Answered: Proof that the energy stored in the…

Science

Physics

Proof that the energy stored in the compact bone is given by E = AL0 (Sb) ^ 2 / 2γ. When Sb is bone stress. *

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter9: Dynamics Of A System Of Particles

Section: Chapter Questions

Problem 9.16P

See similar textbooks

Related questions

Q: A 61 cm long copper wire is clamped at one end and a stone weighing 2.2 kg is attached to the other…

Q: our biceps muscle is attached to your elbow by the distal biceps tendon. An average adults tendon…

Q: Draw the shear and moment diagram for the beam shown and find the maximum moment. 7N A B, C 6m 4m

Q: 1. A force F passing through points A and B shown in the figure has a counter-clockwise moment of…

Q: One end of a steel wire of length 0.2 m and radius 2 x 10-m is fixed. If the work done in wisting…

Q: 2. The force (not just its magnitude) due to a solid body being compressed/stretched in the…

A: A bar is subjected to a Force F bar has cross section area A and length L.⇒ Suppose during the…

Q: For elastic objects, the amount of elastic potential energy is directly proportional to the…

Q: Corda Peso

Q: An athlete strengthens her leg and knee by doing "leg curls." While sitting on a bench with the leg…

Q: 7. A rotating wheel ring has a mass density of 7850kg/m^3. At what angular velocity will the stress…

A: Centripetal force (CF) is given by the formula CF = mω2 x where m=ρV =ρ×area×periphery=ρAπRx=2Rπ

Q: A boom AC 20 m long supports a load of 11760 N s shown. The cable BC is horizontal and 10 m long.…

Q: A wire of length L, Young’s modulus Y, and crosssectional area A is stretched elastically by an…

Q: You’ve conducted tensile testing of the aorta and constituent proteins with the results show below.…

A: Answer

Q: There is a small but appreciable amount of elastic hysteresis in the large tendon at the back of a…

A: The elastic hysteresis is behavior of an elastic material while regaining its shape when the…

Q: 2. A human biceps(upper arm muscle) may exert a force of the order of 600N (about 135 Ib) on the…

A: Tensile stress is defined as the force per unit area produced in the body as a result of an…

Q: A 0.900 m-long metal wire has a circular cross section of diameter 0.950 mm. One end of the wire is…

A: Write the expression for young’s modulus.

Q: A marble column with a cross-sectional area of (2.70x10^1) cm² supports a load of (5.500x10^4) N.…

Q: Review Problem. A 36.0 kg hammer strikes a steel spike 2.20 cm in diameter while moving with speed…

Q: The rigid bars AB and CD shown in Figure below are supported by pins at A and C and the two rods.…

Q: A particular human hair has a Young's modulus of 3.31 x 10° N/m2 and a diameter of 145 um. If a 236…

Q: The figure shows an approximate plot of stress (10° N/m2) versus strain for a thread that will break…

A: Stress versus strain graph is given for a thread. the stress is plotted along y axis and the strain…

Q: A lightweight rope is wrapped around a 1780-N drum, passes over a frictionless pulley, and is…

A: Draw the free body diagram of the drum. The net force acting on the drum along x-direction is…

Q: The leg bone (femur) breaks under a compressive force of about 9.00 × 104 N for a human and…

A: Given: Force to break a human leg FH = 9 x 104N Compressive Strength (Pressure) of human…

Q: We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90 degree…

A: Here, we are required to consider the angle between the forearm and upper arm as 100 degrees. Given:…

Q: An athlete strengthens her leg and knee by doing "leg curls." While sitting on a bench with the leg…

Q: An 11.2-kg stone at the end of a steel (Young's modulus 2.0 x 1011 N/m²) wire is being whirled in a…

Q: A 1.0 m long board is suspended by two springs from a horizontal ceiling, with one spring at each…

Q: A hammer strikes a metal disk with 150N of force, temporarily making the 25.0mm3 disk lose 0.2mm3 of…

Q: Q2/ The equation of a velocity distribution over a plate is u=1/3 y - y' in which the velocity in…

Q: 10. Young's Modulus for steel is 2.1 x 1011 Pa. A steel cable will break if it is subjected to a…

A: Young's modulus (Y) = 2.1×1011 PaArea (A) = 1.5×10-5 m2Length (L) = 18 m maximum stress = 3000 MPa

Q: (III) A scallop forces open its shell with an elastic material called abductin, whose Young’s…

A: Given: The thickness of the abductin is 3.0 mm. The cross-sectinal area of the abductin is 0.50 cm2.…

Q: We analyzed the biceps muscle example with the angle between forearm and upper arm set at 90 degree…

A: r_1 = 5.0 cm, r_2 = 12 cm, r_3 = 30 cm, m_a = 2.4kg, mb = 4.2 kg.

Q: hlete strengthens her leg and knee by doing "leg curls." While sitting on a bench with the leg…

A: Given W= 225 N, D = 44 cm=0.44 md = 5.5 cm=0.055 m

Q: A continuous beam is shown below. Consider a constant EI, X= (A+B+ 5) and Y = 2(C +D+2). Support at…

Q: A bar of aluminum has a cross section of 1.0 cm × 1.0 cm and a length of 88 cm. What force F would…

Q: Only part (b) The head of a grass string trimmer has 100 g of cord wound in a light cylindrical…

A: a)

Q: accelerates at a rate of 4.2 m/s^2 when it realizes that it is hooked. You only used fishing line…

A: The tensile strength is the resistance of a material to break or undergo any deformation , here ,the…

Q: What is the compressive stress ?/?F/A on a woman's feet, in units of kilopascals (kPa)(kPa) , if the…

