List seven advantages that an aluminum parallel- flow,plate/fin evaporator has over a standard round, coppertubeplate/fin evaporator.

Q: True or False? The diesel fuel’s antiknock quality ismeasured by the cetane rating

A:

Q: To convert KN to N, it is multiplied by 100. * оо true Error The net force can be found using only…

A: GIVEN DATA- SOME TRUE/FALSE AND MCQ QUESTION GIVEN WE HAVE TO CHOOSE CORRECT OPTION

Q: Compute the value of pressure at depth of 12.16 m from top of water

A: Given:depth, h=12.16 m

Q: Technician A checks a starter’s field coils for opensby connecting an ohmmeter between the…

A: Given Starter’s field coils check To find Which technician is or are correct

Q: A hallow steel shaft 2540 mm long must transmit torque of 34 KN-m. The total angle of twist must not…

A: Given that, for a hollow shaft, L = 2540 mm T = 4 kN-m Maximum angle of twist =  3 degrees Maximum…

Q: The rotation or twist in degrees of a shaft, 800 mm long subjected to a torque of 80 N-m, 20 mm in…

A:

Q: 1- Threshold shown in Figure (2), calculate the reactions in datums A, F a 1.5 m 1.5 m 450 N A A…

A:

Q: 5. Suppose that there is a negative frictional force proportional to the velocity on a harmonic…

A: Given data: mx¨-bx˙+kx=0 Need to discuss the qualitative nature of the given equation.

Q: Compression of air in an axial flow compressor would be part of what thermodynamiccycle? Carnot…

A:

Q: QUESTION 5 Consider the fully developed flow of light oil at 25°C (p = 910 kg/m³, μ = 0.048 Pa)…

A:

Q: A dehumidifier brings in saturated wet air (100 percent relative humidity) at 30°C and 1 atm,…

A:

Q: For the system of forces shown in Figure (4), find the resultant and direction of the forces and…

A: Given question: Find the resultant and its direction and then locate them with respect to the point…

Q: Problem 6 A 6 meter high, 5 meter wide rectangular plate blocks the end of a 5 meter deep freshwater…

A:

Q: 10. A stream of 2 kg/s of CH, at 1.6 bar and and 140 K is compressed adiabatically to 50 bar and 400…

A: Given: The mass flow rate of methane, m = 2 kg/s The initial pressure of methane, P1 = 1.6 bar The…

Q: A 15 m building use cast iron pipes in their piping system. The water tank located on the top of the…

A:

Q: A rubber block is placed between two rigid walls where a load of P = 65 kN is applied on top as…

A:

Q: Hello Sir, Good Morning I have a question in my home work related mechatronics lesson. The…

A: Given

Q: For the system of forces shown in Figure (4), find the resultant and direction of the forces and…

A:

Q: What are the different formulas needed in heat and transfer?

A: Heat transfer takes place in three different forms namely: Conduction Convection Radiation

Q: What is the purpose of multiple passes in a chiller evaporator?

A: A tool used in refrigeration systems is the evaporator. This apparatus' principal function is to…

Q: vehicle is producing a sharp, metallic rappingsound originating in the upper portion of the…

A: As per suggestion of Technician A: If the vehicle is producing sharp, metallic rapping sound from…

Q: Technician A uses a micrometer to measure the connectingrod journal for taper. Technician B uses…

A: In this problem, it is asking that which technician is correct.

Q: Q. 3: Compare the moment of resistance of the two sections for equal areas of cross-section and of…

A:

Q: The magnitude of the reaction in the datum C shown in the figure is equal to

A:

Q: Shear and Moment Equations, and Diagrams  based on these equations is necessary…

A: Given simply supported beam

Q: Find FA and FB.

A:

Q: Saturated steam at 3 atm will flow through a 3 in. Schedule 80 steel pipe. In order to decrease the…

A:

Q: Q. 4: Determine the nature and magnitude of the forces in member CD, DE and EF (Ref. Fig. 4). 2m 82m…

A:

Q: Q3 A 400-N force is applied to the welded slender bar at an angle 0= 20° 1) Determine the equivalent…

A:

Q: strength is * non-vector quantity vector and non-vector quantity vector quantity Not from the above…

A:

Q: 450 N PA +1.5m 2.5m 2.0 m B D 1.5 m 3.0 m + 100 N 1.5 m TRE 85 N

A:

Q: Which of the following is not part of the starter motorcircuit?a. Batteryb. Starting safety switchc.…

A: given; Which of the following is not part of the starter motor circuit?

Q: am 15kN 35 3m IDKN am Initial FBD Final FBD Find the reactions. Fill in the blank's Draw and label…

A:

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

A:

Q: Find the depth of water at which pressure is equal to 1200 Pa

A:

Q: Find the forces in members EF, KL, and GL for the Fink truss shown. Forces are positive if in…

A: For the given truss, t is required to determine the forces in members EF, KL, and GL.

Q: Compute the Cross sectional area of Pipe Discahrge=0.8 m3/s Velocity=2 m/s

A: Given data : Velocity V=2 m/s Discharge Q=0.8 m3/s   To find : Cross sectional area of pipe

Q: A cyclic heat engine operates between source temperature of 1000 °C and a sink temperature 50 °C.…

A: Given, Source temperature = T1 = 1000 oC = (1000 + 273) K = 1273 K Sink temperature = T2 = 50 oC =…

Q: The Foulcault Pendulum at the California Academy of Science in San Francisco is constructed by a…

A:

Q: Two uniform spheres are positioned as shown. Determine the gravitational force F which the titanium…

A:

Q: strength is non-vector quantity O vector and non-vector quantity 0 vector quantity O Not from the…

A: Given question: Strength is  non-vector quantity vector and non-vector quantity vector quantity not…

Q: Find the heat transfer rate of water that enters a tube with a flow rate of 0.015 kg/s and an inlet…

A: Given data: Mass flow rate = m = 0.015 kg/s Inlet temperature = T∞   = 20°C Length of tube = L = 6 m…

Q: Starting from rest the motorboat travels around the circular path with radius of curvature 50 m, at…

A: GIVEN DATA- A Boat travel around circular path R=50m , V=0.8t m/s , We have to find acceleration and…

Q: Produce a 3D solid model of the Guard casing and test boss

A: Given Test boss Guard casing To find 3D solid model

Q: Identify the Miller Indices for the plane shown: 2 1/2 2/3 (413) (314) (213) (423) (432)

A: Given data: x-intercept=12y-intercept=1z-intercept=23 Need to determine the miller indices for the…

Q: Find the reactions in predicates A and B for the threshold shown in the figure below

A:

Q: Circuits that can energize the high beams even if theheadlight switch is off are known as __…

A: The headlight circuit's dimmer circuit, which is wired in series, enables the driver to switch…

Q: A vertical pole consisting of a circular tubeof outer diameter 5 in. and inner diameter 4.5 in.…

A: Introduction: When external loads are applied to a beam, they must be limited in order to maintain…

Q: A pitot tube is inserted into an air flow to measure the flow speed to measure flow speed. The Pitot…

A:

Q: Consider a cylindrical specimen of a steel alloy 10.0 mm in diameter 75 mm long that is pulled…

A:

Hydronics