Answered: the resistance of the coil.

Engineering

Mechanical Engineering

the resistance of the coil.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter3: Transient Heat Conduction

Section: Chapter Questions

Problem 3.1P: Consider a flat plate or a plane wall with a thickness L and a long cylinder of radius r0. Both of...

See similar textbooks

Related questions

Q: A rod of semiconducting material of lenght L=3 m and cross-sectional area A=4.5 mm^2 lies along the…

Q: Consider compensated n-type silicon at T = 300 K, with a conductivity of o = 16 (N-cm) and an…

Q: A copper conductor has a resistance of 80 Ω at room temperature. If resistance temperature…

A: Given Data→ Resistance of the copper conductor R=80Ω At room temperature Resistance temperature…

Q: The test specimen explained in Question 1(e) maintains the same mechanical properties even after the…

Q: Find the resistance at 20°C of an annealed copper bus bar 3 m in length and 0.5 cm by 3 cm in…

A: The given values are length of copper bar=3m, Area of cross section(A)=0.5×10-2×3×10-2 m2=1.5×10-4…

Q: Wire C and wire D are made from the same material, having length LC = LD = 1.0 m and the resistivity…

Q: Calculate the Resistance , if the RTD temperature is 483.8 °C and Sensitivity is 5.8 °C/ohm O a.…

Q: The inner conductor of a coaxial cable has a diameter of 0.5 mm, an outer conductor an inner…

A: Given Data Outer diameter of coaxial cable is :D=6 mm=6×10-3 m Inner diameter of coaxial cable is :…

Q: 14-Two wires have the same length and the same resistance. One is made from aluminum and the other…

Q: O The maximum power cannot be determined without knowing the resistance of the external circui O 7.5…

A: V = IR I = V/R = 1.50/0.30 = 5 Amp power = P = VI = 5 * 1.5 = 7.5 W Option 1st is the wright answer

Q: What is the average thermal conductivity for the composite material shown? 7 cm 4 cm 10 cm 1 2 3…

A: As per given question We have to determine average thermal conductivity for the composite material

Q: Consider a Wheatstone bridge circuit that has all resistances equal to 100 Ω. The resistance R1 is a…

A: = Wheatstone bridgeSince R1 in a strain guage of 100-Ω resistance . ∵R1=Re=R3=R4=100-e.

Q: Determine the length of a copper wire that has a cross-sectional area as 9.8 mm2. The resistance and…

A: Ans is L=73.5m

Q: Using elassical mechanics, show that the effect of an RF pulse applied around the x-axis is to…

A: In order to detect an MR signal, energy must be applied to the nuclear spin system to stimulate…

Q: Determine the resistance of a copper wire that has a cross-sectional area as 9.9 mm2. The length and…

A: Given Area, A = 9.9 mm2 Length, L = 76 m Resistivity, P = 1.64 x 10-6 Ωm.

Q: In an electrical discharge machining process, the breakdown voltage across inter electrode gap (IEG)…

Q: A conductor made of nickel (pe=6.8 10- 8V m) has a rectangular cross section 5 x 2 mm and is 5 m…

A: Solution:

Q: The area and length of a wire are given as 0.82 square meter and 50 cm respectively. The resistivity…

Q: Question 2 A steel railroad rails 10 m long are laid with clearance of 3 mm at a temperature of…

Q: A certain toaster has a heating element made of Nichrome resistance wire. When the toaster is first…

Q: Example 1.6 Solid copper wire having a diameter of 1.63 mm is used to provide electrical…

A: We have, diameter of the cross-section of the wire, d=1.63mm=1.63*10-3m Length of the wire, l=75m…

Q: e a kitchen oven with cork board (k = 0.043 W/mK) so that the heat losses from the oven does not…

Q: Calculate the resistance of an aluminum cylinder that has a length of 10 cm and a cross-sectional…

A: Given:Length of aluminium cylinder,L=10cm=0.1mCross sectional area of cylinder,A=2×10-4…

Q: 5. A 1.2 m long conductor is made of a mixture (i.e. alloy) of different materials. The resistivity…

Q: A long cylindrical conductor of radius R = 4 cm carries a current of / = 10 A along its length; this…

Q: 1. A bar structure of section 2 cm x 2 cm is made of cast steel is shown in Figure 1, determine the…

A: According to the given information, the value of the area of the bar is 4 cm, no of turn N is 500,…

Q: Determine the resistance of 1200 m of copper cable having a diameter of 12 mm if the resistivity of…

A: Write the given values with suitable variables. L=1200 md=12 mmr=d2=12 mm2=6 mm=0.006 mρ=1.7×10-8…

Q: A bimetallic strip is used as a sensor. The strip has a length of 20 μm. The width of the strip is…

Q: The diameter of a cast iron manhole cover at 23°C is 500 mm. To what temperature should the cover be…

A: Given: d=500 mmT1=23°C∆d=1 mmα=13×106°C

Q: define transverse conductivity of a material. what internal and external forces effect affect…

A: Transverse conductivity: →Transverse conductivity of an elliptical fiber…

Q: Some types of bacteria containchains of ferromagnetic particles parallel to their long axis. The…

A: Certain types of bacteria are placed in a magnetic field of solenoid made of copper wire of certain…

Q: Determine the resistance of a copper wire that has a cross-sectional area as 8.3 mm2. The length and…

Q: Nonmetallic-Sheathed Cable (NM) shall be permitted to be derated from the 90 degrees C temperature…

A: Non metallic sheathed cable shall be permitted to be derived from the 90degrees C temperature rating…

Q: For a conductive wire with length L=1cm,w=1mm, h=1mmunder uniaxial strain, the resistance change is…

A: According to the information we have a Uniaxial strain that is e=1 and the Poisson’s ratio is n= 0.3…

Q: 2. The resistance of a copper wire used to make a motor is 0.5 Ω at 25oC and 0.8 Ω at the motor’s…

A: Given data, The relationship between resistance and temperature is given as – The operating…

Q: Calculate the efficiency of a solar module with the given parameters: • FF = 59% Voc = 5.5 V • Isc =…

A: Write the expression of the input power. Write the expression of the output power.