A: mass = 66 kg weight = 66 * 9.8 = 646.8 N weight on each foot = 646.8/2 = 323.4 N Area of each shoe…

Q: A bar of aluminum has a cross section of 1.0 cm x 1.0 cm and a length of 86 cm. What force F would…

A: Write the given data. A=1 cm×1 cm=1×10-4 m2L=0.86 m∆=1-0.86 mE=69×109 Pa

Q: 11.52 ..* A claw hammer is Figure P11.52 used to pull a nail out of a board (Fig. P11.52). The nail…

A: Here, magnitude of F1 = 400 N. Angle of the nail with the board = 60 degrees. It is given that the…

Q: The beam is made of an elastic-plastic material for which σYσYsigma_Y = 70 MPaMPa . The largest…

A: Given Data ; The stress in the beam is given as σy=70 Mpa The width of the beam is given as b =…

Q: Orb Spiders make silk with a typical diameter of 0.15mm. 1)A typical orb spider has a mass of 0.50…

A: Given:- Orb Spiders make silk with a typical Diameter d= 0.15 mm= 0.15 x 10-3 m Find:- 1)A…

Q: During a dunk, a basketball player will elevate their center of mass 70 cm (or more) while jumping…

A: Given that: h=70 cm=0.7 mm=82 kgkleg=35000 N/m∆x=0.11 m

Q: A 30.0 kg hammer strikes a steel spike 2.30 cm in diameter while moving with speed 20.0 m/s. The…

A: Given : Mass of hammer is 30.0 kg Hammer rebounds speed is 10.0 m/s

Q: A 2.50-kg uniform bar of length e = 1.30 m is held in a horizontal position by three vertical…

A: Given,

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

Proof that the energy stored in the compact bone is given by E = AL0 (Sb) ^ 2 / 2γ. When Sb is bone stress. *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A weight is connected to a spring that is suspended vertically from the ceiling. If the weight is displaced downward from its equilibrium position and released, it will oscillate up and down. (a) If air resistance is neglected, will the total mechanical energy of the system (weight plus Earth plus spring) be conserved? (b) How many forms of potential energy are there for this situation?
Your biceps muscle is attached to your elbow by the distal biceps tendon. An average adults tendon has a 6 mm by 3 mm rectangular cross-section and is 63 mm in length. A tendon has a Young’s modulus of 1.5x10^9 N/m^2. How much work must be done to stretch the length of the distal biceps tendon by 10%? Assume that the tendon is a linearly elastic material and that stretching does not alter it’s cross-section.
Answer the question in full details, thank you very much: A thin uniform rod has mass M = 0.310 kg and length L = 0.470 m. It has a pivot at one end and is at rest on a compressed spring as shown in (A). The sequence below shows that the rod is released from an angle 1 = 65.0 degrees, and moves through its horizontal position at (B) and up to (C) where it stops with Angle 2 = 105 degrees, and then falls back down. Assume friction at the pivot is negligible. Calculate the (translational) speed of the center of mass (CM) at (B) in m/s. The spring in (A) has a length of 0.118 m and at (B) a length of 0.148 m. Calculate the spring constant k in N/m.
During a dunk, a basketball player will elevate theircenter of mass 70 cm (or more) while jumping off of one leg. What is the strain energy contribution to the energy required to elevate the center of mass given the following parameters? How much energy has to be contributed by active muscle contraction? mass = 82 kg, K leg = 35000N/m, dispacement = 0.11 m.
An 1150kg automobile has springs with k = 16,000N/m. One of the tires is not properly balanced; it has a little extra mass on one side compared to the other, causing the car to shake at certain speeds. If the tire radius is 42cm, at what speed will the wheel shake most? [Sketch the scenario first]
A pendulum consists of a 2.0 m long steel wire supporting a lentil of mass 20 kg. If the pendulum is released from a position where it makes an angle of 60 with the vertical, find the difference in length of the wire when the bob is in the initial position and when it passes through its lowest position.
A 15 cm long animal tendon ( وتر ) was found to stretch 3.7 mm by a force of 13.4 N. The tendon was approximately round with an average diameter of 8.5 mm. the elastic modulus of this tendon?
A 15 cm long animal tendon was found to stretch 3.7 mm by a force of 13.4 N. The tendon was approximately round with an average diameter of 8.5 mm. the elastic modulus of this tendon?
A solid cylindrical rod BC of length L = 600 mm and radius r = 12 mm is attached to the rigid lever AB of length a = 300 mm and to the fixed support at C. Design requires that the displacement of A not exceed 10 mm when P = 700 N force is applied at A. For a material with G = 70 GPa and τall = 80 MPa what is the safety of the system under displacement and stress considerations.
A 1.25 m long cable has a diameter 3.50 mm with a Young’s Modulus, E, of 9.75 x 109 N/m2 . When the wire is placed under tension, it experiences a stress of 202.52 x 106 N/m2 , the length of the cable extends by 36.35 mm. Calculate the force that the cable experiences under tension and the strain energy density (U/V) due to deformation. Give your answers in newtons (N) to 2 decimal places for the force; and in joules per cubic metre (J/m3 ) for the strain energy density to 2 decimal places. Assume the cable is solid and the material is homogeneous.
not all the work done to pull the bowstring back is changed into elastic potential energy. why?
To measure the static friction coefficient between a 1.40-kg block and a vertical wall, a spring (k = 770 N/m) is attached to the block, is pushed on the end in a direction perpendicular to the wall until the block does not slip downward (see figure). If the spring is compressed by 0.048 m, what is the coefficient of static friction?