Given the following data/observations for experiment #43B [39B]: a. the mass of Benzyltriphenylphosphonium Chloride (BTPC)(limiting reactant) used was 0.486g. b. the observed melting point of the purified product was 145-149 °C. c. the mass of the purified product was 0.217 g. Calculate the theoretical and the percent yield of the purified product from the above data (show all appropriate calculations and units).

Given the following data/observations for experiment #43B [39B]: a. the mass of Benzyltriphenylphosphonium Chloride (BTPC)(limiting reactant) used was 0.486g. b. the observed melting point of the purified product was 145-149 °C. c. the mass of the purified product was 0.217 g. Calculate the theoretical and the percent yield of the purified product from the above data (show all appropriate calculations and units).

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter7: Extraction

Section: Chapter Questions

Problem 1Q

See similar textbooks

Similar questions

Using the data below calculate the percent yield for the formation of the ether product in the acid catalyzed condensation synthesis of Methyl beta Naphthyl ether? Weight of 2-napthol ____0.505g_______________ Volume of methanol ____2ml______________ Volume of concentrated sulfuric acid _________1.0ml________ Weight of crude product ____0.295g__________ Weight of purified product ___0.144g_________ M.P. Of Product (If solid otherwise write Liquid) _____70-75 C___________
1. Calculate the percent by volume of acetic acid by fermentation. Assumptions: No volume changed during fermentation and conversion efficiency is 85%. Overall chemical reaction facilitated by Acetobacter aceti:C2H5OH + O2 = CH3COOH + H2OGiven: Volume of 6% C2H5OH = 3 LMolar mass of C2H5OH = 46.07 g/molMolar mass of CH3COOH = 60.06 g/molDensity of C2H5OH = 0.789 g/mLDensity of CH3COOH = 1.05 g/mL
Write TRUE if the BOLD word/phrase makes the statement correct. Otherwise, write the correct WORD/PHRASE that will make the statement true. If there are two bold words/phrases in a number, write your answer for EACH of the bold words/phrases. 1. The addition of excess charcoal would decrease the % recovery in the purification by recrystallization. 2. If the target compound is contaminated with impurity, the melting point will be higher than the theoretical value and the melting range is large.
A batch of raw milk was tested and found to contain a bacterial population of 8xl06cfu/ml. It is to be pasteurised at noc for 33 seconds. The average D value at 52°C for the mixed population is 11 min. The z value is 10°C.i)Explain the terms "D value" and "z value".ii)Calculate how many organisms will be left after pasteurisation.iii)Hpw much time will be needed at 62°C to accomplish the same degree oflethality?iv. How much time will be needed at 82°C to achieve the same degree oflethality?
In the molecular weight determination by the Dumas method, several grams of an organic liquid was drawn into a bulb. The bulb was then immersed in a water bath at 87 degrees C and kept there until all the liquid was vaporized and the air in the bulb was replaced by the vapor. The tip was then sealed shut and the bulb removed from the vapor was 36.127g; the weight of the empty (evacuated) bulb was 35.427g; the bulb’s volume was 200.0mL; room temperature was 25 degrees C, and the barometric pressure was 720 mm Hg. Calculate the molecular weight of the organic liquid. Calculate the molecular weight of the organic liquid.
If 0.70 g of FeCl3 is used to iodinate 8.42 g of benzene with sufficient ICl, what is the average number of reactions that each FeCl3 molecule must catalyze?
Based on your research and observations, write the balanced chemical equation/s of the sample/s that will give positive test for Baeyer's reagent. Samples: hexane, cyclohexene, tert-butyl chloride, toluene, water
1)The fat content of 10 g of commercial ice cream was determined by the Mojonnier method. The weights of the extracted fat after the second extraction and the third extraction were 1.30 and 1.36 g, respectively. How much of fat, as percentage of the total, was extracted during the third extraction?
9. Any organic solvent waste generated in this experiment should be collected in your fume hood and poured into the waste container as directed. This waste should not be poured down the drain. True False
If to a solution of NaOH, in water and ethanol (20 ° C) 3 mmol of A (106.11 g / mol) and 2 mmol of B (58.06 g/ mol) and stirred magnetically for 10 minutes. After the reaction is completed, we proceed to isolate (work- up) and purify at C (246.29 g/ mol) yielding 0.300 g of the pure product. Calculate the% return for C showing his work. please show every single step and calculations
Assume that the mass of impure acetanilide is 1.732 g. and the mass of recrystallized acetanilide is 1.271 g. Calculate the percent recovery.
on what factors does the catalytic property of zeolite depends upon?