Part B Reset the PHET simulation (using the button in the lower right) and set it up in the following manner select Oscillate, select No End, and use the parameters in parentheses by sliding the bars for Amplitude (1.00 cm), Frequency (2.40 Hz). Damping (none), and Tension (highest). Using the available Rulers, calculate the frequency of a photon that corresponds to the wavelength of the resulting wave. Assume the length with units (cm) of the ruler represents the real photon wavelength and that the speed of light is 3.00 x 10" m/s Express the frequency in hertz to two significant figures. > View Available Hint(s) Ozv DA frequency Hz Submit Request Answer

Part B Reset the PHET simulation (using the button in the lower right) and set it up in the following manner select Oscillate, select No End, and use the parameters in parentheses by sliding the bars for Amplitude (1.00 cm), Frequency (2.40 Hz). Damping (none), and Tension (highest). Using the available Rulers, calculate the frequency of a photon that corresponds to the wavelength of the resulting wave. Assume the length with units (cm) of the ruler represents the real photon wavelength and that the speed of light is 3.00 x 10" m/s Express the frequency in hertz to two significant figures. > View Available Hint(s) Ozv DA frequency Hz Submit Request Answer

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter25: Instruments For Optical Spectrometry

Section: Chapter Questions

Problem 25.1QAP

See similar textbooks

Similar questions

A light beam (λ=325 nm) is shined on a certain metal surface. If the workfunction (ϕ) of this metal is 8.27 x 10^-20 will an electron eject upon light irradiation? Report all your results by using significant figures and use dimensional analysis.
The percent transmittance (%T) is defined as: %T = (I/Io)*100. What does I stand for? Select one: a. intensity of emitted light by the pure solvent; b. intensity of light transmitted through the sample; c. intensity of emitted light by the sample; d. intensity of light transmitted through the pure solvent; e. all options are incorrect;
Why are wavlength maxima different for UV-Vis and Fluorescence?
Complete the table by calculating Delta ease and wavelength for all transitions indicated using the following equation Also correction the given 93kj and 1232 nm should be 1286 nm!!
Can you think of a situation in which a UV spectrophotometer would be more useful visible light spectrophotometer?
Could a percent transmittance reading of 0.00 be used in calculations.? Yes or no and explain why.
the transmittance concentration pairs could have been used to determine a calibration curve. state at least one important problem associated with such a calibration curve
An absorption measurement with a 1 cm path length yields a reading of 0.004 absorbance units with a noise of 0.001 absorbance units and a mean noise reading of 0 for 10 scans averaged together. Assuming the noise for a single scan does not change if the path length is increased to 6 cm and the number of scans is increase to 100, what is the signal to noise of the new measurement.
A He-Ne laser has a gas discharge temperature of 400 k. The atomic mass of Ne (which is responsible for lasing) is 3.35*10^-26 kg. if lasing wavelength is 630 nm, calculate the lineshape broadening due to doppler effect. * solve this question again baring in mind that the result is lambda = 0.002 nm , so the shift is 630 nm +/- 0.002 nm
Draw and label a schematic of an ICP-OES spectrophotometer. Briefly (point form is acceptable) explain the purpose or function of each component
A reflection diffraction grating has 1294 grooves per mm, and 13.4 mm of illuminated area. What must be the separation (in nm) of two first-order spectral lines centered at 625 nm if they are to be resolved? (Answer should be to 4 decimal places)
The drug pentobarbital is a sedative. It was extracted from a urine sample during a particular ultraviolet-visible spectrophotometric forensic analysis procedure. The extraction solvent was evaporated and the residue reconstituted in a small volume of the transparent solvent methanol. The pentobarbital solution thus obtained had a percent transmittance (%T) of 91 at the relevant wavelength of maximum absorbance. If the urine analyte concentration were halved, what would its percent transmittance be? (You may assume that the Beer-Lambert law holds). Can you show all the steps of the solution