how your reasoning in describing what would be the effect on the calculated equilibrium constant for each of the following mistakes. Your buret was not rinsed with NaNCS solution before use and still contained traces of distilled water. The spectrophotometer was set well-past infinite absorbance upon calibration with the sample holder empty.

how your reasoning in describing what would be the effect on the calculated equilibrium constant for each of the following mistakes. Your buret was not rinsed with NaNCS solution before use and still contained traces of distilled water. The spectrophotometer was set well-past infinite absorbance upon calibration with the sample holder empty.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter90: High-performance Liquid Chromatography (hplc)

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The label is a reagent to which he had specified on the label only the alcohol name and molecular formula of the same which was C4H10O. At the beginning of the experiment, about 50 mg reagent was diluted in deuterated chloroform with standard internal TMS and then added a specific vial (tube) for analysis of 1H and 13C spectra. When operating the equipment and ending the experiment, the teacher of discipline two being a spectrum of each 1H and one of 13C, and requests that they indicate which structure was responsible for those chemical spectra. Do you know those hired to the students who are here, qualify the structure of the referred responsible for the set of 13C and 1H spectra, as requested by the teacher. Figure 1: 1H spectrum of the unknown Figure 2: 13C spectrum of the unknown reagent
You have carried out an experiment using the spectrophotometry concept. A solutioncontaining compound X is mixed with reagent 1 and then reagent 2. This mixture produces ablue colour whose absorbance (A) could be read at 550 nm. The results are shown below If the standard solution (compound X) used have a concentration of 1 mM: 5. What is the reason for using test tube no. 1 in the table above? Can it be replaced withdistilled water?
It's important to mark the solvent front with a pencil after the plate is finished being developed in order to calculate an Rf. Group of answer choices True False
1. Discuss the importance and precautions in using glass cuvettes. 2. Explain in your own understanding the principles of UV-Vis Spectrometer.
Explain results for nitrous acid-observation, hinsberg test-observation and infrared and name unknown.
Following the experimental procedure, a student combined 5.00 mL of 0.0020 M Fe3+ and 1.00 mL of 0.0020 M SCN- with 4.00 mL of water to create their Trial 1 solution. The student used their spectrophotometer to measure the absorbance of the reaction mixture and recorded an absorbance of 0.095. Find the following: Hint: The extinction coefficient of FeSCN2+ is 4,630 M-1*cm-1 and the cuvettes we use have a path length of 1.0 cm. The equilibrium concentration of Fe3+: M (give as decimal to nearest 0.000 001 M) The equilibrium concentration of SCN-: M (give as decimal to nearest 0.000 001 M) The equilibrium constant K: (give to nearest tens place)
Give a detailed procedure of how you will process 5 samples of palm oil adulterated with Sudan IV dye before analysing it with Raman spectroscopy. Name and state the functions reagents used in the sample processing.
By using an illustration, show the general steps on the proper use of IR spectrophotometer.
Describe how to prepare adulterated palm oil samples before analysing it with Raman spectrometer. Also the describe the process how the Raman spectrometer will analyze the adulterated palm oil samples
A 50.0 mL juice extract is colorimetrically assayed using Nelson’s test. One milliliter (1.00 mL) of the solution and the standard glucose solution (concentration: 1mg/mL) were treated with freshly prepared Nelson’s reagent and arsenomolybdate reagent and then diluted to 10.0 mL separately in properly labeled test tubes. Absorbance at 480 nm for the standard is 1.702 and for the sample, 0.926. A. What is the principle behind the assay? B. Calculate the concentration of the reducing sugar in the 50.0 mL sample in mg/mL. Apply Beer-Lambert’s law.
A 50.0 mL juice extract is colorimetrically assayed using Nelson’s test. One milliliter (1.00 mL) of the solution and the standard glucose solution (concentration: 1mg/mL) were treated with freshly prepared Nelson’s reagent and arsenomolybdate reagent and then diluted to 10.0 mL separately in properly labeled test tubes. Absorbance at 480 nm for the standard is 1.702 and for the sample, 0.926. A. What is the principle behind the assay? B. Calculate the concentration of the reducing sugar in the 50.0 mL sample in mg/mL. Apply Beer-Lambert’s law: A=bc
A 50.0 mL juice extract is colorimetrically assayed using Nelson’s test. One milliliter (1.00 mL) of the solution and the standard glucose solution (concentration: 1mg/mL) were treated with freshly prepared Nelson’s reagent and arsenomolybdate reagent and then diluted to 10.0 mL separately in properly labeled test tubes. Absorbance at 480 nm for the standard is 1.702 and for the sample, 0.926. A. What is the principle behind the assay?