The electrical power consumed by the pump, in kW b) What is the daily electricity consumption (in kWh) if the 30 m3 capacity tank is filled 2 times a day?

Q: A stream with Q = 8 m3/s Flow rate is passed through the turbine by means of a pressure pipe. its…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: In a pumping system handling water, the level in the suction tank is 3m below the pump shaft…

A:

Q: A Liquid fluid with a density of 1,750 kg/m3 from an elevated 2m open reservoir (P1=0 bars) flows…

A: Given data: P1=0ρ=1750 kg/m3h1=2 mv1=7.5 m/sP2=7.5 barh2=75 mW=1933400 Jη=75% Need to determine the…

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of vavg = 1.15 m/s.…

A:

Q: Using a handheld bicycle pump to generate an air jet, a soda can as the water reservoir, and a straw…

A: Draw the diagram of the apparatus.

Q: Water enters a hydraulic turbine through a 30-cm-diameter pipe at a rate of 1.1 m3/s and exits…

A:

Q: Water is stored in an elevated reservoir. To generate power, water flows from this reservoir down…

A: given data; pressure (P1)=172.4KPa=172.4*103Paheight above from datum(Z1)=89.5mheight below from…

Q: Water is pumped from a lake to a storage tank 15 m above at a rate of 70 L/s while consuming 15.4 kW…

A: The electric power supplied to the pump is The power supplied to the water by the pump can be…

Q: A tube is used to fill a tank of volume 37.854 L. (1L = 0.001m3). The diameter of the tube is 2 cm,…

A:

Q: A 78-percent efficient 12-hp pump is pumping water from a lake to a nearby pool at a rate of 1.2…

A: The density of water is

Q: Water enters a hydraulic turbine through a 30-cm-diameter pipe at a rate of 0.7 m3/s and exits…

A: The given data is shown in the following attached image:

Q: Liquid water enters a nozzle from the inlet with area of 1000 cm2, and leaves the nozzle from the…

A: Given data: Inlet velocity, V1=10 m/s and inlet area of the nozzle, A1=1000 cm2=0.1 m2. Let V2 be…

Q: 4. In a steady flow apparatus,135kJ of work is done by each kg of fluid. The specific volume of the…

A:

Q: An air compressor receives 272 kg/min of air at 99.29 kPa and a specific volume of 0.026 m3/kg. The…

A:

Q: A fireboat is to fight fires at coastal areas by drawing seawater with a density of 1030 kg/m^3…

A:

Q: 9. A turbine receives steam at 2778.1 kJ/kg enthalpy and then converts it to shaft work. The steam…

A: To determine the power produced by the turbine.

Q: 4. In a steady flow apparatus,135kJ of work is done by each kg of fluid. The specific volume of the…

A: To check: Whether the specific internal energy increase or decrease, and by how much. Given: The…

Q: In a pumping system handling water, the level in the suction tank is 3m below the pump shaft…

A:

Q: Consider water flow in a piping network. The pressure, velocity, and elevation at a specified point…

A: Write the Bernoulli's equation between points 1 and 2. Here, P1 is the pressure at point 1, v1 is…

Q: Underground water is to be pumped by a 78 percent efficient 5-kW submerged pump to a pool whose free…

A: (a) On using Bernoulli’s equation at point of intake and discharge, Now, it is written as

Q: A pump draws 20 kW of electrical power while pumping oil with a density of 780 kg/m^3 at a flow rate…

A: electric power = 20 kW Density = 780 kg/m^3  Flow rate = 0.3 m3/s Inlet diameter = 7 cm Outlet…

Q: a compressor draws in 0.25m^3/s of air whose density is 1.26kg/m^3 and discharges it with a density…

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L's while consuming 22.4 kW…

A: Given data Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L/s while…

Q: team enters a turbine with a pressure of P1 = (5000 – K) kPa, specific internal energy u1 = (3500 +…

A:

