In an oscillatory motion of a simple pendulum, the ratio of the maximum angular acceleration, e"max, to the maximum angular velocity, O'max, is t s^(-1). What is the time needed for the pendulum to complete one-half oscillation? 4 sec 0.5 sec 1 sec

In an oscillatory motion of a simple pendulum, the ratio of the maximum angular acceleration, e"max, to the maximum angular velocity, O'max, is t s^(-1). What is the time needed for the pendulum to complete one-half oscillation? 4 sec 0.5 sec 1 sec

Name: In an oscillatory motion of a simple pendulum, the ratio of the maxim
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: In an oscillatory motion of a simple pendulum, the ratio of the maximum angularacceleration, O"max, to the maximum angular velocity, 0'max, is T s^(-1). What isthe time needed for the pendulum to complete one-half oscillation?4 sec0.5 secO 1 sec0.25

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Oscillatory Motion

Section: Chapter Questions

Problem 30P: A small object is attached to the end of a string to form a simple pendulum. The period of its...

See similar textbooks

Similar questions

An automobile with a mass of 1000 kg, including passengers, settles 1.0 cm closer to the road for every additional 100 kg of passengers. It is driven with a constant horizontal component of speed 20 km/h over a washboard road with sinusoidal bumps. The amplitude and wavelength of the sine curve are 5.0 cm and 20 cm, respectively. The distance between the front and back wheels is 2.4 m. Find the amplitude of oscillation of the automobile, assuming it moves vertically as an undamped driven harmonic oscillator. Neglect the mass of the wheels and springs and assume that the wheels are always in contact with the road.
Show that the time rate of change of mechanical energy for a damped, undriven oscillator is given by dE/dt = bv2 and hence is always negative. To do so, differentiate the expression for the mechanical energy of an oscillator, E=12mv2+12kx2, and use Equation 15.51.
Determine the period of oscillation of a simple pendulum of length L suspended from the ceiling of a car that rolls down an inclined plane of angle (Fig. P16.73). Dissipative forces between the car and the plane are negligible.
A small object is attached to the end of a string to form a simple pendulum. The period of its harmonic motion is measured for small angular displacements and three lengths. For lengths of 1.000 m, 0.750 m, and 0.500 m, total time intervals for 50 oscillations of 99.8 s, 86.6 s, and 71.1s are measured with a stopwatch. (a) Determine the period of motion for each length. (b) Determine the mean value of g obtained from these three independent measurements and compare it with the accepted value. (c) Plot T2 versus L and obtain a value for g from the slope of your best-fit straight-line graph. (d) Compare the value found in part (c) with that obtained in part (b).
A very light rigid rod of length 0.500 m extends straight out from one end of a meterstick. The combination is suspended from a pivot at the upper end of the rod as shown in Figure PI5.42. The combination is then pulled out by a small angle and released, (a) Determine the period of oscillation of the system, (b) By what percentage does the period differ from the period of a simple pendulum 1.00 m long?
A small object is attached to the end of a string to form a simple pendulum. The period of its harmonic motion is measured for small angular displacements and three lengths. For lengths of 1.000 m, 0.750 m, and 0.500 m, total time intervals for 50 oscillations of 99.8 s, 86.6 s, and 71.1 s are measured with a stopwatch, (a) Determine the period of motion for each length, (b) Determine the mean value of g obtained from these three independent measurements and compare it with the accepted value, (c) Plot T2 versus L and obtain a value tor g from the slope of your best-fit straight-line graph. (d) Compare the value found in pan (c) with that obtained in pan (b).
A swimmer in the ocean observes one day that the ocean surface waves are periodic and resemble a sine wave. The swimmer estimates that the vertical distance between the crest and the trough of each wave is approximately 0.45 m, and the distance between each crest is approximately 1.8 m. The swimmer counts that 12 waves pass every two minutes. Determine the simple harmonic wave function that would describes these waves.
A spring of negligible mass stretches 3.00 cm from its relaxed length when a force of 7.50 N is applied. A 0.500-kg particle rests on a frictionless horizontal surface and is attached to the free end of the spring. The particle is displaced from the origin to x = 5.00 cm and released from rest at t = 0. (a) What is the force constant of the spring? (b) What are the angular frequency , the frequency, and the period of the motion? (c) What is the total energy of the system? (d) What is the amplitude of the motion? (c) What are the maximum velocity and the maximum acceleration of the particle? (f) Determine the displacement x of the particle from the equilibrium position at t = 0.500 s. (g) Determine the velocity and acceleration of the particle when t = 0.500 s.
Consider a graphical representation (Fig. 12.3) of simple harmonic motion as described mathematically in Equation 12.6. When the particle is at point on the graph, what can you say about its position and velocity? (a) The position and velocity are both positive. (b) The position and velocity are both negative. (c) The position is positive, and the velocity is zero. (d) The position is negative, and the velocity is zero. (e) The position is positive, and the velocity is negative. (f) The position is negative, and the velocity is positive. Figure 12.3 (Quick Quiz 12.2) An xt graph for a particle undergoing simple harmonic motion. At a particular time, the particles position is indicated by in the graph.
Can this analogy of SHM to circular motion be carried out with an object oscillating on a spring vertically hung from the ceiling? Why or why not? If given the choice, would you prefer to use a sine function or a cosine function to model the motion?