Answered: H.W) 1013.25 J of heat energy is…

H.W) 1013.25 J of heat energy is supplied to 1mol of NH3 ( which is initially volume is 4L at constant pressure 2 atm. if the process is isothermally expansion, determine its final volume.

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter2: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 2.65E: A sample of an ideal diatomic gas is compressed adiabatically and reversibly to double its initial...

See similar textbooks

Related questions

Q: QUESTION 1 You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml)…

A: Given: absorbance of unknown sample = 0.284 To find: Set up a standard curve, determine the protein…

Q: Part A Abeaker with 1.10w10 ml of an aceic acid bufer with a pt of 5.000 is sing on a benchtop. The…

Q: Consider the reaction: 2KCIO, 3 () 2KCI, + 30, 2 (e) At standard state, AG for the reaction is – 35…

A: In ∆G is negative then reaction is spontaneous and if ∆G is positive then reaction is non…

Q: 20.77°C -300mL 600mL - 200mL 500m 400mL 300mL 200mL 100mL 100mL SOLIDS SOLUTIONS LIQUIDS SOLUTIONS…

Q: What is the formula of the precipitate formed when calcium bromide reacts with potassium phosphate?…

Q: What is the empirical formula of a compound that is found to be 61.4% vanadium and the rest is…

A: In this question, we want to determine the empirical formula of the compound which contains V and O…

Q: What is the volume (in L) of (2.11x10^-1) g of argon gas if the pressure is (4.0800x10^2) mm Hg and…

Q: The pH factor is a measure of the acidity and alkalinity of water. A reading of 7.0 is neutral;…

A: Given data: 7.3, 7.4, 7.2, 7.0, 7.5, 7.4, 7.3, 7.3, 7.2, 7.1 n = 10 α = 0.05

Q: What thermodynamic quantity is used to determine whether a chemical reaction will proceed…

A: In the thermodynamic system we can determine which reaction is spontaneously or which reaction is…

Q: The correct formula for diamminetetraaquacopper(Il) chloride is: O ICUCI(NH)2(H,O)]…

Q: Compare the rate of H2 (g) with that of N2 (g) under the same conditions. (MW of H = 1 and N = 14)

A: Graham's law of diffusion: The rate of diffusion or effusion is inversely proportional to the…

Q: 3. Solve for the van’t Hoff factor if the freezing point of a 0.11 m solution of HNO3 is -0.20°C.

Q: B. Calculate the molality of a water solution if the freezing point is: 6. -9.3°C

A: Molality of solution is defined as number of moles of solute dissolved per kilogram of solvent.

Q: Predict the products of the following unbalanced neutralization reaction: NaHCO3 + H2S04 → O H20 and…

A: A neutralization reaction is a chemical reaction in which acid and base react to form salt and…

Q: Acidic solution such as 10-8 M acetic acid and 10-8 M HCI contains H* that is supplied mostly by a.…

A: Strong acids are those acids which realises more H+ ion ie. dissociation of acids occurs completely…

Q: What determines that a homogeneous solution will form? Identify the steps in the process that…

A: When solute and solvent molecules experience same type of intermolecular forces they form solution…

Q: Which of the following is the correct order in which light passes through a UV-Vis spectrometer? O…

Q: Main eondihon which w satisfy to give meari fuf solution c Eigen fuuction) must Dhetailed. puysical…

Q: Explain why the reagents are added in the specific sequence described in the experiment.

A: To explain why reagents are added in the specific sequence in an experiment.