Q: Current Attempt in Progress As shown in the figure below, water behind a dam enters an intake pipe…

A:

Q: A pump delivers water (density equals 1000 kg/m^3) at a steady rate of 1219 L/min as shown in the…

A: The steady flow energy equation is the equation of the first law of the thermodynamics for an open…

Q: diameter tube at a rate of 0.6 m3/s and leaves through a 25 cm diameter tube. cm in diameter With a…

A:

Q: A pump delivers water (density equals 1000 kg/m^3) at a steady rate of 1219 L/min as shown in the…

A: Given data: AE=14 cm2Ai=56 cm2Q=1219 L/min Need to determine the velocity of the flowing fluid at…

Q: Water is pumped from a lake to a storage tank 18 m above at a rate of 70 L/s while consuming 20.4 kW…

A: Density of water = 1000 kg/m3 Height of tank H = 18 m flow rate V = 70 L/s = 0.07 m3/s Pump Power =…

Q: Steam enters a turbine with a pressure of P1 = (5000 – K) kPa, specific internal energy u1 = (3500 +…

A:

Q: Solve the problem.   In a steady flow apparatus, 135 kJ of work is done by each kg of fluid. The…

A: GivenW=135kJ/kgv1=0.37 m3/kgP1=600kPaV1=16m/sz1=32mv2=0.62m3/kgP2=100kPaV2=270 m/sZ2=0 the discharge…

Q: An automobile moving through the air causes the air velocity (measured with respect to the car) to…

A:

Q: Show that the power produced by a wind turbine is proportional to the cube of the wind velocity and…

A: The power generated depends primarily on the discharge through the turbines and the hydraulic head.…

Q: The power output of an adiabatic steam turbine is 5 MW, and the inlet and the exit conditions of the…

A: Given data W=5 MW

Q: 1.  Water horsepower of the pump 2.  Brake horsepower of the pump 3.  Power input to drive the…

A:

Q: A fireboat is to fight fires at coastal areas by drawing seawater with a density of 1030 kg/m3…

A: To find the shaft power input to the pump and discharge velocity of water Firstly to find the…

Q: Q5. The pump shown in Figure 1 is pumping oil of a density = 860 kg/m' and is powered by a 35-kw…

A: given data power of pump = 35 kw density of oil = 860 kg/m3 electric motor efficiency = 90% water…

Q: B. water supply tank is capable of delivering 0.4 m3/s of water for firefighting purposes in a…

A:

Q: Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 23 kW of useful…

A: Given; Mechanical power by a pump, Pm=23 kW Head difference between reservoirs, H=57 m The flow rate…

Q: Calculate the work in megajoules (1 MJ = 1 × 10° J) required to pump all the water out of a full…

A: Given a=4 mb=11 mc=13 mh=2 mDensityρ=1000 kg/m3Acceleration due to gravity g=9.8 m/s2

Q: A submersible pump with a shaft power of 6 kW and an efficiency of 75% is used to pump water from a…

A: Shaft power of pump, P=6 kW Pump efficiency, η=75 % Elevation difference between the lake and pool,…

Q: The power output of an adiabatic steam turbine is 5 MW, and the inlet conditions are given as P₁ -2…

A:

Q: Water at 80 kPa (gage) enters a horizontal pipe at a velocity of 1.7 m/s. The pipe makes a 90° angle…

A: Given Data Inlet pressure is: P1=80 kPa=80×103 Pa inlet velocity is: v1=1.7 m/s Correction factor…

Q: Steam is supplied to a turbine at 407.1 inHg (abs) with the following initial conditions: u = 1163.3…

A:

Q: A pump rated at 700W is used to transfer water from an open tank at ground level, to another open…

A:

Q: A water jet that leaves a nozzle at 58.08 m/s at a flow rate of 118.14 kg/s is to be used to…

A:

Q: In a steady flow apparatus, 135 KJ of work is done by each kg of fluid. The specific volume of the…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.