Question 8:In half-wave rectifier, what is the output frequency if the input frequency is 50HZ. VWhatis the output frequency of a full-wave rectifier for the same input frequency

Answered: Question 8: In half-wave rectifier,…

Question 8: In half-wave rectifier, what is the output frequency if the input frequency is 50HZ. What is the output frequency of a full-wave rectifier for the same input frequency

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter17: Sound

Section: Chapter Questions

Problem 17.8CYU: Check Your Understanding What would happen if more than two frequencies interacted? Consider three...

See similar textbooks

Related questions

Q: Question 1 What is the approximate power output of the Distributed Feedback LASER? O 0.8 mW to 2 mW…

A: The distribution feedback laser used the Bragg reflection ( when the wavelength is comparable to the…

Q: For a cavity with mirrors having re:flectivities of 98%, what would the minimum gain need to be in…

A: Ans:- Image-1 Given data:Reflectivities R=98% or 0.98Amplifier length L=0.1 mmirror seperation d=0.3…

Q: In case of Krypton laser, the wavelength (£) of the laser is 647 nm and the power radiate by the…

Q: Calculate the sound velocity for a monatomic fcc crystal along (100) and (111) directions. Assume…

A: The equation for speed of sound in a monoatomic fcc is vp=CMdhklwhere,C: spring constantM: massdhkl=…

Q: What is the voltage gain in a common emitter amplifier, where input resistance is 3 2 and load…

A: Given value--- input resistance = 3 ohm. load resistance = 24 ohm. current gain = 0.6 . We have to…

Q: 2). A photon is a wave that car be absorbed or emitted by the lattice during thermal vibration and…

A: Photon

Q: Determine the number (#/cm³) of quantum states in silicon between (E,- kT) and E, at T = 300 K. (e-ɔ…

A: Solution :- Given that, Temperature T = 300 K And we know that, mp=9.11×10-31 kgwe know that for the…

Q: What are the disadvantages of a half wave rectifier?

A: A half wave rectifier is used to convert half of the cycle of alternating current to direct current.…

Q: Gallium Arsenide diode laser emits 0.9 maw of power inside a CD player. The band gap of Gallium…

Q: Using the physics terms and expressions show that the efficiency of half wave rectifier is given by…

Q: If the gain of the effective medium in a laser is (1.05), its mirror reflectivity coefficient (0.999…

Q: In case of Krypton laser, the wavelength ()) of the laser is 647 nm and the power radiate by the…

Q: Calculate the maximum permissible frequency of a crystal if you know that the mass of an atom is…

Q: The X-ray diffraction studies show that copper crystallizes in an (FCC) unit cell with cell edge of…

Q: (1) A signal m(t) band-limited to 3kHz is sampled at a rate 100/3% higher than the Nyquist rate. The…

A: question rejected under wrong subject

Q: A full wave rectifier uses a centre - tap transform whose turns ratio to half secondary is 10:1and…

Q: 9. Is the signal x(t) = exp(-t)*sin(t) periodic in nature? a) Yes b) No

A: Write down the given wave equation to determine whether it is periodic or not. Here x signifies…

Q: The distance (spacing) between the energy levels of a harmonic oscillator is: a. Decreasing with n…

A: The energy of nth level of harmonic oscillator is given by E= hf(n+1/2) where f is the frequency of…

Q: What are the advantages of inverting operational amplifier over non-inverting operational amplifier?

A: The circuit connection of inverting amplifier is shown as,

Q: Question 21 What is the approximate power output of the Distributed Feedback LASER? 0.8 mW to 2 mW 6…

A: The approximate power output of the Distributed Feedback laser is 6mW to 12 mW So option (b) is…

Q: In the case of half-wave rectifier, what is the correct answer:

A: As per the company policy, only 1st question will be answered here, please post the rest separately.…

Q: Calculate the threshold frequency of Gold with 7.8x10^-19 J Work Function.

A: The relation of the threshold frequency and the energy as φ=hν

Q: What is Poisson ratio value for different materials?

A: Poisson ratio can be defined as the ratio of a material's transverse contraction strain to…

Q: A three-level laser emits a light of wavelength of 5500 Å. What will be the ratio of population of…

A: The ratio of population of the two states can be written as N2N1=e-ΔEkT…

Q: Calculate the separation (Hz) between two consecutive modes of LASER with cavity length L = 10 cm.…

A: Given Cavity length L=10cmRefractive index=R.I =1

Q: A laser can have all these properties except: a)single color. b)glow in the dark. c)single…

A: The full form of LASER is Light Amplification by stimulated emission of radiation.

