Tech A says that if a noise is caused by a set of worn gears, it will normally be loudest in that gear while driving under a load. Tech B says that if the bearings on the input shaft, countershaft, or main shaft are worn, either front or rear, a growling noise will result when stopped in gear. Who is correct?

Tech A says that if a noise is caused by a set of worn gears, it will normally be loudest in that gear while driving under a load. Tech B says that if the bearings on the input shaft, countershaft, or main shaft are worn, either front or rear, a growling noise will result when stopped in gear. Who is correct?

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter39: Manual Transmission/transaxle Service

Section: Chapter Questions

Problem 2ASRQ: A noise occurs in forward and reverse gears but not in neutral: Technician A says that the input...

See similar textbooks

Similar questions

previous explanation isn't good. What is the output when a large gear drives a smaller gear ? (Answer it within 30min)
Discuss the difference between simple gear train and compound gear train ..
Technician A says that a hunting gearset is one in which one drive pinion gear tooth contacts only certain ring gear teeth, Technician B says that a partial nonhunting gearset is one in which one pinion tooth contacts only six ring gear teeth. Who is correct?
Two mating 20°, 8-pitch, spur gears have 14 and 42 teeth. Will they interfere?
2-) Answer the following questionsa-) The number of teeth that the gear wheels will have at least in order not to be cut from under the profile is called the limit tooth number. Calculate the theoretical minimum number of teeth the pinion gear can have by considering the reference profile without profile slip in evolvent gears, taking the clutch angle of 250.b-) If a gear system is dimensioned according to surface pressure calculations and controlled according to strength, how can a comment be made about the hardness of the gear wheel. Give examples of what the material of this gear wheel could be (3 pieces).
An epicyclic gear train has 3 shafts A,B and CA is an input shaft running at 100 rpm clockwise. B is an output shaft running at 250 rpm clockwise. Torque on A is 50 kNm (clockwise). C is a fixed shaft. The torque to fix C
Explain In order to test the efficiency of reducer gear train 1 kW input was given at the input end at a speed of 1440 rpm and at the output end the measured torque was 56.36 Nm. If the ratio of speed reduction in this unit is 10: 1, the efficiency is about (a) 78% (c) 63% (b) 85% (d) 96%
Plz answer this in 40 min, i need the answer ASAP,thx mechanical engineering Determine from the image below: 1. Types of gears in below gearbox. 2. module 3. surface width (tooth width), and 4. Outer diameter of pinion and gear.
what is the equation of the addendum and dedendum in helical gears
To achieve a slow overdrive in a simple planetary gearset, the . a.sun gear must be the input member b.ring gear must be the input member c.planetary cart"ier must be the input memberring gear must be held d. ring gear must be held
Explain the operation principle of a differential system and how a differential system relates to epicyclic gear trains
When a transmission is described as having two planetary gearsets in tandem, what does this mean?