Technician A says that the engine oil drain plug typically needs to be replaced with a new one at each oil change. Technician B says that engine oil drain plugs must be tightened with a torque wrench when they are installed. Who is correct?

Technician A says that the engine oil drain plug typically needs to be replaced with a new one at each oil change. Technician B says that engine oil drain plugs must be tightened with a torque wrench when they are installed. Who is correct?

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter7: Working Safely In The Shop

Section: Chapter Questions

Problem 14RQ: Technician A says that used engine coolant should be collected and recycled. Technician B says that...

See similar textbooks

Related questions

Q: A vehicle has had several radiator replacements, and each time there has been pinhole leaks in the…

A: Solution:

Q: Pressure regulators are being discussed. Technician A says they are located in the fuel rail.…

A: Pressure Regulator are the important component of fuel rail system The function of Fuel pressure…

Q: why should you wipe off the outside of a zerk fitting before injecting grease into it

A: Solution:

Q: Technician A says that excessively high pressure from an electric fuel pump can be caused by a…

A: Solution:

Q: List five different types of oil rating systems

A: Oil Rating Systems:- The society of Automotive Engineers SAE has established a numerical code…

Q: Technician A says that when using a flare-nut wrench, two wrenches must often be used. Technician B…

A: A flare nut is a nut used for connecting to tubes for compression fittings of ductile materials. In…

Q: ne fluid power system

A: Pnuematic.

Q: Which of the following is a function of the engine’slubrication system?a. Holds an adequate supply…

A: Given Data : Engine's lubrication system

Q: While discussing the cause of an oil leak in an axle housing, Technician A says if the fluid leaks…

A: Technician B is correct. As the leakage in an axle housing is due to the damaged axle seals. So. the…

Q: Technician A says that black exhaust smoke is an indication of a too-rich air-fuel mixture.…

A: Air–fuel ratio is defined as the mass ratio of air to fuel present during combustion. Rich air-fuel…

Q: Technician A says all gaskets should be discarded during teardown to keep the work area clean.…

A: Gasket : A gasket is a mechanical seal i.e it is used to close up the gap between two mating…

Q: Technician A says that air-fuel ratios can be regulated by controlling the “on time” of the…

A: Given: Technician A says that air-fuel ratios can be regulated by controlling the “on time” of the…

Q: Choose the correct statement. Select one: a. A dry sump system stores oil in a tank outside of the…

A: The wet sump system is the best fit during aggressive driving conditions.

Q: 1.Name type of failures in engine blocks

A: The engine is the most important part of the IC engine. In production, Every company produces an…

Q: Identify parts of an engine lubrication system using this schematic drawing Oil Sump

A: given; identify parts of engine lubrication system.

Q: 52) Technician A says few production vehicles have transmissions with an internal oil cooler.…

A: Technician A is saying correct statement as the transmissions with the oil cooler are located in the…

Q: True or False? Oil pressure is determined bywhether the pump is a gear type or rotor typeand by oil…

A: Given Data : Oil Pressure

Q: While discussing electric fuel pumps: Technician A says that some electric fuel pumps are combined…

A: "Technician A only" Given information: While discussing electric fuel pumps: Technician A…

Q: Technician A says that it takes about 1 pint of oil to raise the oil level from "add" to "full."…

A: Technician A says that is takes about 1 pint of oil to raise the oil level from "add" to "full".…

Q: Technician A says it is important to note transmission fluid temperature when checking the fluid…

A: For level checking of transmission fluid its temperature is checked. Transaxle has fluid for…

Q: A reddish-colored oil is discovered to be leaking during an engine oil change and inspection:…

A: Leak fluid color and its use in an automobile is shown in tabulated form Leak fluid color fluid…

Q: d. Check oil level & moisture content 19. If the main wire (coil) to the distributor and the coil to…

A: 19. if the main wire (coil) to the distributor and the coil to the switch are broken , replace them…

Q: an engine is being discussed for lean running condition. technician A checks for air leak in the…

A: There are five factors that causes to run engine in lean condition. They are Fuel System Oxygen…

Q: Add the correct numbers into text boxes to identify correct labelling of a fixed choke carburettor.

A: Given:- Fixed choke carburetor To find:- Name the parts

Q: the oil pressure light stay on whatever the engine fis running, and the oil pressure has been…

A: Oil pressure light indicates that the pressure of the oil is within the specified limits. It will…

Q: Technician A uses a feeler gauge and straightedge to determine the pump cover flatness.Technician B…

A: A feeler gauge is a hand-held instrument that is used to measure the distance between two objects…

Q: What checks can be performed to know if the lubricating oil of an engine has been contaminated?

A: Techniques to check whether the lubricating oil is contaminated are as follows, Debris analysis Wear…

Q: What component is responsible for circulating coolant through the engine

A: In the engine we use water pump to force the water to circulate throughout...

Q: Technician A uses sandpaper to remove carbon deposits from turbocharger wastegate parts. Technician…

A: The turbocharger is a device used to increase the power of the engine by compressing the air that…

Q: If oil pressure is higher than specifications: Select one: a. there may be excessive clearance in…

A: Option b is correct.

