QUESTION 56Short Problem: Given a series circuit comprised of the following element: 88.46-ohm resistor, practical inductor with internal resistanceof 0.69 ohm and reactance of 64.83 ohms; and a capacitor with reactance of 8.42 ohms. Compute for equivalent impedance anglein degrees.Note: Follow this reminder carefully. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle ofcalculation. Use stored values. Write the numerical values only. No units in your final answer. Spaces are not allowed. Excessivenumber of decimals as compared to the required number of decimals may result to an incorrect answer.

Answered: Image /qna-images/answer/9dae95de-13ed-4780-b532-fa732040f5fb.jpg

Short Problem: Given a series circuit comprised of the following element: 88.46-ohm resistor, practical inductor with internal resistance of 0.69 ohm and reactance of 64.83 ohms; and a capacitor with reactance of 8.42 ohms. Compute for equivalent impedance angle in degrees.

Short Problem: Given a series circuit comprised of the following element: 88.46-ohm resistor, practical inductor with internal resistance of 0.69 ohm and reactance of 64.83 ohms; and a capacitor with reactance of 8.42 ohms. Compute for equivalent impedance angle in degrees.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Related questions

Q: 1. The average power in a single-phase ac circuit with a purely capacitive load, for sinusaidal-…

Q: Three Impedances each of (8 - j22)N are connected in mesh across a three-phase 400V ac supply.…

A: According the given equation, we can make the circuit diagram shown below

Q: A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an…

A: Lossless transmission line A transmission line with no line resistance and no dielectric loss is…

Q: A resistor of 4 ohmsisconnected in parallel with an impedancecoil whose resistance and inductive…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: One needs a 100 kVAr A-connected TCR for a three-phase distribution system of 2.4 kVu, and 60 Hz.…

Q: 8991 Reactance does not vary according to the frequency. True False Impedance always expressed as a…

A: Correct option is FLASE Reactance always depends upon the frequency we have two types of reactances…

Q: The single phase load on an installation is 800 kW, 0.8 lagging power factor which works for 3000…

Q: Obtain Z for the following system 'bus

A: Given:-

Q: The sending-end voltage in the circuit seen is adjusted so that the load voltage is always 13,800…

A: Circuit diagram is given, (a) Frequency is given f = 50 Hz Minimum power dissipation is occurs when…

Q: Use nodal analysis to solve the circuit complete soolution

A: In this question, We need to determine the Use nodal analysis to solve the circuit. We know I= V/Z…

Q: A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following…

A: From the given data we have to find the (i) Voltage reflection co-efficents (ii) insulator voltage…

Q: The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm…

A: Given data:

Q: A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this…

A: Impedance: Impedance of a circuit is the combination of all the resistance as well as reactance. It…

Q: The total impedance Z, of a circuit containung an inductor with inductance L and resistance R in…

A: we need to find out R and L.

Q: Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method…

A: The electrical circuits have resistance, inductance and capacitance as their elements. In the…

Q: A series RLC circuit is connected to an AC power source, as shown in the figure. Given that the…

Q: Three branches having impedances of 3+j4 Ω, 16−j12 Ω, and−j4 Ω, respectively, are connected in…

A: Given data: Impedance Z1 = 3+j4 Ω Impedance Z2 = 16-j12 Ω Impedance Z3 = -j4 Ω The admittance of the…

Q: a 6Ω 100 N Zab -jXe j25 N b Given: The phasor circuit shown above. Required: Calculate the value of…

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac…

A: MPT theorem: This is used to find the maximum power in the load.

Q: A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following…

A: NOTE: "Since you have posted a question with multiple sub parts, we will solve first three sub parts…

Q: If the normalized admittance visible at a distance d from the load impedance is 1 - j5, how many mho…

Q: Discuss the following term in reactive circuit? a) Real power b) Apparent power G) Power factor 1.

Q: Use DFT method to compute the circular convolution of x(n)={4,4} and h(n)={2, 6}.

A: Given data, xn=4,4hn=2,6

Q: Q.5. (E3 10) State True or false a- The DC load flow study is an iterative process b- In a load…

A: Since we are allowed to solve only up to three sub parts in a question the solution below contains…

Q: A 240-Vrms, 60 Hz source skpplies two loads as shown above. Find the capacitance of a capacitor…

Q: a short three phase transmission line connected to 33kv 50 hertz generating station at starting and…

A: Write the given information from the question.

Q: TRUE OR FALSE? On the electric power grid, supply must equal demand at all times, otherwise…

A: The solution to the above question is provided in the following steps.

Q: (a) Calculate the input impedance of the infinite ladder network shown in the figure below. (Z =…

A: (a) Since, the given circuit is of the infinite length and the total impedance of the circuit will…

Q: 2. A delta-connected load with 500 resistance, 209mH inductance and 50µF capacitance in series per…

A: In this question we need to find a phase current of the given three phase circuit.

