Sn3(PO4)2 solution is to be subjected to argentometric titration, a) Write the balanced titration reaction. (products are Ag3PO4(s),, other ions are spectator ions b) Write the stoichiometric relationship (fundamental eqn) between the titrant (AgNO3) and the titrand (Sn3(PO4)2.   c) Is this a feasible titration technique? Why?

Q: Sometimes it is not possible to indicate the end point of a titration. a) How can one proceed then…

A: The question is based on the concept of titrations. it is a volumetric technique to determine the…

Q: A solution containing a mixture of metal cations was treated with dilute HCl and a precipitate…

A:

Q: The concentration of cyanide,CN- , in a copper electroplating bath can be determined by a…

A: According to the mole concept, in terms of mass, the amount of substance in moles is equal to the…

Q: The surface water of a lake is at pH = 7.9 and contains 10-29 M dissolved inorganic carbon (i.e.,…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 0.2219 g of pure iron wire was dissolved in acid nd iron reduced to+2 state. Then the solution…

A: In a redox reaction, one reactant is oxidized by releasing the electrons and another reactant is…

Q: A 1.200-g sample of a mixture of NaOH (FW 40.00 g/mol) and NayCO3 (FW 105.99 g/mol) with inert…

A: The reaction between acid and base is termed as neutralization reaction. The products are salt and…

Q: Write a balanced net ionic equation to show why the solubility of Zn3(PO4)2 (s) increases in the…

A:

Q: A sample of solid Ca(OH)2 was stirred in water at a certain temperature until the solution contained…

A: a) from the molarity eqution , M1V1 = M2V2 , we have M1 x 84.3 ml = 2 x 64.6ml x  0.0948  M M1 =…

Q: If the molar solubility of Mg3(PO4)2 at 25 oC is 6.26e-06 mol/L, what is the Ksp at this…

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: a.) What is the precipitation pH in gravimetric sulfate determination? Why is precipitation not done…

A: a) Sulfate is gravimetrically determined by using barium chloride solution.

Q: Identify the type of coprecipitation that occurred in the following situation. (a) The…

A: answer - (a) The precipitation of bulky precipitates (e.g. MgNH4PO4) traps significant amount of the…

Q: A 55.00 mL solution of 0.3900 M AgNO, was added to a solution of Aso " . Ag, AsO, precipitated and…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The arsenic in a 1.010 g sample of pesticide was converted to H3ASO4 by appropriate means. The acid…

A: Molarity is defined as moles of solute upon the volume in litre

Q: A sample of soluble salt weighs 1.2 g and contains chloride, bromide and iodide. With AgNO3, a…

A: To Calculate the approximate percentage of chlorine, bromine and iodine in the sample

Q: In order to adjust the Potassium Permanganate solution, 0.0544g Na2C2O4 was taken and necessary…

A: 2 moles of potassium permanganate reacts with 5 moles of oxalate.

Q: If 1.000 ml. of a solution of KMn04 is equiva- lent to 0.1000 millimole of NaCHO2 (sodium formate)…

A: Oxidation number : The number that depicts the amount or number of electrons lost or gained by an…

Q: A 55.00 mL solution of 0.3900 M AGNO, was added to a solution of AsO. Ag, AsO, precipitated and was…

A: Given. the AgNO3 solution is 55 ml or 0.055 L of 0.39M or 0.39 mol/L moles of Ag in the given…

Q: Chrome then curiously asked Senku if it was possible to titrate the pure KHA. H2A2H;O sample through…

A:

Q: In a precipitation titration of 46.00 mL of a chloride solution of unknown concentration, 31.00 mL…

A: In  precipitation titrations, the stoichiometric reaction is a reaction which produces in solution a…

Q: Compare the molar solubility of Mg(OH)2 in pure water with that in a solution buffered at pH 9.00.

