How to obtain the relative error with a set of data points

Q: if we increase the number of trials, what will happen to the uncertainty ? and what is the…

A:

Q: Why is the y intercept of a regression line 0?

A:

Q: The mean deviation of the values, 18, 12, 15 is

A: ∙Mean devation is calculate by following  is formula   Mean deviation=ΣX-Xn   where X is value,  X…

Q: The original solution was diluted by a factor of three, and then the absorbance of the diluted…

A: According to Lambert Beer law, the absorbance of a solution is directly proportional to its…

Q: what are the adavantages of the internal standard method compare to calibration curve method

A: In internal standard method, an internal standard filled in the same matrix as the analyte filled.…

Q: The data system; controls all modules of the HPLC instrument; takes signal from the detector and…

A: Ans: Computer

Q: As used in the definition of a sampling distribution, "all possible random samples refers to

A: The sample distribution involves the usage of statistical methods in the probability distribution of…

Q: The results + standard deviation (number of samples) are given in the following table:

A: The two methods are: • chromatography •spectrophotometry

Q: (i) What is the difference among 1, 2, and 3?

A: The main difference is the substitution at the rightmost 5 membered ring. In compound 1 there is no…

Q: - the AH value

A:

Q: For the data below, What is the Limit of Linearity based of the Linear Calibration Curve. Answer…

A:

Q: dynamic data is essential.

A: In this question we have to explain above situation and give more examples of such dynamic data in…

Q: Read the length of the metal bar with the correct uncertainty error range (+/-). 5 10 15 20 cm

A: Length is measurement of anything from end to end.

Q: if a researcher includes a plateau of data points when fitting a linear trendline, what impact can…

A: Answer. Regression analysis is a technical measurement used to analyse linear regression. It…

Q: The following molarities were calculated from replicate standardization of a solution: 0.5025,…

A:

Q: Give two examples of the offset errors

A: Offset error arises due to the initial point is not calibrated to zero.

Q: Using the information above, run the linear regression for your data. Enter the equation for the…

A: A question based on general chemistry that is to be accomplished.

Q: My available answer options for part B are: A) 5.88x10-1g B) 5.88x102g C) 1.18x100g D) 1.18x103g…

A: We need to select the correct option for the mass of oxygen

Q: 1. Problem In analytical chemistry accuracy describes: (a) How wide is data spread (b) How close to…

A:

Q: Using the data table given below, calculate the molar concentration for a sample dye solution with a…

A: Absorbance of dye is 0.304  We have to find concentration of dye which has absorbance 0.304  A = ϵ b…

Q: Use the dimensional analysis method, convert 10000000 pound-force in to megapascal.

A: 1 pound-force = 0.00689 MPa

Q: We use control charts to monitor a. random variation. b. assignable variation с. natural variation

A:

Q: Below are group of words. Tick the circle of the choices that is most likely not belonging to the…

A:

Q: Explain the reason 4-point probe method is considered to be more accurate than 2-point probe method.

A: To find: The reason for 4-point probe method is considered to be more accurate than 2-point probe…

Q: or the straight line defined by the points ( 4,55) and (6,83), determine the slope (m) and…

A: When determining graphs in chemistry it is often provided with the points on the graph and we need…

Q: When the maximum potential error is set at 4mg in a total of 120mg, what is the percentage error?

A: Maximum potential error is 124.  Percentage error is 3.33%

Q: In analytical chemistry, what is the difference between determinate and indeterminate errors? Cite…

A: generally, these types of errors are observed incase of titrations.

Q: The following molarities were calculated from replicate standardization of a solution: 0.5021,…

A:

Q: variance

A: If the standard deviation for a experimental data is D  then variance for that experimental data…

Q: Colourblindnees detect end point, that error called of the person unable to الاختيارات Personal…

A:

Q: 2 1.2 1.1 3 0.9 4 0.7 For each set, determine the mean, spread, stand rariation. Calculate the…

A:

Q: b. What are the correct labelings of the axes for the data plot?

A: The experimental procedure related to the concerned data plot has been described with the question.

Q: Using the data given below, determine the relationship between Sstd and Cstd using an unweighted…

A:

Q: What about the stretches at 2900 and 2600?

A:

Q: A solution of potassium chromate of unknown concentration was analyzed against a standard of various…

A: A question based on absorption that is to be accomplished.

Q: Does frequency factor vary with time

A: Frequency factor is also known as pre-exponential factor. Which is very important part of Arrhenius…

Q: For the data below, Calculate the Minimum Detection Limit based of the Linear Calibration Curve.…

A:

Q: What is compensation depth?

A:

Q: Calculate (capacity factor) of (C)

A:

Q: A system will be error free if we remove all systematic error. A True B False

A: Given question is :  A system will be error free if we remove all systematic error.  Whether the…

Q: Match the following terms with their corresponding definitions: Accuracy How close the measured va…

A: Accuracy = How close the measured value is from the true value.

Q: Determine the slope of the linear regression line for a standard curve of concentration versus…

A: The slope of the linear regression line for a standard curve of concentration versus absorbance is…

Q: Calculate the standard error of regression (SER) for the Lineweaver-Burk slope and the Eadie-Hofstee…

A: Standard error of regression (SER )  is the measure of average distance that the viewed…

Q: The following data were obtained in order to determine the density of a cylindrical metal bar. If…

A: From the data obtained, we first need to find out the average density of the bar. Since mass =…

Q: at Error d)

A:

Q: Calculate the 95% confidence interval for these set of data: 3.2, 3.3, 3.4, 3.3,3.4 and 3.5 ppm a.…

A: The given values of the data set are: 3.2, 3.3, 3.4, 3.3, 3.4,  and 3.5 ppm Total number of data, n…

Q: The illumination of an object on the microscope stage passes through a lens (the illumination lens)…

A: Given: What fraction or multiple of the illumination lens focal length (f) should the illumination…

Q: The Gaussian distribution is characterized by the and the O mean; precision O mean; standard…

A:

Q: how do i find the regression line formula and r ^2 labeled on the graph?

A: To find regression formula and r2 we can use Excel.