Q: Based on the balanced thermochemical equation: 4 NO + 6 H2O → 4 NH3 + 5 O2 ΔH = +(8.880x10^2) kJ…

A: Given, 4 NO + 6 H2O → 4 NH3 + 5 O2 ΔH = +(8.880x102) kJ mass (in grams) of H2O are required to…

Q: What volume of 0.260 M Na2S solution is required to completely react with 40.00 ml of a 0.315 M…

Q: A student has a sample of 1.13 moles of fluorine gas that is contained in a 27.0 L container at 297…

A: Given, Number of moles, n = 1.13 mol Volume, V = 27.0 L Temperature, T = 297 K Ideal gas…

Q: Calculate the molar solubility of XF2, (Ksp = 6.8 x 10 6) in a 0.158 M X(NO3)2 solution. Report your…

Q: Which of the following plates represents the course of the reaction from beginning to end, assuming…

A: In TLC, higher the polarity of a compound, higher are its interactions with the stationary phase.

Q: For each of the following statements, answer TRUE or FALSE and explain your answer briefly.…

A: The goal of calibration is to reduce any uncertainty in measurement by ensuring the accuracy of test…

Q: There are two containers, container A with volume 3.0 L and container B with volume 1.0 L…

Q: pH 1 pH4 pH 8 pH 12 H. H,N'-C-C-OH H,N-C-C-o HN-C-C-o H,N-C-C-o CH, CH, CH, CH, HN HN -NH -NH NH NH…

A: Histidine has three ionizable functional groups and equilibrium equations for its three ionizations…

Q: Calculate the Vmax for an enzyme-catalyzed reaction that follows Michaelis-Menton kinetics if the…

Q: 22. Provide the starting materials for the following Williamson Ether Synthesis reaction. Alkyl…

A: In this question we have to tell the starting material of the given reaction.

Q: A 15.152-gram sample of a hydrate was heated to drive off the water, leaving Al(NO3)3 (s) with a…

Q: Consider the following dissociation reaction of iodine at 1000 K: 2(g) = 21(g) The following data is…

A: Solutions Given that Consider the following dissociation reaction of…

Q: C A) k В) -1/k C) In[A]o D) -k E) 1/k 2A In [A] time

A: The slope of the graph ln[A] vs t Will be equal to

Q: An otherwise empty flask with 1.40 atm of N2O5 gas is allowed to decompose at a constant high…

Q: If a solution is red in color, which of the ff. is INCORRECT? 1. Red light is absorbed. II. Green…

Q: H2 (8) 2 H2(g) + O2(g) → 2 H2O(1) AH° = -571.6 kJ From the following enthalpy changes, calculate the…

Q: Substance X is known to exist at 1 atm in the solid, liquid, or vapor phase, depending on the…

A: Given Sample X at 0oC is put into an evacuated flask and heated at a constant rate until 15.0 kJ/mol…

Q: 2. A 1.5 g sample of a mixture of naphthalene (C10H8) and anthracene (C14H10) is dissolved in 20.0g…

A: Given that, Weight of the sample mixture of naphthalene and anthracene = 1.5g Weight of benzene =…

Q: Which chemical reaction is described by the standard cell notation shown below?…

Q: 4G.. 14:34 What type of interaction would you expect between the R groups of the following amino…

A: Amino acid are building block of protein. Amino acid contain carboxyl group, one amino group and one…

Q: The ff. statements are incorrect, EXCEPT: I. Molecules undergo electronic transitions only during…

Q: 2. Kc for the following reaction at 70degC is 4.0. CH3COOH + C2H5OH CH3COOC2H5 + H2O A mixture…

A: CH3COOH + C2H5OH <----> CH3COOC2H5 + H2O I 2 mol 3 mol…

Q: What is it called when the final temperature of your Solid and the water are equal? (Calorimetry)

Q: A student measured concentrations of potassium ions in the solutions using flame photometry and…

A: This can be determined using the given equation.