Q: R wwwww R wwww ww R

A: Consider the following figure: Let I be the current supplied. Beyond point A the three resistances…

Q: The two metallic strips that constitute some thermostats must differ in: A) length B)…

Q: A large motor neuron runs from the brain to the arm. The neuron contains a core of bundled…

A: Microtubules might be the minds of the cell, especially neurons-working like an electronic Lego set.…

Q: Explorer V had copper antennas that were each 25 cm long. If they changed in temperature from 0°C to…

A: Given: Length the antenna=25cm long Change in temperature (ΔT)= -35°C (-ve because temperature is…

Q: 3. Calculate the percentage increase in length of a wire of diameter 2.5 mm stretched by a force…

A: As per given question Wire diameter =2.5mm Weight =100 kg Y =12.5×1010N/m2 we have to determine…

Q: Demonstrate that the time constant RCa of a piezoelectric material is only dependent on the…

A: given; demonstrate that the time constant RCd of a piezoelectric material is only dependent on the…

Q: Devices using semiconductors to measure temperature are called O optical pyrometers thermistors O…

A: An optical pyrometer is a temperature measuring device that works on the principle of matching the…

Q: A wire of length L1=30cm has a fixed end and the other end is welded to another wire, whose linear…

A: Given: The length of wire 1, L1 = 30 cm The density of wire 2, r2 = r2/4 The mass suspended at far…

Q: If w, = 106 rad/s, Qf = 5 × 10² and m = 10-10kg, calculate the stiffness, and resistive constant (b)…

A: Solution (1) Given data: Frequency, ωo = 106 rad/s. A dimensionless quality number, Qf = 5×102.…

Concept explainers

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.

Question

A coil consists of 2000 turns of copper wire having a circular - section of diameter 2.5 mm. The mean length per turn is 80 cm and the electrical resistivity of copper is 0.02 μΩ–m. Determine the resistance of the coil.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The inner conductor of a coaxial cable has a diameter of 0.5 mm, an outer conductor an inner diameter of 6 mm and a length of 50 m. If the inner and outer conductors of the coaxial cable will be joined at one end of the cable, and if the permeability of the insulating material is µ = 4πx10^-7 H/m, what will be the inductance of the cable?
What is the resistance R of a length of copper wire whose length = 10 m and whose diameter = 0.10 mm?
Define the electrical power in terms of resistance R, current I, and potential difference V.
Determine the resistance of an aluminium coil of 1.3 cm as diameter consists of 13100 turns and the mean length per turn is 44 cm. Take the electrical resistivity aluminium coil as 0.017 μΩ–m. The area in cm2 = The total length in m = The resistance of the coil in Ω =
Example 1.6 Solid copper wire having a diameter of 1.63 mm is used to provide electrical distribution to outlets and light sockets . Determine the resistance of 75 meters of a solid copper wire having the above diameter . Resistivity of copper at 20 C is 8 1.723 * 10-8 22.m.
A rod of semiconducting material of lenght L=3 m and cross-sectional area A=4.5 mm^2 lies along the x-axis between x=0 and x=L. The material obeys ohm's law, and resistivity varies along the rod according to p=p0 (1-(x^2/L^2)) where p0= 4.10^-4 ohm.m. The end of the rod x=0 is at a potential V0=30V greater than the x=L. A) what is the total resistance, in units of ohm, of the rod? B) what is the current, in units of miliamperes, in the rod? C) what is the electric potential, in units of Volt, in the rod at x=L/2? D) what is the electic-field magnitude E, in units of V/m, in the rod at x=L/2?
Q1: A copper cable is 2 km long and has across-sectional area of 10 mm². Find its resistance at 80°C if at 20C the resistivity of copper is 0.02x10-6 2.m and its temperature coefficient of resistance is 0.004/•C.
The area and length of a wire are given as 0.82 square meter and 50 cm respectively. The resistivity of that wire is 4.25Ωm, calculate the resistance. a. 2.95 Ω b. 2.59 Ω c. 5.29 Ω d. 5.92 Ω
Determine the resistance of a copper wire that has a cross-sectional area as 9.9 mm2. The length and the electrical resistivity of the copper wire are 76 m and 1.64 x 10-6 Ωm.
A certain toaster has a heating element made of Nichrome resistance wire. When the toaster is first connected to a 120 V source of potential difference (and the wire is at a temperature of 20.0°C), the initial current is 1.90 A, but the current begins to decrease as the resistive element warms up. When the toaster reaches its final operating temperature, the current has dropped to 1.5 A. (d) Determine the operating temperature of the heating element.
(a) A wire carrying a 20.5 A current passes between the poles of a strong magnet that is perpendicular to its field and experiences a 2.46 N force on the 3.75 cm of wire in the field. What is the average field strength? Average field strength in tesla = (b) A spherical surface of area 0.7m2, emissivity 0.85 and temperature 134°C is placed in a large, evacuated chamber whose walls are maintained at a fixed temperature. Find the rate at which radiation is emitted by the surface?( Stefan's constant σ = 5.67 x 10-8 W/m2T4 ) Energy radiated per second in watts =
17- The Electrical resistivity (ρ) of a material is inversely proportional to the length (L) of the material Select one: True False