Mass of empty 250-mL glass beaker: 100.7g Mass of 250-mL beaker and anhydrous citric acid                         First weighing : 103.4 g                         Second weighing: 106.1 g             3. Total volume of citric acid solution: 75.0 mL

Q: columns of equal length. The void time, tM, is equal to 1.75 min on each column. A tm Column 1…

A:

Q: Test Data:             Part 1: Preparation of the Primary Citric Acid Standard Mass of empty…

A: Moles = given mass / molar mass Molarity = moles / volume in litre

Q: PROCEDURE 1000 mg L-asocrbic acid tablet (pulverized into fine powder) Molar mass of tablet =…

A: A question based on introduction to chemistry that is to be accomplished.

Q: Trial 1: Initial pH= 3.92mL Mass of KHP and Paper= 0.868g Mass of paper= 0.357g Mass of KHP= 0.511g…

A: The titration curves for both the trials given are,

Q: a solution that is 0.160 M in propanoic acid and 0.110 M in potassium propanoate (where pK, = 4.87…

A: pH of a buffer is given by the following equation.  pH=pKa + log[base][acid]

Q: Part A: Complete the flow chart with the steps necessary for preparing the pH probe. pH Probe…

A: pH probe cleaning and reading: (i) Electrode is rinsed with water. (ii) Then it is Blot dried by…

Q: fn control option command MODULE Science 7 in your notebook. GIASU: mulov solution that is 2% boric…

A: Calculation of above questions is given below.

Q: What will be the concentration of HOAc immediately after combining the solutions to make up Solution…

A: The molarity equation signifies that- M1: molarity of NaOAc solution. V1: volume of NaOAc solution.…

Q: Problem 1 (Show your work for all parts of answer.) A student did an analysis for clomazone in soil…

A: Answer: Given data- Flow of nitrogen to exactly 10 ml and 50 ml of ethyl acetate.

Q: Trial 1 Trial 2 Trial 3 Volume of Sample (mL) 55.00 55.00 55.00 Final Volume of EDTA (mL) 7.90 15.40…

A:

Q: TRIAL 1 TRIAL 2 TRIAL 3 Wt. of vinegar sample 8.2000 g 8.1000 g 8.2500 g Vol. of vinegar sample…

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: 6.Why: a) saturated NaCl, b) saturated NaHCO3, are used to wash (work up steps) organic product?…

A: Limiting reactant: The limiting reactant is the reactant that gets used up in a chemical reaction…

Q: 20.0 mL water sample was titrated with 0.0100 M EDTA solution that required 14.50 mL for CaCO3…

A: Here we have to determine the hard ness of hard water interms of CaCO3 if 20 mlbof hard water sample…

Q: PROCEDURE 1000 mg L-asocrbic acid tablet (pulverized into fine powder) Molar mass of tablet =…

A:

Q: Activity 2: Syrup   Sucrose           ___ Purified water ___ To make          30ml…

A: Sucrose   10.26 g Purified water 30 ml   Preparation of syrup depends on the physical and chemical…

Q: b. [H] = 0.01 M Standard Acid: %3D Pipette out 0.5 mL of the acid solution prepared in (a) and place…

A: Given -  (a) Acid concentration of acid standard (a) = 0.1 M  Volume is = 5 mL    (b) Now, acid…

Q: v Show Time Remaining ▼ A 0.45 M KBr solution OA contains 0.45 milliliters of KBr in 1 liter of the…

A: Molarity is defined as the number of moles of solute in 1 Liter of  the solution. Molarity of…

Q: Based on the information given, please make a CONCLUSION.

A:

Q: TRIAL 1 TRIAL 2 TRIAL 3 Mass of Vitamin C (mg) 0.011 g/ 11 mg 0.012 g/12 mg 0.011g/ 11 mg Initial…

A: Ascorbic acid + I2    gives     2 I- + Dehydroascorbic acid So, 1 mol vitamin C reacts with 1 mol of…

Q: AST ELIN nasal spray contains 0.1% azelastine hydrochloride and 125 mcg/mL of benzalkonium chloride…

A: The nasal spray contains 0.1% azelastine hydrochloride, which means 100 mL of spray contains 0.1 g…

Q: Methodology: Make schematic diagram for the procedure below B. % SO3 determination Dry the soluble…

A: We need to make a schematic diagram for the given procedure.