Q: , reactive and apparent power consumed by the lo

A: The given load is an RL load that means the power factor of the load is lagging in nature means the…

Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…

A: To solve above problem, one should have a basic idea about the working of AC circuits. The above…

Q: For a single phase ac voltage controller/chopper, which is designed by using thyristors, with the…

Q: R1 3 kN L1 3 mH ww C1 R3 1 kN v(t) 6 μF R2 2 kN ww

Q: Solution in phasor domain representation is a method that can both consider the steady state and…

A: A phasor is represented only for steady state Two waves are said to be in phase if the phase…

Q: In an electric power system, it is given that the effective impedance of the generator station is Rs…

Q: 15. A solenoid coil with a resistance of 50 ohms and an inductance of 250mH is connected to a…

Q: Compute the expected power factor of the circuit given the different capacitance.

Q: 4. The maximum values of the alternating voltage and current are 400 V and 20 A respectively in a…

A: The solution is given below

Q: A certain industrial load has an impedance of 0.6 angle 30 ohms at a frequency of 60 Hz. What…

A: In this question, We need to determine the value of capacitor C to decrease the total angle from 30…

Q: Determine the total equivalent impedance of the circuit as shown. Note: the student must put the…

A: In this question, choose the correct option All are parallel branches so What is equivalent…

Q: Q.5. (Ei 10) State True or false a- The DC load flow study is a linear analysis b- In a load…

A: Statement is False DC load flow equations are alzebric because they are static equations of a system…

Q: create of your own three problem set and solution for impedances and admittance.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Consider the network depicted in the following figure, and determine the equivalent impedance seen…

A: In given circuit, XL=jωL =j 34×2 =j 68 ΩXc=1jωC=1j×34×2×10-3=-j 14.70 Ω

Q: A series circuit of RLC with following parameters, R=15 ohm, L-20 m H Farad. VT=169.7 sin (337t-30)…

Q: Find the total impedance, voltage drop on the 100-ohm resistor, draw the phasor diagram of the…

A: Current and voltage always in phase incase of resistance Current lag by 90 degree with respect to…

Q: The impedance (Z) of a circuit is technically a phasor because it does not correspond to a…

Q: C. Problem Solving. Draw the circuit and show your complete solutions. 1. Given the value of a 6-ohm…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage Vr and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60 Hz, R = 10 ohms, Vcoil = 22.4 V, Vr = 20 V and V = 36V. Calculate Xl and Xc
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage VR and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60Hz , R = 10 ohm Vcoil = 22.4 V. VR = 20 V and v = 36v , find the resistance and inductance of the coil.
. At a 12.47 kV (line to line) distribution system the communication interference (CI) was observed due to 5% of 5th harmonic currents generated by a 3000 kVA arc furnace. In order to avoid CI it is required to convert an existing 600 kVAr capacitor to 5th harmonic filter considering the total kVAr should not exceed 135%. Calculate the following: (i) Capacitor reactance (ii) Reactance of the series reactor (iii) Fundamental frequency current (iv) 5th harmonic frequency current (v) Tuned frequency voltage (vi) Total rms current (vii) Fundamental frequency voltage (viii) Voltage (rms) across the capacitor bank (ix) Check whether the filter kVAr rating is within limit? (x) Comment how the existing capacitor bank is converted to filter
Briefly explain about a) Primary transmission b) Secondary transmission c) Primary distribution d) Secondary distribution
circuits 42 43
Calculate the value of lx using source tranformation theorem.
When an impedance coil is connected to a 114 volt 60 cps source, the current is 3 A. If the current rises to 4 A when a 116 volt 25 cps is is impressed across the coil, determine the values of the resistance and inductance of the coil.
Use nodal analysis to solve the circuit complete soolution
Which of the following capacitors could be used to replace a 188-microfarad, 250-volt starting capacitor? Select one: A. 188 MICROFARAD, 120 VOLT B. 259 MICROFARAD, 120 VOLT C. 200 MICROFARAD, 250 VOLT D. 300 MICROFARAD, 250 VOLT
Given a series circuit comprised of the following element: 68.13-ohm resistor, practical inductor with internal resistance of 0.34 ohm and reactance of 47.15 ohms; and a capacitor with reactance of 7.53 ohms. Compute for the magnitude of its equivalent impedance in ohms. Do not round off during computation. final ans 4 decimal places
WILL SURELY GIVE AN UPVOTETOPIC: AC MACHINE INSTRUCTIONS Please write clearly and understandable wayWrite all the corresponding Given with their corresponding symbols and unitsSolve in step-by-step, no shortcut (I need to learn as a beginner)Underline twice the Final Answer PROBLEM:A single-phase transformer has a voltage ratio on open-circuit of 3300/660-V. The primary and secondary resistances are 0.82 and 0.03 respectively, the corresponding leakage reactance being 4 2 and 0.12 0. The load is equivalent to a coil of resistance 4.8Q and inductive reactance 3.60. Determine the output of the transformer in kW.a. 54b. 108c. 63d. 27
An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henryis connected in series with a variable capacitor. If a 117 volt 60 cps source isconnected to the circuit, what will be the capacitance of the capacitor and the current(a) when the circuit has a power factor of 0.866 leading and (b) when the voltagedrop across the coil is equal to the voltage drop across the capacitor?