Answered: Identify the maximum intrabeam…

Identify the maximum intrabeam permissible exposure (MPE) for the eye: a. CO2 laser for 10 seconds b. HeNe laser for 0.25 second c. Argon laser for 600 seconds d. XeCl laser for 30,000 seconds

Chemistry In Focus

7th Edition

ISBN:9781337399692

Author:Tro, Nivaldo J.

Publisher:Tro, Nivaldo J.

Chapter7: Light And Color

Section: Chapter Questions

Problem 48E

See similar textbooks

Related questions

Q: The following is an UV-Vis schematic diagram. Based on this diagram, answer the following questions:…

Q: How does a CEM detector work

A: Channel electron multipliers (CEMs) are detectors, which respond to charged particles, hard and soft…

Q: In the figure on the right are spectra of two continuum light sources. (a) The spectrum on the left…

A: (e) both (a) and (d) are correct. Deuterium arc lamp - continuous spectrum of deuterium arc…

Q: Q15: If you want a high-resolution gamma detector for 1 MeV gammas, which of these is best? a) A…

A: In electromagnetic radiation, Gamma rays are the highest-energy form as compared to other forms of…

Q: The following is an UV-Vis schematic diagram. Based on this diagram, answer the following questions:…

A: To answer: What kind of spectrophotometer (single or double beam) as shown in the diagram? Give a…

Q: 14.48) Name three characteristic properties of a laser.

A: Characteristic properties of a laser: Coherence: Laser light are highly coherent because emission of…

Q: If electrons are ejected from a given metal when irradiated with a 10-W red laserpointer, what will…

A: The photoelectric effect is a phenomenon in which the electrons are ejected from the surface of the…

Q: Does the amount of radiation (cpm) increase or decrease as the thickness of the shielding increases…

A: Given information, The distance between the source and the sensor stays the same

Q: Force Completion Once started, this test must be completed in one sitting. Do not leave t Remaining…

A: Wavenumber is given by,

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: A 0.035 g of KMnO4 was dissolved in 200 mL of distilled water. This solution had a transmittance of…

Q: Read the excerpts from chemistry journal articles. Determine which section each quote was likely…

A: The first one is the EXPERIMENTAL. It refers to the details of the experiment.

Q: n 1963 javan and townee attained a short term frequency stability of roughly S parts per 10 with a…

A: frequency = S parts per 10 with He-He gas laser therefore variation in frequency…

Q: lassure (mlla 7.5 A3D025 9.4 3 =0.34 %3D 12.5 42=D0.5 7elct the dcta anve on he Graaph welow. 40…

A: There are 4 important parameters which are used to define the gas. They are absolute temperature,…

Q: 1. Calculate a reflective loss when a 589 mm beam of radiation light passes through a piece of…

A: 1. Solution -

Q: II B C D What is the design of figure Il? double beam spectrophotometer diode array…

Q: In this lab exercise, you will make use of Beer's law (also called Beer-Lambert Law) which is stated…

A: Beer-Lambert law: According to this law, the absorption of radiation by the substance depends on the…

Q: Type of UV transition

A: Type of UV transitions

Q: (c) Highlight the difference between COSY-45 and COSY-90 and mention their applications.

A: Correlation Spectroscopy (COSY ) shows the correlation between hydrogens which are coupled to each…

Q: Determining the absorbance of known concentrations for Solution A: What is the most sensitive…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: An empty infrared cell showed 8.9 interference fringes in the wavelength range of 1894 to 2399 cm-1.…

A: The equation required to determine the path length of cell is as follows, b=∆N2ν1-ν2

Q: a. When the light source is monochromatic, Beer's Law holds true. b. Beer's Law establishes a…

A: The answer is given below

Q: The extinction coefficient for FD&C Blue Dye #1 is 138,500 cm-L/mol at 630 nm. A chemist collected…

A: A question based on quantitative analysis, which is to be accomplished.

Q: A student wants to determine the concentration of iron ion in a 15.000 gram solid that contains…

A: As the solution is absorbing green light, the color of the solution would be red according to color…

Q: The effect on motion when an electric potential is applied and positive ions drag a group of…

A: Retardation effect: Retardation is the delaying the process. Thus by Retardation effect is when…

Q: The extinction coefficient for FD&C Blue Dye #1 is 138,500 cm-L/mol at 630 nm. A chemist collected…

A: A question based on quantitative analysis, which is to be accomplished.

