ssm Heat engines take input energy in the form of heat, use some of that energy to do work, and exhaust the remainder. Similarly, a person can be viewed as a heat engine that takes an input of internal energy, uses some of it to do work, and gives off the rest as heat. Suppose that a trained athlete can function as a heat engine with an efficiency of 0.11. (a) What is the magnitude of the internal energy that the athlete uses in order to do 5.1 × 10ª J of work? (b) Determine the 45. magnitude of the heat the athlete gives off.

ssm Heat engines take input energy in the form of heat, use some of that energy to do work, and exhaust the remainder. Similarly, a person can be viewed as a heat engine that takes an input of internal energy, uses some of it to do work, and gives off the rest as heat. Suppose that a trained athlete can function as a heat engine with an efficiency of 0.11. (a) What is the magnitude of the internal energy that the athlete uses in order to do 5.1 × 10ª J of work? (b) Determine the 45. magnitude of the heat the athlete gives off.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter18: Heat Engines, Entropy, And The Second Law Of Thermodynamics

Section18.1: Heat Engines And The Second Law Of Thermodynamics

Problem 18.1QQ: The energy input to an engine is 3.00 times greater than the work it performs. (i) What is its...

See similar textbooks

Similar questions

In a diesel engine, the fuel is ignited without a spark plug. Instead, air in a cylinder is compressed adiabatically to a temperature above the ignition temperature of the fuel; at the point of maximum compression, the fuel is injected into the cylinder. Suppose that air at 20 C is taken into the cylinder at a volume V1 and then compressed adiabatically and quasi-statically to a temperature of 600 C and a volume V2 . If =1.4 , what is the ratio V1/V2 ? (Note: static. In an operating diesel engine, the compression is not quasi-
Two moles of a monatomic ideal gas such as oxygen is compressed adiabatically and reversibly from a state (3 atm, 5 L) to a state with a pressure of 4 atm. (a) Find the volume and temperature of the final state. (b) Find the temperature of the initial state. (c) Find work done by the gas in the process. (d) Find the change in internal energy in the process. Assume Cv=5R and Cp=Cv+R for the diatomic ideal gas in the conditions given.
A Carnot engine is used to measure the temperature of a heat reservoir. The engine operates between the heat reservoir and a reservoir consisting of water at its triple point. (a) If 400 J per cycle are removed from the heat reservoir while 200 J per cycle are deposited in the triple-point reservoir, what is the temperature of the heat reservoir? (b) If 400 J per cycle are removed from the triple-point reservoir while 200 J per cycle are deposited in the heat reservoir, what is the temperature of the heat reservoir?
The energy input to an engine is 3.00 times greater than the work it performs. (i) What is its thermal efficiency? (a) 3.00 (b) 1.00 (c) 0.333 (d) impossible to determine (ii) What fraction of the energy input is expelled to the cold reservoir? (a) 0.333 (b) 0.667 (c) 1.00 (d) impossible to determine
A multicylinder gasoline engine in an airplane, operating at 2.50 103 rev/min, takes in energy 7.89 103 J and exhausts 4.58 103 J for each revolution of the crankshaft. (a) How many liters of fuel does it consume in 1.00 h of operation if the heat of combustion of the fuel is equal to 4.03 107 J/L? (b) What is the mechanical power output of the engine? Ignore friction and express the answer in horsepower. (c) What is the torque exerted by the crankshaft on the load? (d) What power must the exhaust and cooling system transfer out of the engine?
A Carnot cycle working between 100 and 30 is used to drive a refrigerator between 10 and 30 . How much energy must the Carnot engine produce per second so that the refrigerator is able to discard 10 J of energy per second?
In an adiabatic process, oxygen gas in a container is compressed along a path that can be described by the following pressure in atm as a function of volume V, with V0=1L:P=(3.0atm)(V/V)1.2 . The initial and final volumes during the process were 2 L and 1.5 L, respectively. Find the amount of work done on the gas.
A Carnot engine operates with TL=20°C and has anefficiency of 25%. By how many kelvins should the highoperating temperature TH be increased to achieve an efficiency of 35%?
Calculate the net work output (in J) of a heat engine following path ABCDA in the figure, where V1 = 0.5 ✕ 10−3 m3 and V2 = 2.0 ✕ 10−3 m3.
A 500 W Carnot engine operates between constanttemperaturereservoirs at 100 C and 60.0 C.What is the rate at whichenergy is (a) taken in by the engine as heat and (b) exhausted by theengine as heat?
When 1.60×105 J of heat transfer occurs into a meat pie initially at 20.0º C , its entropy increases by 480 J/K. What is its final temperature?
When 1.60×105J of heat transfer occurs into a meat pie initially at 20.0º C , its entropy increases by 480 J/K. What is its final temperature?