solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What is the % purity of the sample to the nearest whole number?

solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What is the % purity of the sample to the nearest whole number?

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. a. How many moles of CO2 were collected? b. What is the percent purity of the sample? Round off to the nearest whole number
The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What CASE does this experiment satisfy?
A powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr.What is the %purity of the sample to the nearest whole number?
To each digestion flask 200 mL aliquots of 10 different drinking water samples were added. Silver was extracted by a co-precipitation procedure and collected by filtration. The precipitate was digested in 200 μl hot concentrated nitric acid and diluted to 5 mL in a dilute phosphate solution. Standards were prepared according to the following table. The samples were analyzed by graphite furnace AAS. Calculate the concentration of silver in each sample. Are there any problems? How will you address each of the identified problems?
A concentration of toxic metals in plant tissue is often found by combusting the material in a furnace and then dissolving the ash in concentrated acid. A 0.5124-gram sample of leaves was combusted to ash and transferred to a 150-mL beaker. A 25-mL portion of concentrated HCl was added and the mixture was heated on a hot plate. Three 5-mL portions of concentration HCl were added over approximately 10 minutes with continued heating in between additions. The resulting mixture was cooled to room temperature and filtered into a 50-mL volumetric flask, which was brought to volume using distilled water and mixed well. From this stock solution, a 10-mL portion was pipetted into a clean 50-mL volumetric flask, brought to volume with distilled water, and mixed. This final solution was analyzed and found to contain 12.1 ppm lead. What are the mass percent of lead in the original plant tissue?
A stock solution of potassium permanganate (KMn04) was prepared by dissolving 13.0g KMn04 with DI in a 100ml volumetric flask and diluting to the calibration mark. Determine the molarity of the solution.
In the laboratory, a student was tasked to prepare a stock solution of HCl for titration. The available analytical grade HCl solution in the stock room was labelled 35% w/v HCl. The student proceeded to prepare the stock solution by mixing 10mL of the HCl solution with 490mL of analytical grade water. Then, the solution was further diluted by adding 5mL, since the total volume of the solution did not reach the 500mL etched mark on the volumetric flask. To prepare the titrant, the student mixed 10mL of the stock solution, then added 40mL of analytical grade water. The titrant was subsequently used to determine the concentration of two titrand. *Use the table as a reference 1. What is the normality of the available HCl reagent in the stock room?* 5.08 N 10.15 N 20.3 N 11.0 N None of the choices 2. What is the normality of the stock solution of HCl?* 0.09N 0.10N 0.11N 0.12N None of the choices 3. What is the normality of the titrant?*…
Ferric oxide (Fe2O3, density 5 5.24 g/mL) obtained from ignition of a gravimetric precipitate weighed 0.296 1 g in the atmosphere. What is the true mass in vacuum?
If you mixed a solution at ARCC that was 17.5 % mass/mass of the sugar sodium and then transferred 2.00 mL weighing 3.21 g into a graduated cylinder and diluted to 10.00 mL, what mass of sodium was transferred to your new solution?
A pipet is used to transfer 6.00 mLmL of a 3.75 MM stock solution in flask “S” to a 25.00-mL volumetric flask “A,” which is then diluted with DI H2OH2O to the calibration mark. The solution is thoroughly mixed. Next, 10.00 mLmL of the solution in volumetric flask “A” is transferred by pipet to a 50.00-mL volumetric flask “B” and then diluted with DI H2OH2O to the calibration mark. Calculate the molarity of the solution in volumetric flask “B.”
6. A stock solution containing 25% w/v of chlorhexidine is used to prepare an antiseptic such that when the antiseptic is diluted 1 in 25, a 1 in 500 wash solution is obtained which is ready for use by the patient. What volume (ml) of the stock solution is required to prepare 5 litres of the antiseptic to fulfil a bulk manufacturing order?
A solution was prepared by dissolving 1210 mg of K3Fe(CN)6 (329.2 g/mol) in sufficient water to give 775 mL. Calculate: the molar analytical concentration of K3Fe(CN)6. the weight/volume percentage of K3Fe(CN)6. ppm Fe(CN)6