Q: Intensifying screens can be placed on both sides of the X-ray film (double-sided) or on one side…

A: Intensifying screens can be place in x-beam film in light of the fact that the two sides of x-bar…

Q: 15. Lenses are coated with thin film to reduce a. Diffraction d. Refraction C. Reflection foronce…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: a- Draw the electromagnetic (EM) spectrum from γ-rays to radio indicating radiation wavelengths…

A: with increase in frequency the energy is increase AND WITH INCREASE IN WAVELENGTH IT SHOULD…

Q: Helen performed an experiment with KMNO4 at 520 nm. Given the percent transmittance of 5 ppm KMNO4…

A: Answer :- ε = 2047 (L.mol-1.cm-1) The Molar absorptivity (ε) of KMnO4 solution = 2047 L.mol-1.cm-1…

Q: Does the amount of radiation (cpm) increase or decrease as the thickness of the shielding increases…

A: The amount of radiation (cpm) increase or decrease has to be predicted

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: Spectrophotomeric Data: (for standard Beer's Law graph) These are Calculated Values mL primary mL…

A: A table of spectroscopic data

Q: From the following options what's the reason why we use absorption and not percent transmittance for…

A: We use absorption and not percent transmittance for UV-Vis spectrophotometry because The absorption…

Q: About Atomic spectroscopy a) Explain the fundamental difference between the two main types of…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: 9. Describe the characteristics and differences between two important micro-analyzing techniques:…

A: Characteristics: Auger Electron Spectroscopy (AES) The scanning Auger microscope is a device that…

Q: What are the advantages and disadvantages of using external standards in

Q: Two 50.0 mL aliquots of a sample were prepared. To one sample, a spike of 2.0 mL of 2 mg/L Fe…

A: In the least square fit equation, y = Absorbance x = Concentration of the sample

Q: 22.6, t 25.1, t n the highlighted area to zoom. Click again to zoom back out.

A: From C-13 NMR we can identify different types of Carbon with their electronic environment.

Q: Which of the following is the purpose of beam splitter in double beam photometer or colorimeter? O…

A: Double beam spectrophotometer is used to compare the light intensity of light of reference sample…

Q: Using the figure below, match the name of the parts of UV-Vis Spectrophotometer found on box with…

A: There are four basic components to a simple single beam UV/Vis spectrophotometer; a light source, a…

Q: 100 ml of a solution contains 0.050 g of a coloured compound that absorbs exactly half the incident…

Q: 5 2. RED ORANDE YELLOW OREEN BLUE BROWN IL 6 9 4

A: The Retention factor of brilliant blue can be calculated as follows

Q: Reset Help 3p 1111 2 111 3p 1 2s 1 34 11 1 1111 4p 1 1 1 4s 1. 3d 3 11 3s 1 4s 1 Aufbau violation…

A: Electronic configuration of an atom is defined as the arrangement of electrons of the atom in its…

Q: Explain the following, giving examples in each case: the inert pair effect refractive lining

A: (a) In periodic table, especially in group 13,14 and 15 , down the group, electrons in the…

Q: What causes light refractics, what does the index of refraction (n) express

A: Refraction of light is resulted by the variation of velocity in various medium by which we can see…

Q: Match a row to a column * Luminescence Laser Photoconductivity Electron microscope O O Welding O O…

A: Luminescence is a process of emission of light. A laser is also a device that emits light in the…

Question

Identify the maximum intrabeam permissible exposure (MPE) for the eye:
a. CO2 laser for 10 seconds
b. HeNe laser for 0.25 second
c. Argon laser for 600 seconds
d. XeCl laser for 30,000 seconds

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Describe how a laser works.
14.48) Name three characteristic properties of a laser.
Using words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can correct for spectral interference in flame atomic absorption spectrophotometry (background absorption/scattering by non- specific absorbers).
Type of UV transition
6. Give one advantage of contact printing over proximity printing. Giveone disadvantage of contact printing compared to proximity printing. 7. A pattern is to be printed using deep UV radiation for the exposure.Should the mask material be made of glass or quartz? Why? 8. Pattern resolution is increased by decreasing exposure wavelength. Ifa projection printer is used, will the objective lens need to be redesigned?Why or why not? 9. In a clean room rated at class 1000, on the average, how many particles percubic meter are there? Assume a particle size of 1 um. 10. After exposing a resist, why is it a good idea to bake the resist? 11. When positive resist is exposed, what happens to its solubility? 12.With respect to transferring a pattern to the resist, what is meant byresolution? 13.What kind of cleaning process is best suited for a wafer before it isoxidized?
Find information on fluorescent dye Fluo-3: Display its structure Briefly describe its purpose and the mechanism of operation Display its fluorescence spectra Display transmission spectra of commercially available optical filters required for flow cytometry measurements of cells stained with Fluo-3 (see lecture notes on where to look)
Briefly, but informatively, explain the following as encountered in analytical chemistry: (i) Photoelectric effect (ii) K−absorption edge (iii) Dead time of a detector
What is flame photometry The general principles of flame photometry Limitation of techniques for flame photometry (what to measure) How to use flame photometry in clinical applications
From the following options what's the reason why we use absorption and not percent transmittance for UV-Vis spectrophotometry? The percent transmittance is not detectable The absorption has better resolution The food coloring reacts to the light if using the percent transmittance The absorption is directly proportional to the concentration of the solution None of the above
What is the IR and HNMRAndCNMR?