One of the problems with timeout-triggered retransmissions is that the time-out period can be relatively long. When a segment is lost, this long timeout period forces the sender to delay resending the lost packet, thereby increasing the end-to-end delay. Is there any remedy for this?

One of the problems with timeout-triggered retransmissions is that the time-out period can be relatively long. When a segment is lost, this long timeout period forces the sender to delay resending the lost packet, thereby increasing the end-to-end delay. Is there any remedy for this?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 19VE

See similar textbooks

Related questions

Q: Consider delivering a series of packets from a sending host to a receiving host along a specified…

A: Define: The delays in processing, transmission, and propagation are all constant. This is due to the…

Q: This begs the issue of why the maximum packet lifetime must be long enough to ensure that not only…

A: In this case, the maximum packet lifetime must be long enough to ensure that both the packet and its…

Q: How many packets would the receiver need to receive in order to ensure that the acknowledgements…

A: Introduction: A dependable Layer 4 protocol, TCP stands for Transmission Control Protocol. TCP uses…

Q: In a selective-reject automatic repeat request (ARQ) error control protocol, the bit error rate…

A: According to the question, we have to find the probability that it will take exactly 11 attempts to…

Q: Suppose that the roundtrip delay between sender and receiver is constant and known to the sender.…

Q: Why does the maximum packet lifetime have to be large enough to ensure that not only the packet but…

A: Explanation: The lifetime to live for a packet must be large enough to ensure both the packet and…

Q: Assume that there is a constant roundtrip delay between the sender and the receiver, and that the…

A: Introduction: The time it takes a server to process and reply to a request is a possible barrier in…

Q: c) If the propagation time were greater than the transmission delay, where is the first bit of the…

A: The answer is

Q: Once the media information reaches the receiver, it must be played out at the right time. In…

A: Problems: Difficult to find the distribution of the jitter variables. The latency added by the…

Q: It is important to keep in mind how a sequence of packets are sent from one host to another along an…

A: Transmission, processing, and propagation delays all stay constant. This is due to the time required…

Q: b) Suppose the server begins to transmit the packet at time t=0. when t= transmission delay, where…

A: The answer is

Q: Assume that the fixed path and attempt to send a packet to a host from a source to a destination.…

A: During transferring data from source to target using fixed path, below mentioned delays can occur

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring. Suppose if…

A: Explanation: The given case is of delayed token transmission, where the transmitter or sender is…

Q: Assume that the sender is aware of the roundtrip delay and that it is both constant and known to the…

A: Protocol:- The protocol is defined as the set of rules and regulations we need to follow when we…

Q: To illustrate, let's say a packet is being sent from one host to another via a defined path.…

A: NOTE :- Below i to the answer in my own words by which you understand it well. Network postpone…

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring. Suppose if…

A: Token ring:- A token ring network consists of a local area network (LAN) whereby all the computers…

Q: The probability that a packet is received in error is 0.6 in Selective Reject ARQ flow control…

A: The buffer window used by Selective Reject is the same size as the sender window.

Q: This raises the question: Why does the maximum packet lifetime have to be long enough to guarantee…

A: Here, the reason for maximum packet lifetime has to be long enough to guarantee that not only the…

Q: It is feasible to transmit a sequence of packets from one host to another using the same path…

A: Start: Delays in transmission, processing, and propagation are all constant. The time it takes to…

Q: Q: Suppose that in a sensor network measured temperatures are not times- tamped by the sensor, but…

Q: If there are x number of devices that are wanting to transmit during a slotted Aloha protocol, what…

A: ALOHA is a multiple access protocol for transmission of data via a shared network channel.

Q: A factor in the delay of a store-and-forward packet-switching system is how long it takes to store…

A: Answer

Q: delay? d) If the propagation time were less than the transmission delay, where is the first bit of…

A: The answer is

Q: Consider transmitting a packet across a specific route from a sending host to a receiving host. In…

A: The end-to-end delay indicates the time necessary to transport data from a source to a destination…

Q: Channel utilization with pipelining. Suppose a packet 10K bits long, the channel transmission rate…

A: Transmission time = L/B = 10K/10Mbps = 1ms Round trip time = 10ms Round trip time = 2*Propogation…

Q: Assume that there is a constant roundtrip delay between the sender and the recipient, and that the…

A: Introduction: Consider the RDT 3.0 protocol, which is used to securely convey data from a sender to…

Q: Suppose that the roundtrip delay between sender and receiver is constant and known to the sender.…

A: Timer necessary in protocol Here the roundtrip delay between the sender and receiver is constant.…

Q: Consider the Go-Back-N (GBN) and Selective Repeat (SR) protocols with a sender window size of 4 and…

A: ANS: - There is a slight difference between Go-Back-N(GBN) and Selective Repeat protocol, that is: -…

Q: Give an example of how nonpreemption in the implementation of fair queuing leads to a different…

A: please check the solution below

Q: Two TCP entities communicate across a reliable network. Let the normalized time to transmit a fixed…

A: Given: The normalized time to transmit the fixed length segment = 1unit End-to-end propagation delay…

Q: Consider a stop-and-wait protocol where the channel does not corrupt any packets (no bit errors) but…

A: Below is the complete explanation about stop-and-wait protocol with delay of packets (or)…

Q: Assume that the sender is aware of and experiences a constant roundtrip delay with the recipient. Is…

A: Reliable Data Transfer The web network layer furnishes just best-exertion administration with no…

Q: Take two hosts, A and B, linked by a single R bps connection. Assume that both hosts are separated…

A: The problem is solved assuming that both hosts are separated by meters and suppose that the…

