Q21 A PMMC instrument gives 25 mA at full scale reading when a potential difference across its terminals is 32mV. Show that how it can be used (a) as an ammeter for the current measurement in the range of 0 –3 A (b) as a 0 – 510V range voltmeter for the voltage measurement. (c) find the multiplying factor of shunt and AND voltage amplification

Q21 A PMMC instrument gives 25 mA at full scale reading when a potential difference across its terminals is 32mV. Show that how it can be used (a) as an ammeter for the current measurement in the range of 0 –3 A (b) as a 0 – 510V range voltmeter for the voltage measurement. (c) find the multiplying factor of shunt and AND voltage amplification

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Similar questions

An office building uses a bank of 63 lead-acid cells connected in series with a capacity of 80 amp-hours each to provide battery backup for their computers. The lead-acid cells are to be replaced with nickel-metal hydride cells with a capacity of 40 amp-hours each. How many nickel-metal hydride cells will be required to replace the lead-acid cells and how should they be connected?
A PMMC type voltmeter, having a full scale reading of 250 V and an internal resistance of 400 kilo ohms, is connect with a series resistance of 100 killo ohms. Calculate the sensitivity of the voltmeter.
A PMMC instrument with FSD of 100 µA and a coil resistance of 1 kQ is to be converted into a voltmeter. Determine the required multiplier resistance if the voltmeter is to measure 50 V at full scale. Also calculate the applied voltage when the instrument indicates 0.8, 0.5, and 0.2 of FSD
A PMMC instrument gives full scale reading of 25 mA when a potentialdifference across its terminals is 75 mV. Show how it can be used (a) as anammeter for the range of 0-100 A (b) as a voltmeter for the range of 0-750 V.
An inter-connect bar is used in a device designed to operate between -20℃ and 60℃. It is 0.5mm long with a cross-sectional area of 0.025 mm2 and has to carry a current of 54 µA when a potential difference of 0.5 V is applied to it. B) The bar is made from silicon doped with acceptor atoms. Calculate the concentration of majority carriers and hence that of the acceptor atoms, assuming that the contribution of the minority carriers is negligible. Determine the minority carrier concentration please solve as soon as possible
The high-voltage power supply for a television's picture tube has an open-circuit voltage of 18 kV and an internal resistance of 1.5 MQ. (a) Find the voltage at the anode of the picture tube when the anode current is 800 µA. (b) What will the anode voltage be if the anode current is increased by 50%? (c) Find the short-circuit current of the power supply
A conductor carries a current that maybe regarded as equivalent to the sum of two components, one of them being a continuous direct current of 4.2 amp and the other a superimposed half-wave rectifier current. If the latter has a maximum value of 8.3 amp, calculate the average current in the wire if (a) both components have the same direction, (b) the two components are oppositely directed?
Design rectifier circuits to provide an output of100 VDC using a.) HWR b.) Center-tappedFWR and c.) Bridge-Type FWR circuits. For each circuit, calculate the transformer peakvoltage rating, the diode PIV ratings, and thetransformer turns ratio, if power is taken fromthe 220V line ac supply
A conductor carries a current that may be regarded as equivalent to the sum of two components, one of them being a continuous direct current of 4.2 amp and the other a superimposed full-wave rectifier current. If the latter has a maximum value of 6.4 amp, calculate the average current in the wire if (a) both components have the same direction, (b) the two components are oppositely directed?
CP3: A Fally controlled single-phase bridge rectifier is supplied from a 50Hz, 230/100 * V transformer It is supplying a highly inductive load of 10Omega resistance. For a firing angle of 45, determine the rectified voltage and the rectified current.
Five years ago, when the relevant cost index was 120, a nuclear centrifuge cost $40,000. The centrifuge had a capacity of separating 1500 gallons of ionized solution per hour. Today, the boss wants to build a centrifuge with capacity of 4500 gallons per hour, but the cost index now is 300. Assuming a power-sizing exponent of 0.75, determine the approximate cost in today's dollars of the new, larger reactor
Calculate the total current of a circuit with a 9.5 V voltage source connected in series with a directly biased silicon diode and a series resistor of 440 Ω. Consider the second approximation of the diode where it is considered to be connected to a battery in series. Units of the response in milli amperes. Note: I put the original exercise in Spanish, so that it is better understood. Explain step by step, please.