Q: Question attached

A: It is given that the molarity of NaOH solution is 0.100 M and volume of vinegar sample taken is 5…

Q: Table 5.1 (report)Sample DistanceFe^3+ (5.8)Co^2+ (0.8)Cu^2+ (3.0)Mixture (0.8)(3.0)(5.8)Unknown…

A: Rf value can be determined as the distance travelled by the solvent divided by its mobile phase can…

Q: If pH (± 0.5 pH units) strips were used to determine the equivalence point at pH=8.5. What is the…

A: The method you have done and all this is fine and correct. There may be some other problem like…

Q: Calculate the volume of the solution you need to take from the standard solution to prepare…

A: The method of decreasing the concentration of a solution is called dilution. The process by which a…

Q: Analytical Method Validation of 1N Sodium Hydroxide What is the result of the titration or the…

A: Sodium hydroxide is a strong base. It has a tendency to absorb water molecules from atmosphere. The…

Q: EAVY METALS determination   Lead nitrate Stock Solution— Dissolve 159.8 mg of lead nitrate in 100…

A: Solution -

Q: Observations: Table 1: Estimation of DO. SI No Volume of water Initial sample (ml) burette Final…

A: The experiment is given as follows:

Q: An unknown was found to contain 10.80 ug of analyte per liter. A spike of 4.30 ug/L was added to a…

A:

Q: Trials 1 2 Volume of aliquot of standard CaCO, solution 25.00 25.00 25.00 (ml) Volume of titrant,…

A: Given ; Volume of CaCO3 solution = 25.00 mL = 0.02500 L                             (since 1 L =…

Q: Trial 1 Trial 2 (Data Collected by (Data Collected by Group Member 1) Group Member 2) Concentration…

A:

Q: Principle: lodometry The percentage purity of cupric sulfate set by the NF is 98.5 to 100.5%…

A: Given: Concentration of sodium thiosulfate = 0.1 N

Q: IV. Problem solving A 300 mL aqueous solution containing of compound X was to be 40 extracted with…

A: Volume of aqueous solution = 300 ml Mass of compound X = 40 g Solubility of compound X in ether = 40…

Q: Assuming that the concentration of NaOH is 0.1M Analysis of acetic acid   Trial   1 2 Volume…

A: Given: Concentration of NaOH = 0.1 M

Q: Activity 2: Syrup Formula Sucrose           ___ Purified water ___ To make          30ml…

A: The activity is about preparation of a syrup containing sucrose and water.

Q: Method A: Dilute 10.00 mL up to 100 mL with a transfer pipet and volumetric flask. Then take 10.00…

A: The absolute uncertainty will be 0.1125

Q: Please help me there are multiple parts, double check your answer as previous tutors got it wrong.

A: The given illustration is the procedures for the preparation of borax solution.

Q: Trials 1 2 3 Volume of aliquot of standard CaCO, solution 25.00 (ml) 25.00 25.00 Volume of titrant,…

A: Titer for trial 1 is determined as shown below.

Q: Help on exam 1

A: Since the equation to find the Rf value is given by  => Rf  = distance travelled by spot /…

Q: Would the concentration of OH– in the solutions used for Runs 2–4 be different if deionized water…

A: The main difference between the deionized water and the NaCl solution is the lacking of ion in…

Q: Part 1: Preparation of the Primary Citric Acid Standard Mass of empty 250-mL glass beaker: 100.7g…

A: We have given that 1) Mass of empty 250-mL glass beaker = 100.7g 2) Mass of 250-mL beaker and…

Q: According to Transport Phenomena experiment, answer the following A Initial weight Final weight (mg)…

A: An equation for absorbance is: A=εcl where A is the absorbance, ε is the molar absorptivity,c is the…

Q: Experiment 11 Data to be completed and uploaded. Only one trial! (There is no part A) Part B.…

A: The reaction between oxalic acid and sodium hydroxide is, Given mass of oxalic acid = 0.1314 g…

Q: Trial 1 Mass of Sample (g) 0.127 Initial Buret Reading (mL) Final Buret Reading (mL) Volume of KMNO.…

A: Answer:- This question is answered by using the simple concept of stoichiometry which involves the…

Q: SERIAL DILUTION: PROBLEM SOLVING. Set up five (5) tubes on the test tube rack and label them 1-5.…

A: Let us consider the serum concentration to be a M

Q: Trial 1 Trial 2 Trial 3 Volume of sample 10mL 10mL 10mL Volume of added 90mL 90mL 90mL distilled…

A: % of lead in water calculated as followed.

Q: Question: Aspartame Was Measured In 3 Diet Sodas, A, B And Cusing A RP-HPLC And Following Data Was…

A:

Q: Complete the data sheet with relevant solutions in solving for the amounts needed in the experiment

A: Here we have to keep following points in mind  1. We are making homogeneous solution, in homogeneous…

Q: Standardization of EDTA Solution Weight of pure CaCO3: 0.2514 g % Purity of CaCO3: 98.0% Total…

A: Molarity of a solution is defined as the number of moles of solute present in one litre of a…