What is the easiest process to get to the result? Assignment - x- OWLV2 | Online teaching and lea XB Calculate the number of milliliter xM Mathway | Algebra Problem Solv xnent/takeCovalentActivity.do?locator=assignment-take[Review Topics][References]Use the References to access important values if needed for this question.In the laboratory you dissolve 20.0 g of ammonium phosphate in a volumetric flask and add water to a total volume of 125 mL.What is the molarity of the solution?M.What is the concentration of the ammonium cation?M.What is the concentration of the phosphate anion?M.Submit AnswerRetry Entire Group2 more group attempts remaining

Molarity,concentration of cations and anions can be calculated as follows

In the laboratory you dissolve 20.0 g of ammonium phosphate in a volumetric flask and add water to a total volume of 125 mL. What is the molarity of the solution? M. What is the concentration of the ammonium cation? M. What is the concentration of the phosphate anion? M. Submit Answer Retry Entire Group 2 more group attempts remaining

In the laboratory you dissolve 20.0 g of ammonium phosphate in a volumetric flask and add water to a total volume of 125 mL. What is the molarity of the solution? M. What is the concentration of the ammonium cation? M. What is the concentration of the phosphate anion? M. Submit Answer Retry Entire Group 2 more group attempts remaining

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 42QRT

See similar textbooks

Similar questions

Draw the spitting diagrams for HC-OH for borneol and isoborneol. Draw them to scale as best as you can, e.g. 1Hz = 5mm or similar
The dye "Smoky Red" (SR) also reacts with NaOH(aq). You are in the lab and perform the following steps: Run1: 20 mL of SR stock solution (1.9 X 10-4 M) diluted to 100 mL 10 mL of NaOH stock solution (2.2 X 10-1 M) diluted to 100 mL at t=0, two above solutions are mixed SR Absorbance (Beer's Law constant = 1.2 X 105) is measured at 90 sec intervals Run2: 20 mL of SR stock solution diluted to 100 mL 20 mL of NaOH stock solution diluted to 100 mL at t=0, two above solutions are mixed SR Absorbance is measured at 60 sec intervals Reciprocal plot of SR absorbance gives q2 = 30.6 X 10-2 sec-1 The reaction of Smoky Red with sodium hydroxide solution is found to occur with a pseudo rate constant q1 of 7.3 X 10-2 sec-1. After Run 2 when volume of sodium hydroxide is doubled, q2 = 30.6 X 10-2 sec-1. Assuming the reaction is second order with respect to the dye, what is n for this reaction (round to the nearest whole number)?
A calibration curve of KCl conductivity (y-axis) vs concentration (mass percent, x-axis) is made. The equation of line of best fit is y = 578.3x + 0.380 and the R 2 is 0.9998. Based on this data what is the mass percent of an unknown KCl solution with a conductivity of 2,788 uS/cm? 6.55 % 6.12 % 4.14 % 3.98 % 4.82 %
Need help on 8. ii iii 9.
How many g of water you need to add into HCl solution (V= 130.0 cm3 mass percentage 22.0 % (w/w), density: 1.40 g/cm3) if you would like to get a solution with 5 % (w/w)? What is the concentrations (g/dm3 and mol/dm3) of the final solution if the density of it is 1.050 g/cm3? Mr(HCl) = 36.46.
5.00 mL of stock solution is diluted to 25.00 mL, producing solution ALPHA. 10.00 mL of solution ALPHA is diluted to 25.00 mL, resulting in solution BETA. 10.00 mL of solution BETA is then diluted to 25.00 mL, producing solution GAMMA. dilution factor for ALPHA from stock solution = 0.167 dilution factor for BETA from ALPHA solution = 0.0476 part c and d?
Mass of aspirin used is .090 g the absorbance for the final solution was .304 nm Slope is 1708 and y-intercept is -0.03397 what is the molarity of the final unknown solution and the molarity of the original solution made from aspirin in the 250.0 ml flask
This is not graded. Do number 6 and 7.
A lead compound would be most promising if it had: A.KM = 4.7 × 10^5 M. B.K(I) = 1.5 × 10^-8 M. C.K(I)= 4.7 × 10^-5 M. D.K(I)= 4.7 × 10^5 M. E.K(I) = 1.5 × 10^8 M.
A dilution of benzene in methanol is made by placing 1.5 mL benzene (density of benzene is 0.879 g/mL and its mol. Wt. is 78.1) in a 100-mL volumetric flask and brining to volume with methanol. What is the concentration of benzene in the solution in mg/L In ppml
Caffeine (C8H10O2N4 • H2O) has an absorbance of 0.510 at 272 nm and 1 cm optical path in1 mg / 100 mL concentration solutions. A 2.5 g sample of soluble coffee is diluted withwater to 500 mL. Take 250 mL, add 25.0 mL of 0.1 N H2SO4 and dilute it to 500 mL. Theabsorbance at 272 nm resulting in 0.415. A) Calculate the grams of caffeine per kg of soluble coffee in the sample. Themolar mass of caffeine is 212 g / mol.
Procaine hydrochloride (MW = 273; L iso value = 3.37). Calculate its NaCl Equivalent 0.24 0.19 0.18 0.21