pike recovery and detection limit. Species of arsenic found in drinking water include AsO32 3 (arsenite), AsO32 4 (arsenate), (CH3)2AsO2 2 (dimethylarsinate), and (CH3)AsO22 3 (methylarsonate). Pure water containing no arsenic was spiked with 0.40 mg arsenate/L. Seven replicate determinations gave 0.39, 0.40, 0.38, 0.41, 0.36, 0.35, and 0.39 mg/L.15 Find the mean percent recovery of the spike and the concentration detection limit (mg/L).

pike recovery and detection limit. Species of arsenic found in drinking water include AsO32 3 (arsenite), AsO32 4 (arsenate), (CH3)2AsO2 2 (dimethylarsinate), and (CH3)AsO22 3 (methylarsonate). Pure water containing no arsenic was spiked with 0.40 mg arsenate/L. Seven replicate determinations gave 0.39, 0.40, 0.38, 0.41, 0.36, 0.35, and 0.39 mg/L.15 Find the mean percent recovery of the spike and the concentration detection limit (mg/L).

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter33: Automated Methods Of Analysis

Section: Chapter Questions

Problem 33.5QAP: Give the advantages and disadvantages of sequential injection analyzers compared to traditional flow...

See similar textbooks

Similar questions

You are given a container with Na3PO3 that is reportedly contaminated. You are asked by your supervisor to determine the percent purity of that sample in order to know the next measures to be taken by the plant. The following are the procedures that you need to do: a. Dissolve sample weighing 1 g in 35 mL water. b. Prepare solution with 45 mL 3% w/v HgCl2, 30 mL 10% w/v C2H3NaO2 and 10 mL CH3COOH. c. Digest sample then filter then rinse the precipitate that weighs 0.2857 g. d. Compute for the % purity.
Concentration=2.5 X 10^3 μM OD400nm=0.859 1cm cuvette is used what is the extinction coefficient (μM^-1 cm^-1)
25 ml of pickled brine was taken from an apple pickled with vinegar and diluted to 500 ml, 25 ml of this was taken and acidity was determined with 0.2 N (Factor: 1.05) NaOH. In the main trials, 6.3 ml - 6.5 ml - 6.9 ml, respectively, 0.1 ml base was used in the analysis without using the sample.For example, how many ppm is its acidity?
A 0.0200 gram blood sample was decomposed by a microwave digestion technique followed by dilution to 100.0 mL in a volumetric flask. Aliquots of the sample solution were treated with a lead complexing reagent and water as follows: Solution 1: 10.0 ml blood sample + 20.0 mL complexing agent + 30.0 mL H20. Solution 2: 10.0 ml blood sample + 20.0 mL complexing agent + 26.0 mL H20 + 4.00 mL of 78 ppb Pb2+ standard. The resulting solutions were analyzed by UV/Vis at 375 nm. Absorbance for solution 1 = 0.155 and for solution 2 = 0.216. Calculate the concentration of lead (ppb) in the original sample.
Which of the following would result in an increase in the calculated ngas 10, assuming the rest of the parameters are held constant? I. Inserting 23.0 mg instead of the prescribed 15.0mg of folded Mg ribbon into the eudiometer. II. Performing the experiment in a different laboratory with a cooler temperature. III. A shorter equilibration time prior to volume measurement. IV. Acid used was 12.0 M HNO3 instead of 6.0 M HCI.
Preparation of 0.25N NaOH Objective: Apparatus and Materials: Procedure : Calculate the exact mass of NaOH needed to prepare 1.0L of 0.25N NaOH for standardization. Show your computations. Using the triple beam balance, weigh the desired amount of NaOH. Place the weighed amount of NaOH into the 500 mL volumetric flask and add distilled water until it reaches the mark. Agitate and transfer the solution into the reagent bottle. Add again distilled water to the same volumetric flask until it reaches the mark and pour it to the same reagent bottle, thus having a total volume of 1.0 L. Label the reagent bottle, 0.25N NaOH. Data and Computations: Conclusion:
Tim is interested in analyzing for Pyraclostrobin (pesticide) in strawberries using QuECHers method for extraction and clean up before analysis with HPLC-uv. The concentration of the Pyraclostrobin in the fruits that he sampled is thought to be between 1-10 ng pesticide per g fruit fresh weight. The HPLC-uv instrument he is using has a LoQ of 5 ppb for Pyraclostrobin. Tim is starting out with 500 mg of the sliced fruit
analyte concentration(C)(mg/ml) injection volume (ul) elution time (time) peak DAD signal(mAU) caffeine 1 1 4.67 302.85 aspartame 5 1 7.53 15.83 benzoic acid 1 1 8.14 89.98 saccharin 1 1 1.91 84.86 mixture(add everything above with 1:1:1:1 ratio) 1 4.47 69.58 How to get the concentration of the mixture in this case?
You are provided with a stock standard with a concentration of 100 mg/L, and a solution of unknown concentration. Prepare calibration standards using a 10 mL volumetric flask and a 1 mL piston pipette, and measure on the UV/Vis spectrophotometer (400 nm). Determine the concentration of the unknown after a 1:40 dilution, and provide the concentration of the initial solution. i need to learn how to do the calculations and draw a calibration curve to find concentration of unknown sample after i find the absorbances.
use analytical separation and analyses to outline analytical separation method protocols that can be employed to recover extremely high deposit of heavy metals and particulate matter in the river making wholesome for drinking in illegal mining communities .
An analyst determines the Cl^- content of rain water with ion chromatography. The data for the calibration line in the range 5 to 50 milli equivalents per liter (mEq/L) is shown in the table below. Additionally, a blank sample was analysed 5 times and the following results obtained: 1.1, 0.5, 0.1, 0.9 and 1.2 ppm Ct Calculate the detection limit (DL) for the method with a 98.3% confidence level. Use ALL data and show equations
Describe an electrochemical sensor assay method for rapid bacterial detection and identification.What are the principles and mechanisms involved?