Gravimetric Analysis: Determination of Chloride Ion in Sodium Chloride Salt Mass of Unknown Sample= 0.4567g Mass of filter paper= 1.0023g Mass of watch glass=22.8795g Mass of watch glass, filter paper and precipitate= 24.0133g Find the following: A.Mass of Precipitate B. Moles of Cl- C. Mass of Cl- D. %Cl-

Gravimetric Analysis: Determination of Chloride Ion in Sodium Chloride Salt Mass of Unknown Sample= 0.4567g Mass of filter paper= 1.0023g Mass of watch glass=22.8795g Mass of watch glass, filter paper and precipitate= 24.0133g Find the following: A.Mass of Precipitate B. Moles of Cl- C. Mass of Cl- D. %Cl-

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.23QAP

See similar textbooks

Similar questions

A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g.29. Compute for the mass (g) of BaSO4 from the experiment.A) 0.3933B) 0.3393C) 0.3133D) 0.3951E) 0.359130. Compute for the experimental mass (g) of SO3 in grams obtained by the student.A) 0.1439B) 0.1349C) 0.1943D) 0.1394E) 0.359131. Compute for the experimental % SO3 obtained by the student.A) 73.21B) 56.33C) 17.89D) 56.89E) 72.8032. Compute for the theoretical % SO3 obtained by the studentA) 0.3933B) 56.37C) 17.33D) 17.89E) 0.425233. Compute for the theoretical mass (g) of SO3 that should be obtained by the student…
A sodium thiosulfate solution can be standardized by using it to titrate the iodine liberated by the action of excess KI on a known weight of primary standard K2Cr2O7: Cr2O72- + 6I- + 14H+ → 2 Cr3+ + 3I2 + 7H2O I2 + 2S2O32- → 2I- + S4O62- Calculate the molar concentration of the sodium thiosulfate solution if 31.47 mL of this solution were required to titrate a sample prepared using 0.2177 g pure K2Cr2O7.
Prepare 0.1 M solutions of NaOH and 0.1 M ethyl acetate using high-purity distilled water. So, weight desired amount of NaOH and ethyl acetate and dissolved in dH2O to prepare stock solution in equal molarity. Mw (NaOH) = 40.0 g/mol , Mw (EtOAc)= 88.1 g/mol, Density(EtOAc): 0.898 g/cm3
Which among these is/are properties for the type of precipitate required in gravimetric analysis? Hygroscopic Known composition Reactive with atmospheric constituents Large particles
0.5 g mixture of (0.1 N KCI and 4 points KBr) is required to 58.03 mL of 0.1 N AGNO3 to precipitate both bromide and chloride as AgCl and AgBr. Calculate the weight percentage for each of the AgCl and AgBr in a mixture if you know that the molecular weight of KCI = 74.5 and of KBr = 119 * %3D
What is the minimum concentration of Ca2+ (M or mol/L) required to form a precipitate with a 0.025 M Na3PO4 solution? (Ksp for Ca3(PO4)2 is 1.0 × 10-26) Enter your answer as scientific notation with the correct number of sig figs, without any units. Use the format #e#
One litre of a saturated aqueous solution of Ag2SO4 (MW = 311.79 g mol- 1) at 25 °C is evaporated to dryness. 4.844 g of Ag2SO4 residue was produced. What is the solubility product (Ksp)?
The mass of K3PO4 needed to prepare 250.0mL of an aqueous solution in which PO4-3 concentration is 0.0550M. The answer is ……………………… How many grams of silver sample is equal to 0.0417 mole of silver The answer is ……………………… When 38.0 mL of 0.1250 M H2SO4 is added to 100 mL of a solution of PbI2, a precipitate of PbSO4 forms. The PbSO4 is then filtered from the solution, dried, and weighed. If the recovered PbSO4 is found to have a mass of 0.0471g, what was the concentration of iodide ions in the original solution The answer is ……………………………… Express 96.342 m using 2 significant figures The answer is ………………………………. The oxidation number of sulfur in (Na2S2O5) is? The answer is ………………………………
You have a 0.05M stock solution of NaCI (Formula Weight: 58.4g/mole), a 0.25Mstock solution of glucose (Formula Weight; 180.2g/mole), and a bottle of solid Tris base (FormulaWeight: 121.1g/mole). How would prepare (be specific) 150mL of a single solution containing75mM Tris, 15mM glucose, and 5mM NaCl.
TOPIC: GRAVIMETRY SHOW THE SOLUTION The mercury in a 0.7152-g sample was precipitated with an excess of paraperiodic acid, H5IO6, according to the following reactions:5 Hg+2 + 2 H5IO6 ---> Hg5(IO6)2(s) + 10 H+The precipitate was filtered, washed free of precipitating agent, dried and found to weigh 0.3408-g. Calculate the percentage of Hg2Cl2 in the sample. Molar Masses: Hg5(IO6)2 = 1448.75 Hg2Cl2 = 472.09 Answer: 38.82% Hg2Cl2 An iron ore was analyzed by dissolving a 1.1324-g sample in concentrated HCl. The resulting solution was diluted with water, and the iron (III) was precipitated as the hydrous oxide Fe2O3·xH20 by the addition of NH3. After filtration and washing, the residue was ignited at a high temperature to give 0.5394 g of pure Fe2O3. Calculate (a) % Fe, and (b) % Fe3O4 in the sampleMolar Masses: Fe2O3 = 159.69 Fe = 55.847 Fe3O4 = 231.54 Answer: 33.32% Fe and 46.04% Fe3O4
The concentration of CO in the air can be determined by passing a known volume of air through a tube containing I2O5, resulting in the formation of CO2 and I2. I2 is removed from the tube by distillation and collected in a solution containing excess KI, producing I3-. I3- is titrated with a standard solution of Na2S2O3. A 4.79 L air sample was sampled as described here, requiring 7.17 ml of 0.00329 M Na2S2O3 to reach the endpoint in a typical analysis. If the density of the air is 1.23×10^-3 g/ml, what is the amount of CO in the air in ppm? (CO: 28 g/ml)
In gravimetric analysis, volatile electrolyte is used in peptization step a. to form small nucleib. to easily dry precipitatec. to reprecipitate the analyteexplain please