Q3 Calculate the cable equation, the largest and smallest cable forces, and the smallest value of the W weight to keep the system in balance, according to the given coordinate system of the cable system given in the figure. The coefficient of friction in pulley A is µM=0.1, the coefficient of friction between the object and the surface is us=0.5. W Hs=0.5 A Hm-0.1 4 kN/m 30 m- X B 4 m +3+ 1m

Q3 Calculate the cable equation, the largest and smallest cable forces, and the smallest value of the W weight to keep the system in balance, according to the given coordinate system of the cable system given in the figure. The coefficient of friction in pulley A is µM=0.1, the coefficient of friction between the object and the surface is us=0.5. W Hs=0.5 A Hm-0.1 4 kN/m 30 m- X B 4 m +3+ 1m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the Tension in Cable "Ta" if Td=300kn.
For the cable loaded as shown. 51. Which of the following gives the value of angle ß₁? a. 36.44° b. 49.78° c. 32.45° d. 52.21° 2. Which of the following gives the tension at BC? a. 35.26 kN b. 32.25 kN c. 26.23 kN d. 20.23 kN 3. Which of the following gives the total length of cable? a. 29.48 m b. 24.26 m c. 20.26 m d. 32.21 m
The top end of vertical boot is connected by two cables having tension T1=500N and T2=1500N as shown in the figure. The third cable AB is used as a guy wire. Determine the tension in cable AB if resultant of three concurrent forces acting at A is vertical?
The 8-m-long cable is anchored to the ground at A.If z = 5 m, determine the location +x, +y of point A. Choosea value such that x = y.
A cable AB shown in Fig.P4.16 suppose a uniformly distributed load of 200 N per linear meter. Determine the maximum and minimum values of the tension in the cable, and the total length of the cable. Answers:L = 127.82 mTmin = 20149 NTmax = 25133 N
Determine the total length of cable, If y=20m. a.) 177.809 KN b.) 176.089 KN c.) 175.980 KN d.) None of the above e.) 178.908 KN
A total length of cable = 6 m is wrapped around the pulleys at A, B, C, and D. If each spring is stretched 200 mm, and The springs are un stretched when d= = 500 N/m k = 500 N/m 3m what the magnitude of mass m of each block. Neglect the weight of the pulleys and cords. when d 2 m.
Considering minor deviations and rotations;Determine the deformation of 1st cable.
Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable CD is required for static equilibrium in the position shown? What is the tension T in cable CD?
Determine the resultant force, together with its angle, of the system shown. -note:The tension exerted by the cable tied to point B is 60N and the one that reaches point C is 40N.
Problem Number 1: In the given cable carrying a horizontal uniform load of 9.5 KN/m , and point C is the lowest point inthe cable. (a) determine the maximum tension (Tmax) on the cable , (b) the cable diameter if the allowabletensile force is 750 MPa (c) Length of the cables considering the given sag.
Determine the tension in cable BD if P = 51 N.