Q: The media material must be played out at the appropriate moment once it reaches the recipient.…

A: Given that: The topic is about The media material must be played out at the appropriate moment once…

Q: In this problem you will be doing some elementary calculations of transmission and propagation…

A: Transmission delay= length of packet/bandwidth = 2KB/2.1 Mbps => 2*1024*10-6 /2.1 => 0.975 ms…

Q: Suppose that the roundtrip delay between sender and receiver is constant and known the sender. Would…

A: Assume that the sender and receiver have a constant roundtrip delay and that the sender is aware of…

Q: This begs the question: why must the maximum packet lifetime be long enough to ensure that not only…

A: This question explains about the maximum packet lifetime be long enough to ensure that not only the…

Q: UDP and TCP use 1s complement for their checksums. Suppose the receive received two 3-bits payload…

A: According to the question , we have to find UDP and TCP use 1s complement for their checksums by two…

Q: Consider two hosts, A and B, connected by a single link of rate R bps. Suppose that the two hosts…

A: Introduction: The transmission delay (dtrans) refers to the time duration that is required to…

Q: ith timeout-triggered retransmissions is that the timeout period can be relative long. When a…

A: Аn RTО оссurs when the source is missing tоо mаny асknоwledgments аnd deсides tо tаke а time оut аnd…

Q: Consider the Stop and Wait protocol, if transmission time is 'a' at the source and propagation delay…

A: The Answer is in /below Steps

Q: Take into consideration the process of transferring a series of packets from a sending host to a…

A: The processing, transmission, and propagation delays are held to the same standard.This is because…

Q: handling the retransmitted packet for estimation timeout interval.

A: The ANswer is in below Steps

Q: In packet switching resources are allocated between the sender and receiver, then released after the…

A: What Is Packet Switching? Packet switching, unlike circuit switching, does not necessitate the usage…

Q: Assume that the sender and receiver both have a constant roundtrip delay, which the sender is aware…

A: Answer: Yes, a timer is required in the protocol rdt 3.0 even if the round trip delay time between…

Q: Consider in the SW-ARQ protocol a packet can at most be retransmitted for 5 times, before it is…

A: Automatic Repeat ReQuest (ARQ): Systems which robotically request the retransmission ofmissing…

Q: Consider the Go-Back-N (GBN) and Selective Repeat (SR) protocols with a sender window size of 4 and…

A: Note: As you have asked a multipart question, as per our policy we will solve the first three parts…

Q: Could this scheme protect against an malicious attacker that can intercept and inject into the…

A: This attack is known as Man in the Middle Attack It is a sort of snoopping assault, where…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

One of the problems with timeout-triggered retransmissions is that the timeout period can be relative long. When a segment is lost, this long timeout period forces the sender to delay resending the lost packet, thereby increasing the end-to-end delay. Is there any remedy for this?
It is feasible to transmit a sequence of packets from one host to another using the same path between the two hosts. Please enumerate the various components of the end-to-end delay for a single packet. Is one of the delays going to be a set amount of time, while the other one has a more fluid duration?
For the sake of this example, let us assume that a packet is being sent from its origin to an address at the other end of the network through a fixed path. The following are other reasons for lateness: How long do the majority of total delays last, and what proportion of total delays are time-dependent?
Assume for the sake of this example that a packet is being sent from a source to an address at the other end of the network via the fixed route. List all the delays' varied causes as well: How many delays are roughly time-dependent and how many are roughly continuous for how long?
It is important to keep in mind how a sequence of packets are sent from one host to another along an established route. Please give a list of the delay components that make up the total end-to-end delay of a single packet. To what extent are any or all of the delays predetermined?
The same route may be used to send several packets from one host to another. Explain in detail the numerous factors that contribute to the total time it takes for a single packet to travel from beginning to finish. Can we expect one of the delays to last a certain period of time and the other to last less stably?
To ensure the quality of service, especially for multiple applications, regulating the rate at which packets are sent to the network is an important strategy. The leaky bucket is just one of such mechanisms. A flow of packets is said to conform to the leaky bucket specification (r, b), where r is the average rate and b is the burst rate, if the number of packets arriving at the leaky bucket is less than r*t + b in every time interval of t. What is the implication of that? What will happen if the number of packets arriving at the leaky bucket is equal to or greater than r*t + b?
In this example, assume that the fixed path is used to transport a packet from a source to an address at the other end of the network. List the many components of delay as well: Approximately how many delays are continuous for how long, and approximately how many are timedependent?
Consider the transmission of a packet from one end system to another. Each of the four categories of delays that a packet may encounter should be thoroughly described.
It is theoretically feasible for two hosts to communicate with one another by sending packets back and forth over the same connection. Please enumerate all of the components that are responsible for the overall amount of time required to process a single packet, starting to end. Is it to be anticipated that one of the delays will continue for a certain amount of time, while the duration of the other delay will be more unpredictable?
Assume a constant round-trip delay between the sender and receiver, and that the sender is aware of this delay before starting. Due to the probability of packet loss, is a timer still necessary in protocol rdt 3.0? Explain.
In a selective-reject automatic repeat request (ARQ) error control protocol, the bit error rate (BER) is assumed to be BER= 10 ^-8 and the frames are assumed to be 1000 bits long. The probability that it will take exactly 11 attempts to transmit a frame successfully is: (a) 0.99 (b) 99x10 ^-22 (c) 10x10^ -6 (d) 1000x10 ^-5 The probability of receiving a frame in error is approximately: (a) 10^ -3 (b) 10^ -5 (c) 10^ -6 (d) 10^ -2