Thefigure shows particles 1 and 2, each of mass m, attached to the ends of a rigid massless rod of length L₁ + L2, with L₁ = 1.0 m and L2= 7.0 m. The rod is held horizontally on the fulcrum and then released. What are the magnitudes of the initial accelerations of (a)particle 1 and (b) particle 2?-L₂-100

The distance of particle 1 from the pivot: The distance of particle 2 from the pivot: Mass of…

The figure shows particles 1 and 2, each of mass m, attached to the ends of a rigid massless rod of length L₁ + L2, with L₁ = 1.0 m and L₂ = 7.0 m. The rod is held horizontally on the fulcrum and then released. What are the magnitudes of the initial accelerations of (a) particle 1 and (b) particle 2? 14+ -L₂-

The figure shows particles 1 and 2, each of mass m, attached to the ends of a rigid massless rod of length L₁ + L2, with L₁ = 1.0 m and L₂ = 7.0 m. The rod is held horizontally on the fulcrum and then released. What are the magnitudes of the initial accelerations of (a) particle 1 and (b) particle 2? 14+ -L₂-

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter12: Rotation I: Kinematics And Dynamics

Section: Chapter Questions

Problem 70PQ: A ball rolls to the left along a horizontal surface, up the slope, and then continues along a...

See similar textbooks

Similar questions

The figure shows particles 1 and 2, each of mass m, attached to the ends of a rigid massless rod of length L1 + L2, with L1 = 1.0 m and L2 = 5.0 m. The rod is held horizontally on the fulcrum and then released. What are the magnitudes of the initial accelerations of particle 2?
Two blocks of the same masses (m = 1.1 kg) are attached to end of a rope that passes over a pulley suspended from the ceiling. The pulley is a uniform disk (Iaisk=MR?), with mass M = 2.7 kg and %3D %3! radius R = 20 cm. When the block is released and the cord unwinds, the acceleration of the blocks ( in m/s) is: m
F15-24. Two identical 10-kg spheres are attached to the light rigid rod, which rotates in the horizontal plane centered at pin O. If the spheres are subjected to tangential forces of P = 10 N, and the rod is subjected to a couple moment M = (81) N - m, where t is in seconds, determine the speed of the spheres at the instant 1 = 4 s. The system starts from rest. Neglect the size of the spheres. P = 10 N %3D -0.5 m 0.5 m M = (81) N-m P = 10 N
A puck of mass m = 1.30 kg slides in a circle of radius r = 22.0 cm on a frictionless table while attached to a hanging cylinder of mass M= 2.30 kg by a cord through a hole in the table. What speed keeps the cylinder at rest? M Number i 2.227 Units m/s
You've taken your neighbor's young child to the carnival to ride the rides. She wants to ride The Rocket. Eight rocket-shaped cars hang by chains from the outside edge of a large steel disk. A vertical axle through the center of the ride turns the disk, causing the cars to revolve in a circle. You've just finished taking physics, so you decide to figure out the speed of the cars while you wait. You estimate that the disk is 6 m in diameter and the chains are 6 m long. The ride takes 10 s to reach full speed, then the cars swing out until the chains are 30∘ from vertical. What is the car's speed?
Keratinocytes are the most common cells in the skins outer layer. As these approximately circular cells migrate across a wound during the healing process, they roll in a way that reduces the frictional forces impeding their motion. (a) Given a cell body diameter of 1.00 105 m (10 m), what minimum angular speed would be required to produce the observed linear speed of 1.67 107 m/s (10 m/min)? (b) How many complete revolutions would be required for the cell to roll a distance of 5.00 103 m? (Because of slipping as the cells roll, averages of observed angular speeds and the number of complete revolutions are about three times these minimum values.)
In Example 2.6, we considered a simple model for a rocket launched from the surface of the Earth. A better expression for the rockets position measured from the center of the Earth is given by y(t)=(R3/2+3g2Rt)2/3j where R is the radius of the Earth (6.38 106 m) and g is the constant acceleration of an object in free fall near the Earths surface (9.81 m/s2). a. Derive expressions for vy(t) and ay(t). b. Plot y(t), vy(t), and ay(t). (A spreadsheet program would be helpful.) c. When will the rocket be at y=4R? d. What are vy and ay when y=4R?
A 0.400-kg pendulum bob passes through the lowest part of its path at a speed of 3.00 m/s. (a) What is the tension in the pendulum cable at this point if the pendulum is 80.0 cm long? (b) When the pendulum reaches its highest point, what angle does the cable make with the vertical? (c) What is the tension in the pendulum cable when the pendulum reaches its highest point?
A particle moves 3.0 m along a circle of radius 1.5 m. (a) Through what angle does it rotate? (b) If the particle makes this trip in 1.0 s at a constant speed, what is its angular velocity? (c) What is its acceleration?
A ball rolls to the left along a horizontal surface, up the slope, and then continues along a horizontal surface (Fig. P12.70). Sketch the angular speed and the magnitude of the angular acceleration of the ball as functions of time. FIGURE P12.70
Two blocks with masses M1 and M2 (M2 > M2) are connected via a massless rope and a pulley (a solid disk with a mass of Mp and radius R). M2 is suspended a distance d above the ground. 10. Mp The system is released from rest and the rope does not slip on the pulley. Find the speed of M, right before it hits the ground. Express your answer in terms of the given values and any constants. M1 M2 d
Certain neutron stars (extremely dense stars) are believed to be rotating at about 1.6 rev/s. If such a star has a radius of 12 km, what must be its minimum mass so that material on its surface remains in place during the rapid rotation? Number i Units kg