Q: The fraction of lattice points occupied by vacancies in solid aluminum at 660°C is 10-3 . What is…

A: T=660°C=660+273=933 Knv/n=10-3

Q: In analyzing the data from a spectroscopic experiment, the inverse of each experimentally determined…

A: The Balmer series is defined by the equation

Q: A laser pulse of energy 4 mJ and the pulse duration 1.5 ns is focused on a target of radius 0.02 mm.…

A: The expression for find laser intensity is I=PA=Etπr2=Etπr2

Q: In a non-inverting amplifier if the feedback resistor is equal to the input resistor, we produce a…

A: The voltage gain of a non-inverting amplifier is : Voltage gain = VoutVin=1+RfRi It is given as…

Q: Question 17 What is the approximate power output of the Distributed Feedback LASER? O 0.8 mW to 2 mW…

Q: 2. Current flows in one direction only for direct current circuits while current may flow in reverse…

Q: 5) What is the magnitude Given that U = 10 E = 5 MeX pr of the wave number k in region I or III in…

Q: A monocrystalline silicon solar panel (active area: 1m2 )has an energy conversion efficiency of 20%.…

A: Given: Active area, A=1 m2 Irradiance, Ee= 800 W/m2 Energy conversion efficiency, η=20%=0.2

Q: Calculate the sabins of absorption at 1000 Hz in a room that has dimensions of 11.00m wide x 15.00m…

A: in this question we calculate sabin by using a = S α a = sabin S = surface area of cube α =…

Q: •P24 For a certain diatomic molecule, the lowest-energy photon observed in the vibrational spectrum…

Q: transducer has the positive temperature coefficient.

A: RTD(resistance temperature detector) transducer has positive temperature coefficient .

Q: A five input summing amplifier has R1=R2=R3=R4=R5=25KΩ.What value of feedback resistor is needed to…

A: Write the given values of this problem. R1=R2=R3=R4=R5=25 k ohm

Q: Calculate the separation of the longitudinal modes of a GaAs laser, when the length of the laser is…

Q: Because of its semiconducting properties, CdSCdS is sometimes used in electronic devices. The band…

Q: The current gain of CE amplifier is 100. If input junction , while output junction resistance is 1.5…

Q: 4. What is the voltage gain in a common emitter amplifier, where input resistance is 3 2 and load…

A: Load resistance (RL) = 24 ohm Input resistance (Ri) = 3 ohm Common emitter voltage (Vce) = (BRL)/Ri…

Concept explainers

Debye Theory of Solids

In solid-state physics, debye theory is used to estimate the phonons contributing to the specific heat capacity in a solid. It explains that the specific heat is a consequence of the vibrations of the atomic lattice of the solid, which is in contrast to the Einstein model. In the Einstein model, solids are treated as independent, non-interacting quantum harmonic oscillators. This model clearly explains the low-temperature dependence of the heat capacity, which is proportional to T3. This is known as Debye T3 law.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Using the physics terms and expressions show that the efficiency of half wave rectifier is given by n = 0.406/(1+rf/Rl)
Q. (a)The signal retrieved in an optical fiber reduces at its output to one-tenth of its input power. What is the overall attenuation? What shall be the power at output in a fiber having loss3 db/km? (b)Explain why laser action cannot occur without population inversion between atomic levels?
Check Your Understanding What would happen if more than two frequencies interacted? Consider three frequencies.
For the CRO display of a pulse waveform, the time/cm is on 50ms/cm and the volt/cm switch is on 0.2V/cm. The width of one complete cycle is 3.5cm and the height of the pulse is 3.4cm. Determine a) the periodic time b) the frequency and c) the magnitude of the pulse voltage.
Because of its semiconducting properties, CdSCdS is sometimes used in electronic devices. The band gap energy for CdSCdS is 2.40 eVeV . What is wavelength of a photon with this energy?
A five input summing amplifier has R1=R2=R3=R4=R5=25KΩ.What value of feedbackresistor is needed to make it an average amplifier?
Following the analysis applied to the half-wave rectifier with capacitor filter, showhow to arrive at the output waveform for a center-tapped full-wave with filtercapacitor
UPVOTE WILL BE GIVEN! PLEASE WRITE THE SOLUTIONS COMPLETELY AND LEGIBLY. PLEASE ANSWER #2 1. Calculate the sabins of absorption at 1000 Hz in a room that has dimensions of 11.00m wide x 15.00m long x 3.50m high. The room has: a. Plasterboard (12mm(1/2") in suspended ceiling grid b. Walls are constructed of concrete blocks (coarse). c. The floor is covered with marble. 2. The absorption coefficients of the materials at 1000Hz are as follows: a. Plasterboard (12mm(1/2") in suspended ceiling grid – 0.04 b. Concrete blocks (coarse) - 0.29 c. Marble flooring -0.01 3. Compute the reverberation time (RT60) of the room. 4. Is the reverberation time appropriate for a room designed for speech? 5. As a designer, what will you recommend 5 to increase (or decrease) the reverberation time?
Q6:- (a) Using diode equation, determine the diode current at 20°C for a silicon diode with n=2, Is=0.1μA at a reverse-bias potential of -10 V. (b) Is the result expected? Why?
For the 3- input And gate, determine the output waveform in relation to the following inputs. 1) (00100100100100100)2 2) (11111111110000000)2
Write an integrated program in Fortran to calculate the Q value of the following sequence
A low-power laser used in a physics lab might have apower of 0.50 mW and a beam diameter of 3.0 mm. Calculate (a) the average light intensity of the laser beam, and(b) compare it to the intensity of a lightbulb producing100-W light viewed from 2.0 m.