spotting paper chromatography samples above the solvent level ______________________________________ a. enhances chromatographic chamber saturation b. prevents premature separation of components c. Both a and b d. Neither a nor b

spotting paper chromatography samples above the solvent level ______________________________________ a. enhances chromatographic chamber saturation b. prevents premature separation of components c. Both a and b d. Neither a nor b

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.8QAP

See similar textbooks

Related questions

Q: In a normal phase chromatography setup, which would be the predicted characteristics of the eluates…

Q: In thin layer chromatography the initial spot is placed: A. on a pencil line B. four centimeters…

A: Thin layer chromatography is a type of chromatography.

Q: What part fo chromatography is being descibe by the following? a phase that is fixed in place either…

Q: All three of these are gas chromatography runs from my sample. I'm trying to figure out what it…

A: To find the reason for varied retention times and intensities

Q: Fresh solvent - eluent Mobile phase Sample components A Celumn packing Stationary phase suspended in…

A: B is less polar and A is more polar Because the stationary phase is polar, polar molecules will…

Q: d) In a typical HPLC column, 150 atm of pressure is required to push the mobile phase through the…

A: In this question, we have to find out the correct answer of given problem by the help of the concept…

Q: List 2 factors that can affect separation in chromatography experiment

A: 1st factor is by increasing the retardation time. As we increase the size of coloumn ,then analytes…

Q: Explain how the Rf (Retention Factor)-values can be in agreement or disagreement with the “like…

A: Interpretation - To explain all about that how the Rf ( Retention factor ) - values can be…

Q: True or false. A primary standard solid must be weighed accurately and diluted to an accurately…

A: Analytical chemistry.

Q: economical purification technique that ca n be pure material? O Distillation O Another extraction…

Q: All chromatographic techniques can be used as separation methods. True False

A: Chromatography is a laboratory technique for the separation of a mixture into its components.…

Q: Which solution is of known concentration that is used to react completely with an analyte?…

Q: Nitrogen Content Assay Method I is also known as? Distillation Micrometric Method Macromethod…

A: Nitrogen Content Assay Method I is also known as?

Q: How can you vary the retention factor and selectivity factor?

A: Retention factor is a variable which indicates the time duration a component spends in the…

Q: Retention Time Of Cyclohexene?

A: Retention time is the time interval between compound introduced or chromatogram starting to maximum…

Q: Explain about Liquid Chromatography technique.

Q: One of the following techniques cannot be used for separation ounodwom Select one: O a.…

A: Answer - The correct option is (b) boiling point determination. The boiling point of a compound,…

Q: in what situation does one use thin and/or column chromatography? You can any of theme for anything…

A: Chromatography is an analytical technique to separate mixtures into it's components. It is also…

Q: Using a normal phase chromatography, which solute will elute out first from column? Chlorophyll…

A: Answer In column chromatography the more polar compounds…

Q: calculate the following for each sample gas chromatograph. a) retention time for each peak (label…

A: The given plot is redrawn as shown below.

Q: Why is splitless injection used with purge and trap sample preparation?

A: The collection of all of the analyte from the unknown and to inject whole of the analyte into the…

Q: Label the parts of this chromatography column. "A" "B" "C" "D" "E" "F"

A: Chromatography - It is a laboratory technique used for the seperation of a mixture. The mixture is…

Q: When you prepare your sample to run through the column chromatography , what is the first proper…

A: For the column chromatography the sample should be properly dissolved in an appropriate solvent

Q: What are the possible reasons why there are no spots on the Developed Plate after analysis?

Q: if air can degrade a column and cause TC detector filaments to burn out, why do we use an air peak?

A: Interpretation - If air can degrade a column and cause TC detector filaments to burn out, why do we…

Q: paper chromatography?

A: Chromatography is a technique that is used for the separation of a mixture. It has two important…

Q: What should you do if there are insoluble impurities after heating up your sample in the…

A: A multiple choice question based on purification, which is to be accomplished.

Q: Explain how solvent trapping and cold trapping work in splitless injection.

A: In Gas chromatography both split and splitless injection takes place. Split injection is used when…

Q: Give at least five factors to consider when performing chromatography (paper, thin-layer, liquid,…

A: Chromatography is a technique that is used for the separation of components of a mixture. The…

Q: High performance liquid chromatography can separate eluates even if they are not present in the UV…

A: The actual separation of each component in a sample is always carried inside a column and to be able…

Q: State the major differences along liquid, gas, and super critical fluid chromatography?