A: The dissociation of Mg(OH)2 is Mg(OH)2 s⇋Mg2+ aq+ 2OH- aq. For pure water: Ksp = (s)(2s)2 =…

Q: arsenic in a 1.010 g sample of pesticide was converted to H3ASO4 by appropriate means. The acid…

A:

Q: A volume of 50 mL of 1.8 M NH3 is mixed with an equal volume of a solution containing 0.95 g of…

A: The concentration of Mg2+ ion in the resulting solution of 100 mL is;…

Q: A saturated solution of magnesium hydroxide is prepared and the excess solid magneisum hydorixed is…

A:

Q: During the titration of an HClO4solution with 0.10320M NaOH, a CHEM 3A student,Juan becamedistracted…

A: Answer: In this question we are titrating the acid against base where concentration of base is known…

Q: accordingly

A: Mass of Na2C2O4 = 0.0585 g Molar mass of Na2C2O4 = 134 g/mol At equivalent point,  Geq. of KMnO4 =…

Q: In iodimetry as a titrant is used: I solution; Na,S2O3 solution KI solution; KIO; solution;

A: The titrant used in the iodimetry is I2 solution.

Q: Using basic conditions, MnO4- can be used as titrant for the analysis of Mn2+, with both the analyte…

A: A question based on quantitative analysis, which is to be accomplished.

Q: The % w/w in a 0.6712-g sample was determined by Volhard titration. After adding 50.00 mL of 0.05619…

A:

Q: The potential at equivalence point of the following titrations will be dependent of the pH of the…

A: Potentiometric titration is another titration  method where potential difference of analyte is…

Q: 2. The Department of Environment and Natural Resources is collecting samples of air around the urban…

A: Volume of air sample = 3.0 L Volume of Ba(OH)2 = 50 mL Molarity of Ba(OH)2 = 0.0116 M Molarity of…

Q: What is the iron(II) ion concentration in a solution prepared by mixing 329 mL of 0.411 M iron(II)…

A: We have to find iron concentration

Q: dentify the buffer capacity of the solution by titration using 0.250 M NaOH. Calculate the buffer…

A: Buffer is a solution that resists the change in pH when one mol of acid or base is added to it. It…

Q: 50 cm3 of 0.05 M weak acid solution is titrated with 0.1 M NaOH solution. The measured pH values are…

A: Given: Volume of weak acid = 50 cm3 Concentration of weak acid = 0.05 M Concentration of NaOH = 0.1…

Q: The level of dissolved oxygen in a water sample can be determined by the Winkler method. In a…

A:

Q: An aqueous ethylene glycol (HOCH, CH, OH, FW = 62.07 g/mol) solution with a mass of 220.9 mg is…

A: Answer: mass percent= 8.15 %

Q: If 1.000ml of a solution of KMnO4 is equivalent to 0.1000mmol of sodium formate (HCO2Na) in the…

A: Oxidation number :  The number that portrays the sum or number of electrons lost or picked up by a…

Q: Use the References to access important values if needed for this question. Write a balanced net…

A: Zn3(PO4)2 contains a basic anion so its solubility increases in the presence of strong acid.…

Q: Make a complete schematic diagram for the precipitation separation and identification of group lll…

A: We have to make the schematic diagram for the precipitation separation and identification of group…

Q: A lake has a pH of 6.35 and a measured alkalinity of 5.0 x 10-3 eq/l. What is the concentration of…

A:

Q: A saturated solution of magnesium hydroxide is prepared and the excess solid magneisum hydorixed is…

A:

Q: What is the acid/base ratio? Why is it important in the titrimetric process?

A: Acid base ratio is the exact amount of acid and base required to obtain a desired pH. This value can…

Q: How to qualitatively search for NO3- and NO2- in the presence of Br- anion? Explain with reaction…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The amount of iron in a meteorite is determined by a redox titration using KMnO4 as the titrant. A…

A:

Q: Identify the differences between a primary and secondary standard in titration process? state…

A: Titration: it is common laboratory method of quantitative chemical analysis to determine the…

Q: Please answer the following question: Suggest a strategy using selective precipitation (which salts…

A: The cations have a notable electron deficiency and are produced by the removal of electrons from the…

Q: A 1.200-g sample of a mixture of NaOH (FW 40.00 g/mol) and Nancog (FW 105.99 g/mol) with inert…

A:

Q: A sample of solid Ca(OH)2 was stirred in water at a certain temperature until the solution contained…

A: Solubility product is a product of the concentration of ions with the power when the solution is…

Potentiometric Titrations

Potentiometric titration is one of the important titration methods and is mainly carried out to characterize acid solutions. It follows a method similar to that of the normal titration technique, but the main difference is that there is no indicator used in the potentiometric titrations. Instead of using an indicator, electrodes are employed for monitoring the whole titration process. A scientist named Robert Behrend did the potentiometric titration for the first time, and it was done using the mercurous solution and potassium chloride.