

A:

Q: -5 ft- 400 lb 200 lb/ft -21₁1-1₁- -2 ft- FIG. P5.17 4 ft D 2 in.

A: Calculate the reaction at the support, RA+RC=400+200×5+2+4RA+RC=2600  ............ 1Taking moment…

Q: a frictionless pulley. The coefficie blocks and also between the bo 1 equal to 0.3. The force P (in…

A:

Q: Problem 4a: Find the reactions at A and C. 40 lb 60 lb 80 lb 4 in. 4 in. 4 in.

A: giventruss as shown below

Q: The crane shown in the figure supports in G a weight of 150 lb (includes the log and the grapple…

A: For the given crane Weight = 150 lb  To draw  (a) FBD of entire crane  (b) FBD of part EFG and part…

Q: 4)Find true magnitude and direction of forces on the wheel and cable members at static…

A:

Q: pont pressed 2 in for the position veen 800 and 2000 lb/in, pl of 100 lb/in. ugh 30 degrees above…

A: Use Energy Conservation: T1 + V1 = T2 + V2Vie = T2 + V2g12 k x12 = 12 m v62+ 12 I6 w2+ mg( 1.5)12…

Q: 6.5kN Find the force in EF,CF,BC and mention if it's a compression or

A:

Q: The weight shown below is 1000 lb, attached to a cable at E, running througha smooth pulley with a…

A: Given data W=1000lb

Q: (1) Calculate the support reaction. Draw the N, M, T diagrams of the figures given below. 10 kN 3 m…

A: A beam's shear force diagram (SFD) and bending moment diagram (BMD) depict the variation in shear…

Q: Physics - Finish A particle of mass m is suspended by massless string inside a trolley of mass m as…

A: Write the given value using suitable variables. Here mA signifies trolley mass, and mB signifies…

Q: a uniform ladder 8 meters long and weighing 350 N rest against a smooth vertical wall at an angle of…

A: Given: Length of the ladder is 8 m. Weight of the ladder is 350 N. Angle from the vertical wall is…

Q: Two masses are attached to a uniform meter stick as shown in the figure below. The masses of m1 and…

A: Given: Mass m1=50gMass m2=75gMass of the meter stick m3=150g

Q: he stopper in the figure has a specific gravity of 76 kN/m°. Calculate the diameter for the valve to…

A: we have to calculate the diameter of Ball

Q: 30° а ст 2r Figure 3 D Č, 4) There are three cylinders located as in the figure 4. Two of them which…

A: The free-body diagram of the system is given below, The value of angle θ, θ=cos-1r3r=70.528o

Q: A force P=95 lb causes the angle = 60° for equilibrium. Cord AB is 2 ft long. Take &= 50 lb/ft.…

A: To find: The unstretched length of the spring. Given: The stiffness of the spring is k=50 lbft. The…

Q: P-2. Write the two equations of equilibrium, 2F, = 0 and EF, = 0. Do not solve. 600N 60 450 N 30 (a)…

A: For the figure (a)

Q: For the pulleys system shown below, if each pulley has 80 N weight , answer the following to be the…

A:

Q: A truss is facing a two-force member and both of them are in the opposite directions, and the truss…

A: If two forces are in going in opposite directions and are collinear too. Then the truss is getting…

Q: Calculate the forces arising on A, B and D pins with the effect of 500N horizontal force in the…

A:

Q: The pulley system below is in static equilibrium, where load W3 is 730 N, angle α = 50O and angle θ…

A: Given Data The given load is:W3=730 N θ=30° α=50° To find: The ratio of the load W1W2 Now draw the…

Q: A boom hinged at the base of a vertical mast is used to lift a 2000 load. Find the tension in the…

A:

Q: For P1=558 N and P2=698 N, the internal force in member DC is (assume all forces are tension) –3 m 3…

A: Given figure, In ΔCDE,

Q: The pulley system below is in static equilibrium, where load W3 is 730 N, angle a = 500 and angle 0…

A:

Q: Two blocks of mass Mi and M2 are connected by a massless string that passes over a massless pulley…

A:

Q: A small ring Pis threaded on a fixed smooth horizontal rod AB. Three horizontal forces of magnitudes…

A:

Q: 2. Cable AB passes over the small ideal pulley C without a change in its tension. The length of…

A: Given data Weight of load W = 50N To determine the tension in the cable CD

Q: (11) Ignoring friction, the equation E x ED = R x RD is true for all three classes of levers. Use…

A: In the given lever diagram, hinge is at point D, Load of 100 N is acted at point R and the effort is…

Q: (Q3] (a) Support A is ball and socket while at Z there exists a frictionless slot as shown in the…

A:

Q: Freblem 2ir the conds wuspend the twe buckets weight of 60 rl position tucke A 20 Figure 2:…

A:

Q: In the shown systems of pulleys, the weight of each box is W=100N. For each configuration, calculate…

A: In this problem, there are 3 unknowns in part A so we will answer only part (A). Please resubmit the…

Q: Calculate the force in the AE cable in the system in equilibrium position shown in the figure.…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: 4 kN 3 m 4 m Use the method of joints to find all reaction and member forces in the trusses.

A:

Q: 4)Find true magnitude and direction of forces on the wheel and cable members at static…

A: Solution:

Q: For figure a and b show calculations to determine the support reactions PLUS draw proper free body…

A:

Q: Q) Internal forces are not shown on a free-body diagram because the internal forces are (Choose the…

A: In the given statement, it is asked  why internal force is not shown in Free body Diagram.

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.