Q: Moving to another question will save this response. Question 36 Which of the following compounds is…

A: Bases such as calcium hudroxide can be used in inaking cement, ammonium hydroxide can be used in…

Q: 1. Arrange the halides tested in order of decreasing reactivity toward Ag^ + (S N 1) 2. Explain…

A: GIVEN: 1. Arrange the halides tested in order of decreasing reactivity toward Ag^ + (S N 1) 2.…

Q: Question 11: What is the identity of the alkyl bromide that Gwen used in this reaction? CI Br Br…

A: Given reaction is :

Q: How many coffee beans can you buy if you spend $(2.3000x10^2)? Each coffee bean weighs (1.60x10^-1)…

A: Known Weight of each coffee bean = 1.60 ×10^-1 gram 1 bag coffee contains 454 g coffee beans . Cast…

Q: 2. What is the solubility of lead (in pM) for solid Pb(OH)2 in a sample of water containing 2.4 x…

Q: Which of the following is the purpose of beam splitter in double beam photometer or colorimeter? O…

A: Double beam spectrophotometer is used to compare the light intensity of light of reference sample…

Q: Give the IUPAC names of the following(skip e) CI 2-chloró-4-ethylheptane a) b) c) d) = f)

A: IUPAC name are as follows:

Question

H.W) 1013.25 J of heat energy is supplied to 1mol of NH3 () which is initially
volume is 4L at constant pressure 2 atm. if the process is isothermally
expansion, determine its final volume.
(g)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Applications of Statistical Thermodynamics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Many compressed gases come in large,heavy metal cylindersthat are so heavy that they need a special cart to move them around. An80.0-Ltank ofnitrogen gas pressurized to 172 atm is left in the sun and heats from its normal temperature of 20.0C to 140.0C. Determine a the final pressureinsidethe tank and b the work, heat, and U of the process. Assume that behavior is ideal and the heatcapacity of diatomic nitrogenis 21.0J/mol.K.
What is the finaltemperature of0.122 mole ofmonatomic ideal gas that performs 75J of work adiabatically if the initial temperature is 235C?
Use the heat capacities of the products and reactants of the thermite reaction and the calculated H of the process to estimate the temperature of the reaction. Assume that all of the heat generated goes to increasing the temperature of the system.
A 220-ft3 sample of gas at standard temperature and pressure is compressed into a cylinder, where it exerts pressure of 2000 psi. Calculate the work (in J) performed when this gas expands isothermally against an opposing pressure of 1.0 atm. (The amount of work that can be done is equivalent to the destructive force of about 1/4 lb of dynamite, giving you an idea of how potentially destructive compressed gas cylinders can be if improperly handled!)
The following are values of heat capacity for nitrogen gas; Temp K Cv J/mol. K 300 20.8 400 20.9 500 21.2 600 21.8 700 22.4 800 23.1 900 23.7 1000 24.3 1100 24.9 Using the general formula Cv = A BT C/T2, find values of A, B, and C that fit the given data.
Calculate the work for the isothermal, reversible compressionof 0.245 moleof an idealgas going from 1.000L to 1.00 mL if the temperature were 95.0C.
For the process A(l) A(g), which direction is favored by changes in energy probability? Positional probability? Explain your answers. If you wanted to favor the process as written, would you raise or lower the temperature of the system? Explain.
The distance between downtown San Francisco and downtown Oakland is 9 miles. However, a car driving between the two points travels 12.3miles. Of these distances, which one is analogous to a state function? Why?
A piston reversibly and adiabatically contracts 3.88 moles of ideal gas to one-tenth of its original volume, thenexpands back to the original conditions. It does thisa total of five times. If the initial and final temperatures both are 27.5C, calculatea thetotal work andb thetotal U forthe overall process.
A sample of an ideal diatomic gas is compressed adiabatically and reversibly to double its initial pressure. By what percentage does its absolute temperature change in a the low-temperature limit and b the high-temperature limit?
Explain why the high-temperature reservoir of a heat engine must, indeed, be higher in temperature than the low-temperature reservoir. Can it ever be the other way around?
Would the amount of heat absorbed by the dissolution in Example 5.6 appear greater, lesser, or remain the same if the heat capacity of the calorimeter were taken into account? Explain your answer.