Determine the slope of the linear regression line for a standard curve of concentration versus absorbance using the following data. Concentration (M) Absorbance 2.00x10-5 0.0500 5.00x10-5 0.130 1.00x10-4 0.200 2.00x10-4 0.450 5.00x10-4 1.25 7.50x10-4 1.40 Group of answer choice 5.00x10-4 1.00x10-5 1990 0.0420 0.456 0.296

Determine the slope of the linear regression line for a standard curve of concentration versus absorbance using the following data. Concentration (M) Absorbance 2.00x10-5 0.0500 5.00x10-5 0.130 1.00x10-4 0.200 2.00x10-4 0.450 5.00x10-4 1.25 7.50x10-4 1.40 Group of answer choice 5.00x10-4 1.00x10-5 1990 0.0420 0.456 0.296

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter26: Molecular Absorption Spectrometry

Section: Chapter Questions

Problem 26.2QAP

See similar textbooks

Similar questions

Concentration [M] Absorbance Solution 1 86.29 0.64 Solution 2 51.986 0.29 …. Fig 1: [graph of the calibration curve, make sure to show: function, R2, 0 intercept]
Table 1. Data for the Concentration of the KMnO4 Unknown Solution. Abs of Unknown Solution is 0.362 Absorbance Concentration Trial 1 0.120 0.00145 Trial 2 0.066 0.00104 Unknown Solution: __________ What is the Concentration of the Unknown Solution. _____________ Show statistical treatment of data.
The original solution was diluted by a factor of three, and then the absorbance of the diluted cereal sample solution was measured and recorded as (2.0x10^-1). Use the following trendline and dilution factor to determine the concentration of iron, in unit of M, in the original cereal sample solution. The trendline (linear regression) as displayed on the plot is y = 11898x - 0.0112.
Use least square regression to determine the best straight line and slope; compare the slope from 5 & 6. Concentration (M) Absorbance (no units) 0.10 0.09 0.20 0.14 0.30 0.19 0.40 0.27 0.50 0.30 0.60 0.34 0.70 0.37
Explain the reason 4-point probe method is considered to be more accurate than 2-point probe method.
Derive an expression relating absorbance to the concentrations of standard and unknown ( c subscript s and c subscript x) and the volumes of the standards and unknown ( V subscript s and V subscript x ) as well as the volume to which the solutions were diluted (V subscript t). Derive expressions for the slope and the intercept of the straight line obtained in (a) in terms of the variables listed above.
Give answer of both subparts in clear handwritten answer.
Why is the y intercept of a regression line 0?
A solution of KMnO4 with a concentration of 8.25 x 10-5 M yields an absorbance value of 0.1302 when measured in a 5.60 cm cuvette, set at a wavelength of 725 nm. Compute for the Molar Absorptivity Coefficient of the sample. Choices: a. 2.8182x10-8 c. 4.8182x10-8 b. 3.8182x10-8 d. 5.8182x10-8
Why is gradient elution used
An absorption measurement with a 1 cm path length yields a reading of 0.004 absorbance units with a noise of 0.001 absorbance units and a mean noise reading of 0 for 10 scans averaged together. Assuming the noise for a single scan does not change if the path length is increased to 6 cm and the number of scans is increase to 100, what is the signal to noise of the new measurement.
A student prepared a cereal sample solution using a procedure similar to that in Lab 5. The original sample solution was diluted by a factor of two, and then the absorbance of the diluted sample solution was measured and recorded as (2.0x10^-1). Use the following calibration plot and the dilution factor to determine the concentration of iron, in unit of M, in the original cereal sample solution. The trendline (linear regression) as displayed on the plot is y = 11898x - 0.0112.