A: A supercritical fluid is the phase of a material at critical temperature and critical pressure of…

Q: What error is introduced into the determination of an Rf value if the top is left off the developing…

A: In chromatographic technique, the components of a mixture are separated by using a developing…

Q: Solve this

A: Solid phase extraction is technique of preparing sample with help of solid adsorbent. It is used to…

Q: Determine the Kovats retention index for all six analytes.

A: In gas chromatography, Kovats retention index is used to convert retention times into…

Q: Explain why the indicators, red and blue, are separated on the TLC plate during a chromatography…

A: Thin ayer chromatography is a chromatography technique, which is used to separate non-volatile…

Q: Match column A with column B. v Mobile phase: NON-POLAR Stationary phase: NON-POLAR v mobile phase -…

Q: a) Solid phase extraction E

A: In this question, we have to tell about which pre concentration method would be right for tomato…

Q: Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many…

A: Given that., Distance traveled by the spot from bottom = 3.52 cm Distance travel by mobile phase =…

Q: "Start the chromatography by adjusting the fraction collector to 130 drops per fraction (about 3…

A: It is given that for 130 drops per fraction it shows volume 3 mL That means volume of 130 drops is 3…

Q: Explain why it is needed to filter the solvent before introducing it to the HPLC system

A: Basically there are following two reasons for using filtration during HPLC sample preparation are…

Q: Question 5 Which part of the HPLC contains majority of the solvent? O fraction collector O reservoir…

A: The beginning of the HPLC system occurs with the solvent reservoir which contains the solvent , and…

Q: The following conditions may not cause tailing EXCEPT a. Thick filter paper as the stationary phase…

A: Tailing in thin layer chromatography : Due to the using high concentration of solute or other…

Q: How column is developed and solvent selection is done in HPLC?

A: HPLC stands for High-pressure liquid chromatography or high-performance liquid chromatography.HPLC…

Q: What is the purpose of thin layer chromography lab? What is a hypothesis I can use when conducting a…

A: Introduction: Chromatography is a technique used to separate the mixture if solution. There are two…

Q: Paper Chromatography laboratory report explanation

A: Paper chromatography is an analytical method used to separate colored chemicals or substances. It is…

Q: f the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mi what is the % B…

A: Solution- Given data- Dwell time is 3.5 min. Solvent gradient of 5% B to 60% B in 20 min. To find-…

Q: A TLC plate showed two spots A and B with Rf 0.20 and 0.30, respectively. Sketch a TLC chromatogram…

A: Sketch of TLC chromatogram: TLC plate = 10cm

Q: Should you increase the diameter or length of the chromatography colum for increasing throughput?

Q: How do you weigh hydgroscopic samples?

A: Hydgroscopic samples contain moisture. Therefore it is measured in digital analytical balance.

Question

spotting paper chromatography samples above the solvent level ______________________________________

a. enhances chromatographic chamber saturation

b. prevents premature separation of components

c. Both a and b

d. Neither a nor b

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

in what situation does one use thin and/or column chromatography? You can any of theme for anything chromatography
How column is developed and solvent selection is done in HPLC?
Explain why it is needed to filter the solvent before introducing it to the HPLC system
In comparing direct headspace injections with SPMEheadspace injections, later eluting peaks (by GC) arelarger in SPME. Explain why.
In order to execute paper chromatography, which of the following stages is required?I. Load the standard/s beside the sample spotsII. Allow the chromatogram to touch sides of beakerIII. Saturate the chamber with vapor of the mobile phaseIV. Place the spots at the same height as the solvent level
Where should the analyte be spotted on a TLC plate? Below the 1 cm spot line On the 1 cm spot line. On the solvent front line Above the 1 cm spot line
paper chromatography?
Before developing a TLC plate you should _______.a. Make sure to mark the origin with a pen b. Make sure to mark the origin with a pencil c. Make sure the filter is all the way around the inside of the developing chamber
Explain why the indicators, red and blue, are separated on the TLC plate during a chromatography lab.
Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many amphetamine‑type stimulants (ATS). Using a 0.25 mm thick silica gel stationary phase and a 98.5:1.5 methanol:concentrated ammonia mobile phase, a spot was observed to have traveled 3.52 cm when the solvent front traveled 8.81 cm. What is the retardation factor (?F)for the compound that composes this spot?
High performance liquid chromatography can separate eluates even if they are not present in the UV detector. True False
Need help with ochem gas chromatography. Show all the work please tnx’