Q: Which type of oil filter uses an anti drain back valve to prevent it from emptying of oil when the…

A: Which type of oil filter uses an anti drain back valve to prevent if form emptying of oil when…

Q: When fitting a freshly ground valve into a freshly ground seat: Technician A says that the seat…

A: The reconditioning of the valve seats is done to remove cracks, pitting and grooves from its…

Q: Technician A says that excessive engine oil consumption can be caused by low oil levels. Technician…

A: Answer:- Technician B correct.

Q: Hydraulic lifters or hydraulic lash adjusters (HLA) may not bleed down properly and cause an engine…

A: Using an engine oil too thick can cause the hydraulic lash or hydraulic lifters to not bleed as fast…

Q: Technician A says that coolant hoses should be squeezed to check for hardening or softening.…

A: Solidly squeeze both the upper radiator and radiator hoses. They ought to feel firm, solid, and…

Q: Technician A says that you may be able to smell antifreeze from a leaking heater core. Technician B…

A: A loosen belt dive can be noisy and a antifreeze from a leaking heater core can be smelly.

Q: A vehicle comes in with no coolant and a core plug popped out of the engine block. Technician A…

A: The water pump in an automobile is a part of the cooling system of the engine. The most commonly…

Q: Technician A says that a two-stroke oil injection system uses a gravity-fed pressure system.…

A: Given Data⇒ Technician A⇒Two stroke-oil injection system uses a gravity-fed Pressure system.…

Q: Technician A says the oil pressure will typically below the level is at the add" line on the…

A: Technician B statement is correct because worn engine bearings will definitely cause low oil…

Q: When installing a spin-on oil filter, failure to lube the O-ring will:

A: The correct option is a.

Q: If the oil on the dipstick looks milky gray, it is possible that there is water (or coolant) being…

A: Solution:

Q: the metring valve portion of combination valve fails .technician A says that this means the entire…

A: Given data technician A says that this means the entire combination valve must be replaced.…

Q: when installing a spin-on oil filter, failure to lube the o-ring will?

A: Given: When installing a spin-on oil filter, failure to lube the o-ring will?

Q: Technician A says that broken engine mounts can cause the fan to hit the shroud. Technician B says…

A: Solution:

Q: Answer the following question: 1. On an aircraft enumerate the turboprop starting procedures.

Q: What is the purpose of blowing the Main Engine (kick start by air) before initial start up? * To…

A: Disclaimer: Since you have posted multiple questions we will solve the first question for you. If…

Q: While discussing valve body assemblies in late-model transmissions: Technician A says that the valve…

A: Automatic transmission valve body is a major part of a vehicle’s automatic transmission system. It…

Q: 26(a). What is the use of separator and when it is used in oil industry?

Q: Technician A says that when draining the engine oil, the engine should be fully cold for best…

A: CORRECT ANSWER IS D) NEITHER A NOR B As the old engine oil should be drained when the engine is warm…

Question

100%

Technician A says that the engine oil drain
plug typically needs to be replaced with a
new one at each oil change. Technician B
says that engine oil drain plugs must be
tightened with a torque wrench when they
are installed. Who is correct?
Select one:
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

37- Technician A says that all transmission opening pressure are derived from the regulated output flow of the oil pump. Technician B says that every automatic transmission uses one, or more, pressure regulator valves. Who is correct? A- Technician A B- Technician B C- Both A and B D- Neither A nor B
List out the design requirements of diesel engine combustion chamber
Technician A says that when using a flare-nut wrench, two wrenches must often be used. Technician B says to use an open-end wrench on fuel fittings. Who is right?
Technician A says that a stator aids in directing the flow of fluid from the impeller to the turbine. Technician B says that a stator is equipped with a one-way clutch that allows it to remain stationary when necessary. Who is correct?
when installing a spin-on oil filter, failure to lube the o-ring will?
Carbon deposits on the intake valve or seat may cause the valve not to close properly. Tech a says that the flywheel will be harder to spin when starting the engine. Tech b says that the engine will loose power. Who is correct?
Technician A says the oil pressure will typically below the level is at the add" line on the dipstick. Technician B says that wom engine bearings could cause low oil pressurecorrect ?
Technician A says that excessively high pressure from an electric fuel pump can be caused by a faulty pressure regulator. Technician B says that the typical problem may be an obstructed return line. Who is correct?
Technician A says that used engine coolant should be collected and recycled. Technician B says that all oil- based waste materials can be collected in the same container if an approved waste disposal company is hired to rid the shop of the oil. Who is correct? Technician A Technician B Both A and B Neither A nor B
While discussing an inoperative blend air door: Technician A says that to check the proper functioning of the ductwork, a scan tool may be used to command the door to change position. Technician B says that in some cases you can reach under the dash to reconnect the cable or free a stuck flap. Who is right? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
Explain how a plugged fluid cooler can cause a vehicle to stall when reverse is selected.
List five problems that can be caused by engine overheating.